Digital Commons Network^™

The Missouri Miner, January 26, 1972

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, January 19, 1972

The Missouri Miner Newspaper

No abstract provided.

Cold-Formed Steel Structural Elements Subjected To Time-Dependent Loading, Charles G. Culver

CCFSS Library (1939 - present)

This report summarizes the results obtained from a comprehensive study of the behavior of thin-walled, cold-formed members subjected to impact or shock loading. The influence of local buckling and the concept of effective width in the elastic post-buckling range on the dynamic response of these members is described. Analytical and experimental results for thin compression elements, beams and columns are discussed. Comparisons between the analytical and experimental results are presented. Application of the results obtained from this research to practical situations involving impact or shock loading of cold-formed members is also discussed.

Column Research Council Proceedings, Fritz Engineering Foundation

CCFSS Library (1939 - present)

These Proceedings are a record of the Annual Meeting containing the abstracts of the reports presented and the transcription of our panel discussion.

Study Of Cold-Formed Steel Structural Members Made Of Thick Sheets And Plates, William M. Mckinney, Victor A. S. Liu

CCFSS Library (1939 - present)

INTRODUCTION In steel design, the Specification for the Design of Cold-Formed Steel Structural Members l issued by the American Iron and Steel Institute has long been used for structural members cold-formed to shape from steel sheet or strip used for load-carrying purposes in buildings and other thin walled steel structures. Even though no thickness limitation was included in previous editions of the Specification, 2,3, the thickness of material used in the cold-formed steel construction was often limited to about 1/4 inch because the maximum thickness of steels used under all ASTM Specifications listed in Section 1.2 of the AISI Specification …

Proceedings Of The 2nd International Symposium On Lower-Cost Housing Problems, Oktay Ural

International Symposia on Low Cost Housing Problems

To protect and improve the total human environment is a major concern of all the nations of the world. This is well noted in the recent activities of the United Nations. The provision of decent homes for every family of our world is an integral part of the human environment. It is this belief which generated the initial interest for the planning of the International Symposia on Lower-Cost Housing Problems.

The purpose of the Second International Symposium is many sided: to generate concern on the housing problems around the world as they exist today; to gather people who share mutual …

Table Of Contents, University Of Missouri--Rolla

International Symposia on Low Cost Housing Problems

No abstract provided.

Some Quasi-Uniform Space Examples, Troy L. Hicks, J. W. Carlson

Mathematics and Statistics Faculty Research & Creative Works

No abstract provided.

The Application Of Impact Dampers To Continuous Systems, Ranjit Kumar Roy

Doctoral Dissertations

"A study has been made of the application of impact dampers to two types of continuous systems, a simply supported and a clamped beam. Previous efforts have included the effect of impact dampers on single degree of freedom and other systems with finite numbers of degrees of freedom.

Experimental models were tested in the laboratory and finite element computer programs were developed to calculate response. Results from calculations agree favorably with experimental tests. Further, results from the first few natural modes also compare reasonably with data published on systems with finite number of degrees of freedom.

Curves are presented which …

Digital Spectrum Analyzer Systems: A Model And System Implementation, Richard Ray Kuenzer

Doctoral Dissertations

"This thesis introduces digital spectrum analyzer systems and presents a generalized model which can be used to implement new systems. The model is presented using the Digital Design Language (DDL) to facilitate system programming. Three hardware systems are defined and their merits are considered. Procedures are given to aid in implementing an analyzer system on a wide range of hardware configurations. A digital spectrum analyzer system which was implemented at the University of Missouri - Rolla and is presently being used by electrical engineering students is presented. This system utilizes the IBM 360/SO computer located in the Computer Center at …

Methods And Applications Of Systems Identification, Allen Glenn Behring

Doctoral Dissertations

"A "Schmidt filter" is proposed to compute an optimal orthonormal basis for a set of "noisy" filter input functions. Procedures for determining the transfer function and inverse transfer function of the filter are given. The Schmidt filter is applied to the problem of determining mathematical models of discrete, stationary, linear, dynamic systems for the case where measurements may be corrupted by noise of unknown statistics. The identification problem is reconsidered for the case where noise and signal moments are specified. Procedures are given which insure unbiased, adaptive estimates of system order and parameters for this case. These theoretical propositions are …

Thomson's E/M Experiment Revisited, Michael Glascock, Don M. Sparlin

Physics Faculty Research & Creative Works

The objective of this experiment is to familiarize the student with the impulse theorem, electron dynamics, and magnetic field contours. He is challenged to obtain accurate as well as precise measurements with suboptimum apparatus through correct analysis. He also investigates the influence of various systematic errors using model calculations on a small computer. © 1972, American Association of Physics Teachers. All rights reserved.

Transverse Cellular Mappings Of Polyhedra, Ethan Akin

Mathematics and Statistics Faculty Research & Creative Works

We generalize Marshall Cohen's notion of transverse cellular map to the polyhedral category. They are described by the following: © 1972 American Mathematical Society.

