Digital Commons Network^™

An Investigation Of Continuous Steel Beams In The Plastic Range, Robert Adams Shoolbred

Masters Theses

"The purpose of this thesis is to investigate the action of beams in the plastic range. The test specimen will be a 4WF 13 structural shape continuous over three supports having equal span lengths of seven feet. Three types of loading were chosen. The first loading will be concentrated in the center of each span. The second loading will be a concentrated load in the center of one span only. The third loading will be the settlement of the two end supports until a plastic hinge forms at the center support, then the two spans will be loaded with concentrated …

Horizontal Pressures On Retaining Walls Due To Line Surface Loads, John B. Heagler

Masters Theses

"Among the oldest types of structures with which engineers have had to deal are those which serve to laterally restrain masses of earth, or to prevent earth embankments from assuming their natural angle of repose. This is necessary where space is limited or the natural slope would encroach upon other property. These structures, usually called retaining walls, are subjected to forces, both lateral and vertical due to the pressures exerted by the backfill material and any loads imposed on the backfill material. The first step in the design of the retaining wall is to determine the magnitude, position, and line …

Testing Of Missouri Shales For Light Weight Aggregate Production, Jerry D. Plunkett

Masters Theses

"The original objective of this investigation was to determine by testing those clays, shales, and loesses occuring in Missouri in large deposits (over 15 feet in thickness with little overburden), which would be suitable for the production of light weight aggregate. The second objective was to investigate the mechanism of bloating as related to the physical and chemical properties of the above materials, and by using these relationships cause clays which do not naturally bloat, to bloat using some addition. The use of additives would permit the economical use of material closer to the market in many instances.

After the …

Deposition Of Metallic Coatings From Fused Salt Baths, Andrew Hessler Larson

Masters Theses

"This thesis is the result of an investigation undertaken to study some of the important factors affecting the deposition of metallic diffusion coatings on other metals immersed in a fused salt bath….

There are many methods which have been devised to obtain diffusion coatings on various metals. One which is quite well known and used commercially is the process of “chromizing” which produces a diffusion layer if chromium on another metal. One method of “chromizing” consists of immersing the specimen to be coated in a mixed chloride fused bath containing chromium metal flakes. Another method consists of packing a low …

Effect Of Carbon Content In Steels Upon The Deposition Of Titanium From A Fused Salt Bath, Reinhard Paul Abendroth

Masters Theses

"STATEMENT OF PROBLEM Previous work done at the Missouri School of Mines and Metallurgy on the deposition of titanium upon various metals, especially iron and steel, bas shown that titanium can be deposited upon ingot iron and. low carbon steels with comparitive ease. Difficulty was encountered in attempts to deposit titanium upon steels of higher carbon content and upon cast irons.

For this reason, it was decided to investigate more thoroughly the relationship between the carbon content of various steels and the quality of titanium coatings deposited on these steels. Once this relationship had been established, a suitable theoretical explanation …

Corrosion Products Of Titanium In Fused Salt Baths, Kai-Chai Chiou

Masters Theses

"Titanium is gaining great interest in the modern metal industry because of its natural abundance and its desirable physical and chemical properties. Among them, its excellent corrosion resistance, such as the resistance to normal atmosphere attack, humid and saline atmosphere attack, sea water attack, and nitric acid attack, is the most prominent characteristic being welcomed by the engineers. The usefulness of titanium would be greatly increased if it were possible to plate titanium on other metals, thus increasing the corrosion resistance of these other metals.

Much concern, at present, has been given to the possibilities of the electrodeposition of titanium …

Coloration Of Glass By High Energy Radiation, Thomas L. Nickens

Masters Theses

"Purpose of Investigation: One of the objects of this investigation is to determine the amount of CeO₂ required to prevent the discoloration of glass when exposed to gamma radiation. By discoloration, it is meant that there has been a change in the absorption bands of visible light. Another objective is an attempt to prevent the coloration by the introduction of two oxides not previously used. Finally, a theory is presented which could explain why glass containing CeO₂ does not change color upon irradiation by gamma rays"--Introduction, page 1.

A Survey Of The High School Business Departments Of Iroquois County, Danville, Hoopeston, And Kankakee, Paul R. Byers

Masters Theses

No abstract provided.

The Changing Voice, George Smith Briggs

Masters Theses

No abstract provided.

The Education Of Abraham Lincoln, Hazel Roberts

Masters Theses

No abstract provided.

