Digital Commons Network^™

Investigation Of The Effect Of The Wall Thickness On The Residual Stresses Developed In Thick Wall Cylinders Due To Water Quenching From The Outside Surface., Ghanshyam Chandubhai Patel

Masters Theses

"This investigation has been made to determine the residual stresses in thick wall cylinders by the use of strain gages.

The cylinders were quenched from their outer surface i n water from a temperature of 1000°F, and the resulting residual stresses were determined by Sachs boring-out method. The effect of the wall thickness of the cylinders on the residual stresses and the error developed due to the boring operation were discussed"--Abstract, p. ii

Solid Solubility Of Sodium Oxide In Tricalcium Aluminate, Joel A. Conwicke

Masters Theses

"The tie line connecting the compounds 3CaO·Al₂O₃ and Na₂O·8CaO·3Al₂O₃ in the ternary system CaO-Al₂O₃-Na₂O was studied at 1250° Celsius.

It was determined that Na₂O can exist in crystalline solution with 3CaO·Al₂O₃ in percentages of about 2.3% or less without any apparent change in the structure of 3CaO·Al₂O₃. X-ray diffraction peaks in the back-reflection region shifted to lower d-spacing values on increasing Na₂O contents.

At a Na₂O content of about 2.7%, each major x-ray …

Application Of An Orifice Meter To Fan Testing., J. F. T. Agapito

Masters Theses

"In this investigation the application of an orifice meter to fan testing was studied and evaluated. An orifice meter was designed and was installed in a centrifugal fan duct. Measurements were checked and compared with those of a standard pitot-tube traverse and were found to be in very close agreement. It is suggested that a meter of this type could easily be adapted not only to laboratory work but also to field tests"--Abstract, p. ii

The Dielectric Properties Of Thallium Nitrate., Gene E. Gowins

Masters Theses

"The purpose of this research was to investigate the dielectric behavior of thallous nitrate and to determine whether it belongs to space group Pbnm or to Pbn2.

The growing of single crystals of thallous nitrate which are suitable for dielectric measurements is difficult because the crystals are prone to initiate a dendritic growth habit. In the present work single crystals of thallous nitrate were obtained, however, by slow evaporation of an aqueous solution at 55 degrees centigrade. The crystals were plates, not larger than 8 x 8 x 2 mm, whose principal faces were subsequently indentifled as (001) planes. The …

A Method To Give The Best Linear Combination Of Order Statistics To Estimate The Mean Of Any Symmetric Population, Robert M. Smith

Masters Theses

“This paper gives a distribution for the ratio of two non-independent normally distributed random variables. The random variables involved are jointly distributed as the bivariate normal with means zero and variance- covariance matrix V.

The sample mean and one-half the sum of the smallest and largest sample observations from the symmetrically truncated Cauchy density function are compared as estimates of the mean of this density function. The reason for this comparison is to determine which of these two estimators gives the best estimate of the mean.

A method to empirically determine the best linear combination of order statistics for any …

Effect Of Hydroxyethyl Cellulose On Properties Of Concrete At Early Ages., Vipinchandra R. Shah

Masters Theses

"In this investigation, hydroxyethyl cellulose was used as an admixture in plain concrete. The admixture was tested for its effect on the compressive strength of plain concrete cylinders and for its effect on the flexural strength of plain concrete beams. Specimens were also tested for freeze-thaw durability and shrinkage.

The test results indicated that hydroxyethyl cellulose has the effect of increasing the compressive strength and decreasing the flexural strength of plain concrete. The rapid freezing and thawing tests showed that the durability increases with increase in amount of admixture.

The tests were carried out in the Materials Laboratory of the …

The Effect Of Surface Roughness, Cure Pressure, And Temperature Level On The Thermal Resistance Of Bonds And Contacts, David Leo Schwaller

Masters Theses

"This investigation was conducted to determine the thermal effect of temperature level, surface roughness, and curing pressure on bars and bonded interfaces.

The equipment used in this investigation is shown in Fig. 1 and Fig. 2. The four specimens used, cylindrical aluminum alloy bars, were cut radially at their midpoints and faced on a lathe. Heat was supplied by an electrical resistance heating element and an ice bath was used to conduct heat from the alloy specimen. A heat shield was used to insure one dimensional heat flow. Spacers were placed in the insulation at the top, the interface, and …

The Effect Of Plastic Deformations On Grain Boundaries., Jayendra Jamnadas Shah

Masters Theses

"The purpose of this study is to determine the effect of the plastic deformations on the grain boundaries and the grain structure of mild steel. Five beams tested were of A-36 steel and of 6 WF 20 rolled section. Central loading was used to develop a plastic tinge at the cent1:1r.