The Plasma Polymerization Of Vinyl Monomers. I. The Design, Construction, And Operation Of An Inductively Coupled Plasma Generator And Preliminary Studies With Nine Monomers, L. F. Thompson, Kenneth G. Mayhan

Chemical and Biochemical Engineering Faculty Research & Creative Works

An apparatus was constructed which would allow vinyl‐type monomers (and others) to polymerize at ambient temperatures in the presence of an inductively coupled RF field. The details of the construction of the system are reported along with preliminary results obtained from nine monomers: styrene, methylvinyldichlorosilane, vinyl acetate, acrylonitrile, vinyl fluoride, 1,1‐difluoroethylene, vinyl chloride, ethylene, and 1,3‐butadiene. Copyright © 1972 John Wiley & Sons, Inc.

Saturated Enthalpies For Mixtures Of Propane And Propene, David B. Manley, George W. Swift

Chemical and Biochemical Engineering Faculty Research & Creative Works

No abstract provided.

The Plasma Polymerization Of Vinyl Monomers. Ii. A Detailed Study Of The Plasma Polymerization Of Styrene, L. F. Thompson, Kenneth G. Mayhan

Chemical and Biochemical Engineering Faculty Research & Creative Works

A study has been made on the plasma polymerization of styrene monomer in a cold, low‐power, inductively coupled RF plasma. Styrene monomer yielded an insoluble, crosslinked film which was slightly colored. A kinetic study is reported for styrene. The effects of power level, bleed rate of monomer, pressure, and reactor geometry on the rate of polymer formation are reported. A mechanism is postulated for plasma polymerization. It was found that the initiation step was the rate controlling step and that the reaction followed a cationic polymerization scheme. Both crosslinking and discoloration of the polymers occur at the time of polymerization …

Characterization Of Poly(Methyl Methacrylate) From Radiation‐Induced Polymerization In The Presence Of A Kaolin Clay Substrate, J. J. Beeson, Kenneth G. Mayhan

Chemical and Biochemical Engineering Faculty Research & Creative Works

Two types of polymer are formed in the radiation‐initiated polymerization of methyl methacrylate (MMA)–kaolin clay complexes. Homopolymer can be extracted from the complex by the use of organic solvents. Inserted polymer must be removed by dissolution of the polymer–clay complex with hydrofluoric acid. The polymers formed show no differences in structure (as determined by infrared analysis), had high molecular weights (1–5 x 106), and had similar molecular weight distributions (as determined by GPC). The molecular weights of the homopolymer increased as temperature increased (25°–75°C), and dose rate decreased (24.9–7.35 rads/sec). The isotacticity of the polymers when compared to irradiated bulk …

An Inexpensive Electrical Vacuum Feedthrough, D. R. Kastelein, Richard A. Anderson, Kaare J. Nygaard

Physics Faculty Research & Creative Works

No abstract provided.

A Study Of Phosphorus Adsorption And Desorption Kinetics On Silicon (111) Surfaces, L. E. Davis, L. L. Levenson, J. J. Melles

Physics Faculty Research & Creative Works

Low energy electron diffraction (LEED) and Auger electron spectroscopy (AES) methods were used to characterize the (111) surface of Si wafers before and after the deposition of P2 molecules. Before deposition, the well-known Si(111)-7 LEED pattern was easily obtained by thermal cleaning at 1200 °C. Cleaning was done by electron bombardment in a vacuum chamber with a base pressure of ∼ 10-10 Torr. After cleaning, AES showed that about 10-2 atomic layer of carbon was the only surface contaminant. The sensitivity of our cylindrical AES apparatus for phosphorus was about 10-3 atomic layer. We found that ∼5x10-2 atomic layer of …

A Correction To Classical Homogeneous Nucleation Theory For Polar Molecules Exhibiting An Electric Double Layer At The Liquid Surface, Daniel R. White, James L. Kassner

Physics Faculty Research & Creative Works

An oriented dipole surface layer is added to the classical liquid drop model of nucleation to account for the surface behavior of substances having polar nonsymmetrical molecules. The preliminary treatment of the change in free energy as given by Abraham is modified to include Fletcher's exponential decay of the degree of orientation. An additional correction for the excess binding energy due to the presence of a foreign molecule in the prenucleation cluster is included to account for the inflections observed in the experimental results of Allen and Kassner. The resulting free energy of formation is combined with the kinetic treatment …

Application Of The Weiss Molecular Field Theory To The B‐Site Spinel, W. E. Holland, Harry A. Brown

Physics Faculty Research & Creative Works

A molecular field treatment of the B‐site spinel was used to determine the ordering temperatures and the asymptotic Curie temperature in terms of the exchange integrals. The theory was developed from a 16‐sublattice model and took into account interactions between an atom and its nearest to fourth‐nearest neighbors. Experimental values of the ordering temperatures and the asymptotic Curie temperature were then used to determine the exchange integrals for the systems Hg1−xCdx Cr2 S4, CdCr2S4(1−y)Se4y, and Zn1−xCdxCr2Se4. Copyright © 1972 WILEY‐VCH Verlag GmbH & Co. KGaA

An Experimental And Numerical Study Of Elastic Strain Waves On The Center Line Of A 6061-T6 Aluminum Bar, J. L. Habberstad, K. G. Hoge, J. Earl Foster

Mechanical and Aerospace Engineering Faculty Research & Creative Works

The elastic strain waves resulting from the impact of two 3/4-in-dia 6061-T6 aluminum bars are studied experimentally and analytically. Experimental data are obtained from strain gages on the center line and outer surface of the bar, located at various distances from the impact end of the bar. Experimental data are compared to numerical results obtained from integrating the exact equations of two-dimensional motion. In general, agreement between the numerical and experimental results is very good. © 1972 by ASME.