The Scope Of An Industrial Arts Program For Community Unit School District #4 Of Paris, Illinois, Raymond V. Griffin

Masters Theses

No abstract provided by author.

Development Of A Follow-Up Study, Jack E. Miller

Masters Theses

No abstract provided.

The Case Study, Robert Winkleblack

Masters Theses

No abstract provided.

Some Effects Of Public School Music On The Development Of Adult Musical Interests And Activities, Charles E. Moore

Masters Theses

No abstract provided.

The Use Of A Steady State Flow Reactor In The Study Of Rapid Gas Phase Reactions, Ormond Kennedy Lay

Masters Theses

"The demonstration of the feasibility of rocket propelled devices for various purposes within the past few years has initiated an intensive search for suitable reactants for use as rocket fuels. Consequently, the investigation of the properties of chemical reactions which rapidly liberate large quantities of energy has assumed major importance. In order that such reactions may be adapted to practical use as rocket propellants knowledge of the characteristics of these reactions is required. Properties such as+ the mechanism of the reaction, the speed of the reaction under varied conditions of temperature, pressure and concentrations, the conditions required for the initiation …

Investigation Of Soil Bricks As A Building Material, Ahmet Ilter

Masters Theses

"The need of a cheap construction material for small village farm construction in Turkey makes soil-cement a most desirable material. What is more, as far as the author knows, soil-cement has not found any application in farm house construction in Turkey as yet. So the author, being acquainted with his native country's house construction problem, and seeing the suitable application soil-cement have on such construction, came to the decision that he should investigate this problem thoroughly.

The main objective of the tests run in this investigation will be to find the strength of different samples of soil-cement. The stabilizer used …

The Design And Construction Of An Electronic D-C Analog Computer, Frederick R. Wagner, William A. Paar

Masters Theses

"To make this project realizable with the funds available and in the time allowed, and to set forth some definite goals, the following objectives were adopted:

1. Design, construct, and place in working order a d-c electronic analog computer capable of solving 4th order linear differential equations with constant coefficients.
2. Include in the design provisions for real time computation, and also fast, repetitive operation.
3. Provide for later expansion of the computer installation.
4. Limit expenditures to $700"--Introduction, page 4.

Heat Flow In A Two-Dimensional Steady-Flow System Without Radial Symmetry, George H. Parharoglu

Masters Theses

"As the extent of the science of heat conduction depends on the multiplicity of the boundary conditions that can be applied to the basic differential equation, a particular case in which the use of one set boundary conditions for the development of the general equation for the temperature distribution as well as the the amount of heat flow in a steady-state, two-dimensional heat flow system with a source of heat plased at the center of or along the axis of a cylinder, and without radial symmetry has been the object of this problem. Radial symmetry means the variation of temperature …

Foraminifera Of The Type Section Of The Archusa Marl Of Mississippi (Eocene, Claiborne Group, Wautubbee Formation), Nathan Eugene Crockett

Masters Theses

"The type locality of the Archusa marl member of the Wautubbee formation is situated south of Quitman, Clarke County, Mississippi. Stratigraphically, the unit falls within the middle Eocene Claiborne group, being roughly equivalent to the upper part of the Lisbon formation of Alabama and the lower part of the Cook Mountain. The marl falls within the Ostrea sellaefonnis zone and the zone of "Ceratobulimina eximia.” The type section consists of 48 feet of sandy marls, with a thin oyster bed near the middle.

The Archusa foraminifera fauna consists of 87 species and varieties, belonging to 49 genera and …

The Mineralogy Of The Grassy Creek And Saverton Formations, Dirk Pieter Van Duym

Masters Theses

"A study of the mineralogy of the Grassy Creek and Saverton formations of Northeast Missouri was undertaken to determine whether a division is justified, as proposed by some stratigraphers, of these argillaceous beds into two formations. The formations were sampled systematically at surface exposures on the northeast limb of the Lincoln Arch in the vicinity of Hannibal and Louisiana, Missouri. The samples were investigated mineralogically in the laboratory. Previous studies showed that the fossils of the Grassy Creek and Saverton beds were virtually identical. The present study demonstrates that the Grassy Creek and Saverton beds are too near alike in …

Determination Of The Thermal Conductivity Of Sodium Chloride At Elevated Temperatures, Harold Robert Weisbrod

Masters Theses

"The purpose of this research is to investigate possible methods of determining the thermal conductivity of small poorly conducting samples at elevated temperatures, and, further, to assemble a suitable apparatus, followed by measurement of thermal conductivity of one or more cubic lattice samples.

