Digital Commons Network^™

Methane Dry Reforming Reaction On Cr, V, In, And Ga Supported Sapo-34 Zeolite, Ehigiator Festus Ojo

Masters Theses

”The CO₂ reforming of methane is a significant research area in mitigating and transforming two greenhouse gases for the production of syngas. The reaction has been investigated for four different promoted catalysts to determine their reactant's conversion, product’s selectivity, and their respective syngas ratios.

The catalytic test was investigated under atmospheric conditions at 600⁰C for 6.5h with a WHSV of 4800 ml g^-1 h^-1. The conversion and selectivity of catalysts 9Al 1V-inc SAPO-34, 9Al 1Cr-inc SAPO-34, 9Al 1Ga-inc SAPO-34, and 9Al 1In-inc SAPO-34 were analyzed. The CH₄ conversion for the different catalysts are, 9Al 1Cr-inc …

Unmanned Aerial And Traversing Vehicle -- A Mobile Platform For Bridge Inspections, Clayton A. Fritsche

Masters Theses

“Unmanned aerial vehicles (UAVs), also known as drones, have been rapidly growing in popularity since their creation. This study aimed to create a robotic platform used to assist in the inspection process of the nation’s aging and deteriorating bridges. To this end, a multimodal inspection robot that utilized both flying and driving technologies, was designed, analyzed, and tested for aerial, traversing, and their transitional operability. The design, herein referred to as the “BridgeBot”, was evaluated both computationally and experimentally. A finite element model of the BridgeBot was established and analyzed under static loading scenarios to help determine stress distributions and …

Performance Of One-Part And Two-Part Class C Fly Ash-Based Alkali Activated Mortars, Cedric Chani Kashosi

Masters Theses

“Seeking an eco-friendly concrete, researchers have conducted studies to fully replace ordinary Portland cement (OPC) with fly ash (FA) producing alkali-activated concrete (AAC). Results showed better performance of AAC in terms of high early compressive strength, and durability compared to conventional concrete. However, much is still unknown about the behavior of AAC. From the type of materials used, the curing procedure, and long-term strength development of these binders; a thorough investigation is needed in order to fill the existing gap from previous studies and thus make a step forward to the safely use of AAC in the construction industry. The …

Estimating Electromagnetic Emissions From A Site Installation With Multiple Racks Of Server Equipment, Ze Sun

Masters Theses

“There are hundreds, sometimes even thousands, of servers working simultaneously inside a data center. Their radiation can be a problem and cause EMI issues. However, it is not feasible to perform full-wave simulation of these racks because of the large electric size of the model. In this thesis, an algorithm is proposed to predict the emission form rack array. The equivalent dipole source is extracted from EMI measurement data of a single rack and used as the radiation source in the multiple rack model. The coupling between racks cannot be ignored, but through the simulation, it is also found that …

Feasibility Study For Sustainable Controlled Low-Strength Material (Clsm) Incorporating Off-Specification Fly Ash And Bottom Ash, Alexis K. Vandomelen

Masters Theses

“Controlled low-strength material (CLSM) is a self-consolidating cementitious material used in applications requiring high flowability and low strength. The primary components of this material, being cement and sand, however, negatively impact the environment. Cement is a large contributor to CO2 emissions, and the vast depletion of sand causes physical and political issues. Furthermore, over 100 million short tons of coal combustion products (CCP), including fly ash and bottom ash, are created annually in the United States, while nearly half of all CCP remain unused. No off-specification fly ash has been implemented in CLSM. This study uses coal ashes sourced from …

Influence Of Pumping Parameters On The Freeze-Thaw And Scaling Resistance Of Highly Workable Concrete, Alexandra Nicole Wehar

Masters Theses

“Over the past 60 years, pumping concrete has gained popularity due to the economic and technical benefits that typically accompanies it. However, boom configuration and flow rate can adversely affect freeze-thaw and scaling resistance of concrete due to the effects of pressure on the air-void system. Therefore, the objective of this research is to assess the influence of different pumping parameters on the durability of hardened self-consolidating concrete. Self-consolidating, flowable, and conventional concrete mixtures were tested during large scale pumping experiments positioning the pump boom in an “A” and a flat shape as well as using different pumping speeds. In …

Laser Machining Countersinks In Carbon Fiber Reinforced Polymer, Leon James Neely Hill

