Architectural Engineering Commons^™

Polypropylene As Partial Fine Aggregate Substitute In Concrete, Samuel E. Royston, Chrisitan G. Achkar, Nicholas B. Tabarez

Architectural Engineering

The objective of this project is to discover a structurally effective method in repurposing recyclable plastic waste through its partial substitution for traditional fine aggregate in concrete.

Results obtained from analysis indicate a 25 percent compressive strength reduction with polypropylene at a 10 percent partial substitution for total sand content. This material successfully performed as an alternative, presenting a ductile mode of failure.

Three material alternatives - polypropylene, polyethylene, and rubber - were substituted for a percentage of sand. These materials underwent concrete cylinder crushing tests to determine their ultimate crushing strength, with the intent of identifying the most effective …

Precious Plastics - Plastic Brick Machine Fabrication, Timothy Ukaobasi Kanu, Evi Paraskevi Troulis

Architectural Engineering

The goal of this research is to determine the structural parameters of the recycled plastic polypropylene when molded into bricks resembling CMU blocks. To accomplish this, three mechanisms had to be assembled: the shredder, the injector, and the 1x1 mold. A tensile and compression test were to be performed on the plastic brick, and the values would be used to compare the tensile and compressive strength of PP plastic bricks, as well as their modulus of elasticity and stress vs. Strain performance. These values would be analyzed to determine whether it would be feasible to build an entire plastic wall. …

Analysis Of Burning Wood In The Transient State And The Application To Structural Design, Roberta Veliz, Kimberly Guzman

Architectural Engineering

Determining the extent of the contribution of exposed timber on compartment fire dynamics in open floor plans is a complex process. Designers traditionally used compartmentalization design methods which create spaces where flashover is likely, given the fuel load and ventilation conditions. However, due to the large geometric dimensions and spread of fuel, fires in open floor plans are more likely to remain as localized or traveling fires. As such, an understanding of not only ignition potential but also flame spread is critical to characterizing the contribution of exposed timber. An integral step in characterizing the potential contribution is through an …