Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Engineering
Structural Stability Of A Joined-Wing Sensorcraft, Brandon J. Adams
Structural Stability Of A Joined-Wing Sensorcraft, Brandon J. Adams
Theses and Dissertations
This thesis employed a multi-disciplinary design approach to determine the structural stability of the Boeing Joined-Wing SensorCraft. Specifically, this thesis sought to characterize the free vibration modes, ensure a buckling safe design and determine the influence of the geometric and aeroelastic nonlinearities associated with this joined-wing design. The clamped free vibration modes were developed for a wind tunnel model and were compared to the free-free vibration modes, several differences were found. Linear static analyses were performed on numerous maneuver loads and gust conditions to determine the critical loading condition. The SensorCraft was then redesigned for the critical load case to …
Situational Awareness And Synthetic Vision For Unmanned Aerial Vehicle Flight Testing, Joseph M. Dugan
Situational Awareness And Synthetic Vision For Unmanned Aerial Vehicle Flight Testing, Joseph M. Dugan
Theses and Dissertations
The Advanced Navigation Technology (ANT) Center at the Air Force Institute of Technology (AFIT) is currently exploring ways to develop and advance the employment of autonomous Unmanned Aerial Vehicles (UAV) by the Department of Defense for military purposes. The research in this thesis describes the development of a tool that enhances situational awareness and provides synthetic vision in a program called the Aviator Visual Display Simulator (AVDS) during UAV flight. During flight testing, the Situational Awareness and Synthetic Vision Relay Tool (SASVRT) developed provides the test coordinator and pilot, as well as the safety observers, with the most pertinent information …
Aeroelastic Analysis Of A Joined-Wing Sensorcraft, Jennifer J. Sitz
Aeroelastic Analysis Of A Joined-Wing Sensorcraft, Jennifer J. Sitz
Theses and Dissertations
This study performed an aeroelastic analysis of a joined-wing SensorCraft. The analysis was completed using an aluminum structural model that was splined to an aerodynamic panel model. The force and pressure distributions were examined for the four aerodynamic panels: aft wing, fore wing, joint, and outboard tip. Both distributions provide the expected results (elliptical distribution), with the exception of the fore wing. The fore wing appears to be affected by interference with the joint. The use of control surfaces for lift and roll was analyzed. Control surfaces were effective throughout most of the flight profile, but may not be usable …
Sensor-Craft Analytical Certification, Ronald W. Roberts Jr.
Sensor-Craft Analytical Certification, Ronald W. Roberts Jr.
Theses and Dissertations
This study developed a multi-disciplinary conceptual design of a joined-wing sensor-craft. Initial analysis was conducted using an aluminum model. Linear fully stressed design and flexible aerodynamic trim were used to converge to a minimum weight design that was aerodynamically stable. This optimized design was buckling safe. A similar optimization process using non-linear fully stressed design and flexible aerodynamic trim was conducted. The non- linear structurally deformation was over ten times greater than the linear structural deformation. Again, the model was structurally and aerodynamically optimized. The linear optimization was repeated using a composite structural model incorporating Conformal Load-bearing Antenna Structures. This …