Masters Theses

“Laser machining countersinks with a frequency doubled Q-switched diode pumped Nd:YAG laser is demonstrated. Tests were conducted in 0.100" thick IM7 prepreg CFRP with [0,90]3S orientation. The HAZ is minimized to avoid stress concentrations in the epoxy matrix. A chamber and filtration system was designed and built to contain the byproducts produced in the machining process. The variables investigated are the number of repetitions in the offset path, the plunge rate, and the line energy. The research was performed over one baseline study, one parameter space exercise, two full factorial experiments, and one repeatability study. Assessment was done under an …

Controlled Switching In Kalman Filtering And Iterative Learning Controls, He Li

Masters Theses

“Switching is not an uncommon phenomenon in practical systems and processes, for examples, power switches opening and closing, transmissions lifting from low gear to high gear, and air planes crossing different layers in air. Switching can be a disaster to a system since frequent switching between two asymptotically stable subsystems may result in unstable dynamics. On the contrary, switching can be a benefit to a system since controlled switching is sometimes imposed by the designers to achieve desired performance. This encourages the study of system dynamics and performance when undesired switching occurs or controlled switching is imposed. In this research, …

Inclusion Engineering In Femnal Steels, Rairu Vaz Penna

Masters Theses

"Low density high Mn and Al steels, or FeMnAl steels, show great promise for military vehicles and automotive applications in which high strength and toughness is a requirement. However, these steels are subject to processing challenges including development of oxide and nitride inclusions during melting and casting as well as a large as-cast grain size and heavy interdendritic segregation. This can lead to non-uniform heat treatment response and cracking during subsequent hot rolling. Adding up to 10%Al lowers the density of these steels by as much as 15%, unfortunately, this also results in large amounts of hard and faceted AlN …

Exploration For Alteration Halos Around The Ag-W Deposits In Southeastern Missouri, Usa, Daniel Joseph Warbritton

Masters Theses

"The St. Francois Mountains in SE Missouri are an extensive terrane of granitic ring complexes and associated rhyolites. They were an important source of Ag, W, and Sn and mined intermittently from the 1800s until the 1950s. The Ag-W ores occur in the Silvermine Granite and rhyolite roof rocks. The deposits are classified as a xenothermal ore system with mineralization occurring in quartz veins and surrounding greisen (up to 2.5 m). Exploration for hydrothermal ore deposits often focuses on the identification of alteration halos in the surrounding host rocks. In the vast majority of xenothermal ore deposits, such as in …

The Impact Of Artificial Intelligence On Higher Education, Yizhi Ma

Masters Theses

"A perfect storm is hitting higher education. Decreased funding from traditional funding sources, such as State Governments, and transformative changes caused by artificial intelligence (AI) will revolutionize higher education. Higher education needs to change and evolve quickly and continuously to prepare students for the upheavals in the job market caused by AI, machine learning, and automation.

As AI continues to make inroads into our world and our lives, its impact and effects can no longer be ignored. What kinds of organizational changes in higher education are necessary? How can higher education continue to prepare students for the AI evolution and …

Discrimination By Design?, June Carbone, Naomi Cahn, Nancy Levit

Articles

No abstract provided.

The Chevronization Of Auer, Kristin Hickman, Mark R. Thomson

Articles

No abstract provided.

The Duty Of Data Security, William Mcgeveran

Articles

No abstract provided.

Blackstonian Marriage, Gender, And Cohabitation, June Carbone

Articles

No abstract provided.

Demystifying Patent Holdup, Tom Cotter

Articles

No abstract provided.

On Public Employees And Judicial Buck-Passing: The Respective Roles Of Statutory And Constitutional Protections For Government Whistleblowers, Heidi Kitrosser

Articles

No abstract provided.

The Failure Of Youth Sports Concussion Laws And The Limits Of Legislating Health Education, Francis Shen

Articles

No abstract provided.

What Exactly Is The Rule Of Law?, Robert Stein

Articles

No abstract provided.

Wicked Crypto, Alan Rozenshtein

Articles

No abstract provided.

Women, Rule-Breaking, And The Triple Bind, June Carbone

Articles

No abstract provided.

Polarized Justice? Changing Patterns Of Decision-Making In The Federal Courts, Herbert M. Kritzer

Articles

No abstract provided.