Construction Engineering Commons^™

House As Mediator: Integrative Typology As Connector Between Land And Sea, Samantha Kudish

Architecture Thesis Prep

Rather than the water being an obstacle to coastal residential communities, water can act as an opportunity. Instead of barricading these areas from the water, integrating it with the area would create communities that are capable of living in unison with the ocean. This can introduce new typologies of housing that can withstand the continuing rise of sea levels. Blurring the line between land and sea by living with the sea will allow coastal regions to stay afloat, benefiting from ever-changing water conditions. A proposed new housing typology would introduce a new program to coastal neighborhoods, rather than putting up …

Engineer Manual 385 Effectiveness: A Study Of Predictive Analytics, Scott Arias

All-Inclusive List of Electronic Theses and Dissertations

Under the guidance of the United States Army Corps of Engineering Manual 385 (EM 385), the federal government has taken a stringent stance on construction safety. Using the mandated Occupational Safety and Health regulations and the 29 Code of Federal Regulation as a safety foundation, the EM 385 requires project-specific planning, continuous oversight and direct control of all safety activities. These mandates, required of every Department of Defense entity, focus on safety management not found within other federal agencies, in an attempt to reduce the number and severity of mishaps. This study looks for causation between the use of the …

An Environmental Value Engineering (Eve) Emergy Analysis Rubric To Compare High-Speed Passenger Rail And Interstate Passenger Car Transportation Alternatives Through A Fixed Distance, Joseph Threadcraft

All-Inclusive List of Electronic Theses and Dissertations

An Environmental Value Engineering (EVE) analysis was used to conduct an environmental life cycle assessment of transportation alternatives consisting of high-speed passenger rail and interstate passenger car transportation. This analysis was formulated on the EMERGY inputs of environment, fuel energy, goods, and services (labor). EMERGY input tables were calculated based on subsystem inputs for each mode of transportation. Areas of commonality were identified for analysis exclusion while aspects that showed differentiation were included as viable inputs into the calculation of the total EMERGY for each system. The summation of inputs resulted in an overall EMERGY calculation of the alternatives. Subsequently, …

The Effects Of Limestone Particle Size On Bone Health And Performance Of Pullets And Hens In Conventional Cage And Alternative Housing Systems, Pamela E. Eusebio Balcazar

Department of Animal Science: Dissertations, Theses, and Student Research

One of the major welfare issues in cage-free housing systems is bone fracture. The goal of this research was to improve bone health in layers by building better pullet skeletons and to investigate limestone particle size (LPS) effects on bone health in conventional cages and cage-free housing systems. Study 1 was a preliminary study that compared conventional cages with litter floor pens in terms of performance, bone health, and eggshell quality from 33 to 47 wk of age. Caged hens had higher egg production and eggshell strength, and improved feed efficiency, but lower tibia bone mineral content compared to floor …

Bs News November/December

Building Services Engineering

No abstract provided.

Ua66 Ogden College Of Science & Engineering Newsletter, Cheryl Stevens, Dean

Ogden College of Science & Engineering Publications

No abstract provided.

Bs News September/October

Building Services Engineering

No abstract provided.

Assessment Of Future Employment And Competency Skills In Building Information Modeling: A Delphi Study, Joseph A. Raiola Iii

All-Inclusive List of Electronic Theses and Dissertations

Many mainstream architecture, engineering, and construction (AEC) professionals are using Building Information Modeling (BIM). Although more and more firms are using BIM and this trend is forecast to continue, it is unclear what skills and competencies a construction manager will need in five years related to BIM. This research aims to answer that question through the use of a Delphi panel comprised of AEC professionals. The panel consists of members with the following qualifications: a minimum of eight years industry or academic experience or a combination of the two, a minimum of three years BIM experience, and membership in a …

Building Envelope For Energy-Efficient Residential Homes, A Case Study For The U.S. Department Of Energy Challenge Home Student Design Competition, Milica Tajsic

UNLV Theses, Dissertations, Professional Papers, and Capstones

With the continuous rise of population and expansion of urban areas, the need for additional housing and infrastructure is growing rapidly. Building sector is consuming a vast majority of the natural resources to meet the needs of urbanization and is in need of efficient, sustainable solutions that are viable for the customer, the economy and the environment. The building sector is both the problem and the solution to the issues of the carbon footprint of our society (Architecture 2030, 2011).

The envelope (roofs, walls, and foundations) and windows typically account for 36% of overall energy use, or about 14.3 quads …

Coastal Defenses, U.S., Bert Chapman

Libraries Faculty and Staff Scholarship and Research

Provides an overview of U.S. military coastal defenses during the period up to and including the War 1812.