At the center, where a plastic hinge was formed, the effect of the plastic deformations on the grain structure was severe in all the samples taken from the tension side of all plastically or partially plastically loaded beams. In fully plastically loaded beams this effect had spread on both …

Effect Of Internal Pressure On Compressive Buckling Stress Of A Cylindrical Shell Under Eccentric Loading, Chao-Ping Chu

Masters Theses

“In this paper, an investigation was made of a thin- walled cylindrical shell under compressive load with various eccentricities and internal pressures to study the effect of the internal pressure on the compressive buckling stress of the shell.

So far, theoretical methods have not been devised to solve this problem; therefore, an experimental study was carried out. The experimental results indicated that the buckling load of the shell decreases as the eccentricity increases, that the buckling stress increases as the eccentricity increases, and that the change in buckling stress increases with an increase of internal pressure and is very nearly …

The Effects Of Granular Size On The Thermal Conductivity Of Fine Sand, Fikri Yalvac

Masters Theses

"The Thomas method (1) for determining the thermal conductivity of solid materials can be used for the determination of the thermal conductivity of granular materials. In this thesis this method has been used to determine the effect of the granular size of sand cn its thermal conductivity.

River sand was classified according to size by the Tyler Standard Screen Scale into 50-60, 50-80, 80-100, 100-200, and below 200 mesh size. These sands were used for the experiments. The clay was separated from these samples to obtain pure river sand for the experiments.

According to the International Critical Tables, the thermal …

The Missouri Miner, December 06, 1963

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, November 08, 1963

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, October 04, 1963

The Missouri Miner Newspaper

No abstract provided.

Decay Of Intensity Of Certain Hg Lines In An Hg-Ar Discharge, Edward E. Stepp, Richard A. Anderson

Physics Faculty Research & Creative Works

The afterglow of four mercury spectral lines was examined in a mercury-argon electric discharge. The 2537- Å line decays in a complex fashion with three definite modes of decay. The 4077-, 4358-, and 5461- Å lines exhibited an even more complicated decay. These lines exhibited an initial rapid decay followed by an increase in intensity. Finally the intensity of these lines went through two maxima before they decayed in intensity at a slow constant rate. The actual intensity behavior of the 2537- Å line was masked by the imprisonment of resonance radiation. It is postulated that the main processes governing …

The Missouri Miner, September 20, 1963

The Missouri Miner Newspaper

No abstract provided.

Missouri S&T Magazine, June 1963, Miner Alumni Association

Missouri S&T Magazine

No abstract provided.

The Missouri Miner, May 03, 1963

The Missouri Miner Newspaper

No abstract provided.

Theory Of The Effect Of Temperature On The Electron Diffraction Patterns Of Diatomic Molecules, Russell A. Bonham, Jerry Peacher

Physics Faculty Research & Creative Works

The effect of temperature on the electron diffraction pattern of a diatomic molecule is considered from the standpoint of the simple kinematic scattering theory utilizing a quartic vibrational potential. The potential is obtained by an expansion of ħ²J( J+1)/2μr²+D exp[-2a(r-r_e)]-2D exp[-a(r-r_e)] about its minimum value r₀. The second-order wavefunction for the nth vibrational and 7th rotational state of the system has been obtained, and expressions for the electron diffraction quantities r_g, l_e ², and M (s) have been computed. General results for the quantity M (s) …

The Missouri Miner, April 26, 1963

The Missouri Miner Newspaper

No abstract provided.

Magnetic Structure Investigations At The Nuclear Center, R. Ballestracci, E. F. Bertaut, J. Coing-Boyat, A. Delapalme, William Joseph James, R. Lemaire, R. Pauthenet, G. Roult

Chemistry Faculty Research & Creative Works

The magnetic structure of the compounds UOS, ß-CoSO₄, YCO₅, and HoCO₅ is briefly described.

UOS is antiferromagnetic. The Néel temperature is T_n=55°K. The magnetic cell is doubled in the c direction with a ++ - - sequence of U moments along c. The apparent spin is S∼1. The negative interaction corresponds to U-O-U links.

In ß-CoSO₄ (high-temperature modification, space group Pbnm), Co atoms are in 000, 00½, ½½½, ½½0. Here three different antiferromagnetic spin modes, mutually perpendicular, A_x(+ - - +), G_y(+-+-), and C_z(++ - - …

Missouri S&T Magazine, February 1963, Miner Alumni Association

Missouri S&T Magazine

No abstract provided.

An Investigation Of The Acceleration Of Neutrons, Charles Edward Byvik

Masters Theses

"The acceleration of neutrons via their magnetic dipole moment in an axially symmetric magnetic field is considered. Conditions for bunching are derived and expressions for the off-axis forces are developed. It was found that neutrons off axis are forced back onto the axis and that neutrons slightly depolarized remain in their initial state. A calculation of the acceleration is made using the field of a current loop and the conclusion is that under present laboratory capabilities a neutron accelerator is not feasible"--Abstract, page ii.