Basic requirements of the apparatus are few. It is first required that the measurement of thermal conductivity be made over a considerable range temperature. It is also preferred that the basic apparatus be placed in a vacuum where undesirable heat flow by convection is eliminated and air corrodible samples are preserved.

The apparatus must use only the …

Tunnel Rehabilitation, Jay C. Dotson

Masters Theses

"This paper is an outgrowth of research conducted at Missouri School of Mines and Metallurgy over a two year period. The purpose of the study is to assemble into one volume information that is pertinent to the rehabilitation of tunnels. Notwithstanding the voluminous size of the paper, much descriptive material necessarily has been omitted because of the far-reaching scope of tunneling practices and of the specialized fields therein. An extensive bibliography has been prepared to supplement the material that has been selected for presentation. Through consultation with tunnel men of all ranks, observations in the field, and an intensive search …

Geology Of The South Half Of The Meramec Spring Quadrangle, Missouri, Howard Joseph Yorston

Masters Theses

"This report is a continuation of the work initiated by Mueller in his mapping of the north half of the Meramec Spring Quadrangle. The completion of this work provides not only a geologic map of the whole quadrangle but also completes the mapping of the geology of a strip of quadrangles extending from Rolla to the Mississippi River. In addition to being a step closer to the goal of complete geologic coverage for the state, this work will be of value to those concerned with the prediction of depths of wells drilled in search for water, which in view of …

A Sociometric Study Of Popularity And Academic Achievement In A Ninth Grade Class, Elizabeth V. Banks

Masters Theses

The Problem and Its Background

Introduction

It is common knowledge that education consists of more than training for academic achievement. It consists of teaching whole individuals how to live effectively in their social environments. Although it is almost impossible to teach them all the skills directly they can be helped to learn through experience a great number of them for themselves. These view-points with respect to the teaching of students are held not only by a great number of educational authorities but are also part of the educational practice of a great number of teachers. Jenkins, Shacter and Bauer^{1 …}

Effects Of The History And Culture Of The Amish Upon The Educational Program In The Arthur Community Unit School, Harrison Wesley Brown

Masters Theses

No abstract provided.

A Junior High School Teacher Tackles Her Reading Problems, Irma W. Young

Masters Theses

No abstract provided.

The Bloating Of Missouri's Shales, Peter Kurtz Jr.

Masters Theses

"The first objective of this investigation was to determine which deposits of clays, shales, and loesses in Missouri are suitable for use in the production of lightweight aggregate by virtue of their expanding characteristics upon heating. The second objective was to determine, if possible, commercially feasible additions that will produce the bloating property in shales that do not naturally bloat.

There are two conditions which must be met in firing in order to bloat a clay or shale. First, a gas must be formed and evolved during firing. Second, enough glass of the proper viscosity must be formed to trap …

Photoelastic Investigation Of The Stresses In A Capless Connecting Rod, Gerald Delaine Smith

Masters Theses

"For a great many years the primary method used to solve engineering problems was by the use of mathematics. However, rigorous and simple mathematical solutions are only possible if the geometry of the member and its loadings are relatively simple. When irregular shapes with complex loadings are encountered, rigorous mathematical solutions for stresses induced are either impossible or very cumbersome. In such cases, the engineer must resort to other methods which are available today.

This paper attempts to show the application of the photoelastic method to such a problem. Moreover, it will show the comparative ease with which the designer …

Runoff And Soil Moisture, John William Clark Jr.

Masters Theses

"Hydrology is the science treating of water from the time it hits the earth until it leaves the earth. This never ending movement of water is called the "hydrologic cycle" and is best summarized graphically. The hydrologist is primarily concerned with rainfall, runoff and evaporation. One of the basic aims of the science is to compute the surface runoff from any rain on a given area. Surface runoff is here considered as that water which reaches the channels without penetrating the ground, plus subsurface storm flow. Subsurface storm flow is slower than surface runoff but faster than ground water flow. …

The Effect Of Air-Entrainment On Concrete Containing Chert Gravel, Ali Erdogan Dinc

Masters Theses

"The problem which the writer is analyzing in this paper has been suggested to him by Prof. Carlton of the Civil Engineering Department. It consists of two parts.

1. 1. Bar-Run aggregate is to be obtained from Springcreek near Rolla. This material is to be screened and recombined to obtain the best gradation for highest strength concrete obtainable.
2. Durability studies are to be made on the concrete resulting from best established mix by varying the amount of air entrainment compound (Vinsol Resin) to be added to the cement"--Introduction, page 1.