An Emerging Vocabulary: Architecture Of Performance, Jeremy H. Stock

Kaleidoscope

Re-chartered at the University of Kentucky in 2005, the Triangle Fraternity – a brotherhood of students studying Architecture, Engineering, and Sciences – now seeks to establish a visible presence by building a new fraternity house on-campus. To enable this investigation, professors Gregory Luhan, Peyman Jahed, and Bruce Walcott developed a design + energy studio experience that provided a framework for an integrated design team to use a systems-thinking approach to generate a range of scalable, net-zero energy prototypes. These prototypes can be applied in a variety of contexts and have the potential to address larger issues, such as energy efficiency …

Bs News July/August

Building Services Engineering

No abstract provided.

Cooperative Construction In Schools In California, John Mauck Donley

Master's Theses

Cooperative Construction in Schools in California

John M. Donley

The construction industry has lost efficiency since 1964, while becoming increasingly more litigious. Schools in California can ill afford the time to allow the construction industry time to fully evolve. It may take years or decades to fully improve the efficiency of, and reduce the conflict within the construction industry.

At the same time, the construction industry has developed new processes to improve efficiency and reduce conflict. These processes are beginning to be broadly embraced by the industry. They all contain cooperative elements. Taken together they represent a new organizing principle …

Multi-Criteria Decision Modeling For Best Value Selections In Target Value Design Integrated Project Delivery, Brent Patrick Griffis

Master's Theses

Integrated Project Delivery (IPD) combined with Target Value Design (TVD) is a better way to deliver value for the client than traditional guaranteed maximum price (GMP) methods. With traditional GMP delivery methods, the interests of the parties are often at odds. The goal of IPD is to align all party interests in order to achieve a win-win scenario. Due to the aligning nature of IPD and the fact that each party’s success is dependent on achieving the project objectives as a whole; a non-biased, transparent, decision-making process is necessary in order to deliver the project objectives within the constraints of …

Ua66 Ogden College Of Science & Engineering Newsletter, Cheryl Stevens, Dean

Ogden College of Science & Engineering Publications

No abstract provided.

Information Technology Project Management Of The New College Of Education Facility At Western Kentucky University, Christopher Lee Roberts

Masters Theses & Specialist Projects

Information Technology (IT) Project Management methodologies are numerous, often varying from organization to organization, and sometimes from project to project within the same organization. Although project type and scope can be a powerful indicator of what methodologies may work best for a given project, choosing which methodology to use can be daunting for project teams. At times, even after due diligence has been practiced to identify the management options available for a given project, there may not be a perfect fit. At such times, or when a formal methodology does not exist in an organization or project management office, the …

Bs News May/June

Building Services Engineering

No abstract provided.

Bs News March/April

Building Services Engineering

No abstract provided.

An Introduction To Taking Off Building Quantities:An Irish Approach, Tony Cunningham

Other Resources

The purpose of measuring building work is to establish the correct amount of work to be executed. Calculating well presented accurate quantities in a clear manner while adopting a logical approach will help to reduce errors and will save time if the measurements need to be referred to at a later date. This paper describes and demonstrates an approach to hand-written taking off procedure informed by the techniques adopted by Irish consulting quantity surveying practices. The paper also discusses the ‘direct billing’ system used inIrelandand contrasts this with the procedures demonstrated in various UK textbooks, identifying key differences between the …

A Survey For The Construction Management Department At Brigham Young University, Daniel J. Foutz, Dr. Kevin Miller

Journal of Undergraduate Research

Kevin Miller and I conducted a survey for the benefit of the Construction Management Department at Brigham Young University. The survey also benefitted two professional associations of the construction industry, namely, the Associated General Contractors of America (AGC), and the Association of Building Contractors (ABC). The purposes of the survey were to: evaluate current use of software in the industry; gain information for seminars held by the AGC and ABC; determine the level of interest in a proposed graduate program for the Construction Management Department; and expand job opportunities for BYU’s construction management graduates and interns. In conducting the survey …

Impact Of Sustainable Cool Roof Technology On Building Energy Consumption, Prem Kiran Vuppuluri

Dissertations and Theses

Highly reflective roofing systems have been analyzed over several decades to evaluate their ability to meet sustainability goals, including reducing building energy consumption and mitigating the urban heat island. Studies have isolated and evaluated the effects of climate, surface reflectivity, and roof insulation on energy savings, thermal load mitigation and also ameliorating the urban heat island. Other sustainable roofing systems, like green-roofs and solar panels have been similarly evaluated. The motivation for the present study is twofold: the first goal is to present a method for simultaneous evaluation and inter-comparison of multiple roofing systems, and the second goal is to …

Method And System For Optimal Coordination Control And Soft Repair Of Multiple Rooftop Heating And Cooling Units, Haorong Li

Durham School of Architectural Engineering and Construction: Faculty Publications

Techniques are described that may be implemented in an adaptive control device to regulate multiple zone environmental units based upon multiple temperature values and multiple airflow values, where each temperature value and each airflow value is related to the temperature and the airflow in a specific zone. In an implementation, the input interface of the adaptive control device is configured to receive multiple temperature values and multiple air flow values from multiple zone sensors. The adaptive control device may calculate multiple operational values based on the multiple temperature values and the multiple air flow values. An operational value indicates a …

Ua35/3 Memoranda, Wku Provost

WKU Administration Documents

Memoranda issued by the WKU Provost to WKU faculty and staff via email.