Investigation Of Ablation Materials, John Martyn Schattyn

Masters Theses

"The desired result of this paper is to determine what effect the physical and thermal properties of a material have on the ability of that material to act as an ablation heat shield. On the basis of their physical properties, five materials, nickel, beryllium, fused quartz, teflon, and phenolic-nylon, were chosen as examples.

The tools used for this study are heat transfer equations involving a change in material phase. The resulting criteria may be assumed applicable to any material exhibiting one of the four types of ablation processes"--Abstract, page 2.

The Performance Of A Mechanically-Aided Countercurrent Extraction Column., Jerry James Carr

Masters Theses

"In recent years liquid extraction has become a major industrial method for the separation of liquid solutions. Liquid extraction has proven successful in some separations performed only with great difficulty by other, more common mass-transfer operations. Th e industrial utilization of liquid extraction has resulted in considerable interest in the design and performance correlations of high-capacity, high-efficiency extraction equipment.

Continuous countercurrent columns, filled with various packings, baffles, and plates, have been found to be relatively ineffective in liquid extract on service. The density difference of the contacted phases is generally insufficient to, by itself, cause the intimate contact necessary for …

A Study Of A Method For Determining Properties Of Metals At High Strain Rates., Warren Heidbreder

Masters Theses

"An experimental method has been developed for determining the tensile and other physical properties of metals under high loading rates. Experimental equipment was designed, fabricated and tested. It was desirable to keep the equipment simple and inexpensive so that it could be used by operators Lacking experience in electronics and high-speed photography which are required for some of the more sophisticated methods now in use. The energy for pulling the specimens is supplied by smokeless gun powder. The firing of a cartridge into a closed cylinder with movable piston accomplishes the breaking of the specimen. A record of the time, …

Hydraulic Transportation Of Coal In Open Flumes., Nallapu Narayan Reddy

Masters Theses

"The objective of this study is to design a simplified form of hydraulic transportation system using open-flumes and operated by gravity in pitching coal seams. This type of system is to be used in conjunction with mining by hydraulic methods where the water used for the extraction of coal can also be used for the loading and transport functions"--Introduction p. 1

Determining Stability Of Nonlinear Control Systems Via Lyapunov's Method., John Joseph Komo

Masters Theses

"The problem undertaken in this thesis is to present Lyapunov's method of stability as i t applies to control systems and to use it in the stability analysis of nonlinear control systems. The variable gradient method of generating Lyapunov functions is presented since this seems the best general procedure for obtaining Lyapunov functions. Also, the integration of matrices method is presented as a comparison. ii

Procedures for the use of the variable gradient method and the integration of matrices method are written and several examples are used to illustrate these procedures.

It is concluded that Lyapunov's method is very definitely …

Analysis Of A Char-Forming Ablator, William J. Reilly

Masters Theses

"The purpose of this thesis is to conduct an analytical analysis of a char-forming ablation material. This is one phase of ablation heat transfer.

Fourier's general equation for one dimensional heat conduction is transformed to moving coordinates and is then solved using the applicable boundary conditions. Solutions of this equation are valid for initial studies in ablation heat transfer"--Abstract, page ii.

The Anodic Dissolution Of Zinc In Aqueous Solutions, Glenn E. Stoner

Masters Theses

"The increasing demand for protective metals as coatings and non-corrosive alloys has stimulated extensive research on the fundamental behavior of metals in corrosive media.

One of the problems still unsolved is the nature of the mechanism of the anodic dissolution of metals like zinc, magnesium, beryllium, cadmium, and aluminum in aqueous salt solutions. Several schools of investigators have proposed different and opposing theories to explain the discrepancies which often arise between coulometric data and the weight loss of metal electrodes in certain salt solutions.

The purpose of this investigation was to obtain experimental data for the anodic dissolution of zinc …

Determination Of The Standard Free Energy Of Formation Of Zr₃S₂, Peter E. Otten

Masters Theses

"The Knudsen effusion method was used to find the equilibrium magnesium pressure for the reaction

3 Zr (s) + 2 MgS (s) = 'Zr₃S₂' (s) + 2 Mg (v)

By using known standard free energy data for the formation of magnesium sulfide and by using the equilibrium magnesium pressure, the standard free energy of formation of Zr₃S₂ was calculated and could be expressed by the equation

Δ F° = -139,800 + 49.13 T cal/mole

in the temperature range 900 to 1100°C.

It was also found that Zr₃S₂ was the zirconium …