An Application Of Bubble Shape Theory To The Determination Of Air Transfer Through Adsorbed Surface Films, Robert A. Medrow

Mechanical and Aerospace Engineering Faculty Research & Creative Works

No abstract provided.

Magnetohydrodynamic Stability Of The Developing Laminar Flow In A Parallel-Plate Channel, T. S. Chen, T. E. Eaton

Mechanical and Aerospace Engineering Faculty Research & Creative Works

Linear stability of the developing laminar flow of an electrically conducting, incompressible fluid in a parallel-plate channel under a transverse magnetic field is investigated. The case of small magnetic Reynolds numbers is treated. The developing flows whose stability characteristics are studied correspond to those induced by a uniform and a parabolic velocity distribution at the channel inlet. The stability of the fully developed Hartmann flow is also reexamined. Neutral stability curves and axial variations of the critical Reynolds number are presented for a range of Hartmann numbers between 0 and 4. It is found that for Hartmann numbers larger than …

Finite-Element Analysis Of Pressure Vessels, Robert L. Davis, H. Dean Keith

Mechanical and Aerospace Engineering Faculty Research & Creative Works

The finite-element technique has been applied in the analysis of a variety of pressure vessel problems. The example problems described in this paper suggest that the finite element method is perhaps the most suitable means currently available for obtaining quick and accurate solutions for real-life pressure vessel problems. Finite-element programs can be used by the practicing engineer. Companion programs are available that can be used to check the input data and graphically display both the input and output data. © 1972 by ASME.

A Strain Energy Comparison Of Discrete Modeling For Vibrating Continuous Systems, S. K. Tolani, Richard Dale Rocke

Mechanical and Aerospace Engineering Faculty Research & Creative Works

Lumped parameter models commonly used to describe continuous one-dimensional and Bernoulli-Elder beam vibration problems have been compared on the basis of maximum system, strain energy. The consistent mass matrix approach has been included in the comparison. Standard matrix techniques have been employed to mathematically obtain desired solutions. Closed form solutions and solutions via the models to Ike system strain energy were obtained for all systems in three dynamic states: Free vibrations, constant base acceleration, and half sine base acceleration. Behavior of the strain energy errors, in general, were found to be similar to those of the frequency root errors. © …

Adsorption Of Rare Gas Atoms On Xenon, Donald E. Hagen

Physics Faculty Research & Creative Works

The problem of adsorption of rare gas atoms on solids is treated for the case of submonolayer films. An energy spectrum calculation method which is suitable for band structure or heat capacity calculations is discussed. It is particularly useful for adsorbate-substrate systems in the region intermediate between "tight binding" and "plane wave" behavior. The method employs a technique introduced by Kohn and Luttinger of using the eigenfunctions corresponding to a particular point in the Brillouin zone as a basis set. The cases of He and Ne adsorbed on Xe are discussed.

A Study Of Some Complexometric Titrations In Nonaqueous Solvents, Ngo The Hung

Masters Theses

"Complexometric titrations of calcium, zinc and lead with polyaminocarboxylic acids: ethylenediaminetetraacetic acid (EDTA), 1,2-diaminocyclohexanetetraacetic acid (DCTA), ethyleneglycol-bis(2-aminoethylether)tetraacetic acid (EGTA) and tetraethylenepentamine (tetren) have been investigated and compared in the following organic solvents: methanol, dimethyl formamide, dimethyl sulfoxide and methyl ethyl ketone. Various end point detection methods have been used: direct visual titration with metallochromic indicators and instrumental detection by photometry, potentiometry (mercury electrode and lead ion selective electrode) and amperometry. Calcium, zinc and lead can be determined up to trace levels (ppm) under specific conditions. A concrete application of this thesis is the determination of zinc or calcium in a …

Reconstruction Of Finite Duration Signals, John A. Stuller

Electrical and Computer Engineering Faculty Research & Creative Works

The Problem of Reconstructing a Finite-Duration Finite- Energy Signal that Has Been Band Limited and Sampled is Considered. an Interpolation Formula is Derived that, in Principle, Permits Perfect Signal Reconstruction in the Noiseless Case Provided Only that the Sampling Frequency Exceeds the Cutoff Frequency of the Band-Limiting Filter. the Degradation Introduced by Measurement Noise on the Samples is Evaluated. © 1972, IEEE. All Rights Reserved.

Comments On “Accelerated Model-Reference Adaptation Via Lyapunov And Steepest Descent Design Techniques”, John S. Pazdera, Hugh F. Spewce

Electrical and Computer Engineering Faculty Research & Creative Works

No abstract provided.