• Dean, College of Human & Health Services
• Summer Projects, 2014
• Directorship of the Kentucky Museum

Improving Enrollment In The Construction Management Graduate Program Through Students’ Perspectives, Mouloud Messaoudi

Master of Technology Management Plan II Graduate Projects

Low enrollment and the decrease in graduation and retention rates are challenges facing the growth of the Master’s in Technology Management – Construction Management (MTM-CM) program at BGSU. In addition, the competition between the universities to enroll and retain more in-state, out-of-state, and international students is aggressive. There is a need for a revaluation for the MTM-CM program in order to attract more students in the future. This study is a necessary step to know what the MTM-CM students think about the product delivered to them at BGSU. There was no prior study investigating the satisfaction level of the construction …

The Influence Of National Culture On Effectiveness Of Safety Trainings During Postdisaster Reconstruction, Behzad Esmaeili, Kevin Grosskopf, Amy Javernick-Will

Durham School of Architectural Engineering and Construction: Faculty Publications

Non-English speaking workers constitute a disproportionately high number of workers involved in postdisaster reconstruction. Additionally, the rate of fatality among these workers is higher than the industry average. Research shows this population is more prone to unsafe behaviors in the working environment, conceivably because many of these workers are sent into the field prior to any formalized training. Recent studies show that the native culture of construction workers can impact risk-taking behavior. While numerous researchers have attempted to develop training materials for Hispanic workers, the number of studies that consider the impact of native culture on safety behavior is minimal. …

Virtual Surface Temperature Sensor For Multi-Zone Commercial Buildings, Yuebin Yu, Denchai Woradechjumroen, Daihong Yu

Durham School of Architectural Engineering and Construction: Faculty Publications

Multi-zone structure is commonly used in small commercial office buildings, retail stores and supermarket. While there is no adjacent wall between the zones, the impact of a neighbor zone on the current zone can be approximated and analyzed through the application of virtual walls. It is critical to accurately estimate the virtual wall surface temperature in order to evaluate the model uncertainty and apply improved supervisory control on multiple rooftop air-conditioning units (RTUs). We propose an innovative virtual surface temperature sensor based on system-identification to solve this challenge. The validation of the virtual temperature model is processed by the three …

Shallow Flat Soffit Precast Concrete Floor System, George Morcous, Maher Tadros

Durham School of Architectural Engineering and Construction: Faculty Publications

A precast concrete floor system that eliminates the need for column corbels and beam ledges while being very shallow. The main advantages of the present system include a span to-depth ratio of 30, a flat soffit, economy, consistency with prevailing erection techniques, and fire and corrosion protection. The present system consists of continuous precast columns, prestressed rectangular beams, hollow-core planks, and cast-in-place composite topping. Testing results have indicated that a 12 inch deep flat soffit precast floor system has adequate capacity to carry gravity loads (including 100 psf live load) in a 30 ft x 30 ft bay size. Testing …

Behavior Of I-Section Gfrp Beam Including Retrofitting For Damage Effects, Mamadou Konate, Zia Razzaq

Civil & Environmental Engineering Faculty Publications

This paper presents the outcome of a study of an I-section Glass Fiber Reinforced Polymer (GFRP) beam including retrofitting for damage effects. A total of three beam tests were conducted in the following sequence: GFRP beam with no retrofitting and a single mid-span web brace; the partially damaged (cracked) beam with GFRP plates used for retrofitting; and the retrofitted beam re-tested with the lateral brace at the top flange level. Both cracking and lateral-torsional buckling behavior is studied and experimental load-deflection relationships recorded. Using the mechanical properties of GFRP based on the experimental data, theoretical predictions are made for the …

Hybrid Of Natural Element Method (Nem) With Genetic Algorithm (Ga) To Find Critical Slip Surface, Shahriar Shahrokhabadi, Vahid Khoshfahm, Hamed Nabizadeh Rafsanjani

Durham School of Architectural Engineering and Construction: Faculty Publications

One of the most important issues in geotechnical engineering is the slope stability analysis for determination of the factor of safety and the probable slip surface. Finite Element Method (FEM) is well suited for numerical study of advanced geotechnical problems. However, mesh requirements of FEM creates some difficulties for solution processing in certain problems. Recently, motivated by these limitations, several new Meshfree methods such as Natural Element Method (NEM) have been used to analyze engineering problems. This paper presents advantages of using NEM in 2D slope stability analysis and Genetic Algorithm (GA) optimization to determine the probable slip surface and …

Bs News January/February

Building Services Engineering

No abstract provided.