Digital Commons Network^™

Model Study Of A Folded Plate Roof, Graham G. Sutherland

Masters Theses

"The purpose of this study was to conduct a model study of a folded plate roof in order to determine the feasability [sic] of using model studies as a method of design. Dimensional analysis was used to derive prediction equations for determining the stresses in two prototype structures, when the stresses in the model were known. One model and two prototype folded plate roofs were constructed of plexiglas [sic]. SR-4 strain gages were attached to the structures and strain readings taken as a uniform vertical load was applied in increments. From the strains the stresses at various points in the …

Study Of Deformation Of Non-Oscillating Droplets In Liquid Media, Arun Kumar Agrawal

Masters Theses

"The object of this investigation was to find a method for predicting the deformation of non-oscillating liquid droplets which are moving in liquid media, from a knowledge of droplet size and the physical properties of the continuous and dispersed phase systems. The deformation of thirteen liquid-liquid systems was experimentally studied in this investigation"--Abstract, page i.

A Study Of Degradation In The Pumping Of Dilute Polymer Solutions, I-Chung Chang

Masters Theses

"In the course of an investigation of the turbulent flow properties of dilute high polymer solutions in organic solvents, a number of supplementary investigations were required. These were: 1. Determination of the molecular weights of a number of polymers by intrinsic viscosity measurements. 2. Determination of the effect of pumping on the degradation of high polymers in dilute solutions. This included development of a method for estimating the concentration of dilute polymer solutions. 3. Determination of the effects of density, viscosity and non-Newtonian behavior on the calibration of turbine flow meters"--Introduction, page 1.

Spectrographic Study Of The Afterglow Of Mercury, Edward E. Stepp, Richard A. Anderson

Physics Faculty Research & Creative Works

The short duration afterglow of 14 Hg lines was examined, at temperatures of 150°, 200°, 250°, and 300°F, in a cell that had been excited by an rf source. All of the lines exhibited a smooth exponential decay at the lowest temperature. At some temperature above 150°F, however, all of the lines, except the 2537- and 4079- Å lines, exhibited an enhancement of intensity in the time region between 50 and 100 µsec. At the highest temperature all of the lines originating from levels at an energy of 8.84 eV or above, except those originating from the 6¹D …

Stability Determination By Liapunov's Method In Nonlinear Control Systems, Neng-Chung Liao

Masters Theses

"An introduction to Liapunov's second method as it applies to control system stability is presented in this work. Main theorems and definitions of Liapunov's method are treated. In particular, Lur'e's method and Szego's method for testing the stability of a nonlinear system are presented, and several examples are used to illustrate these procedures"--Abstract, page ii.

The Cementing Of Hydraulically Placed Tailing Fill By The Oxidation Products Of Pyrrhotite, Stanley H. Alder

Masters Theses

"This thesis has been prepared to make available basic information on the use of the oxidation products of pyrrhotite to cement hydraulic tailing stope fill. As nothing has been published on this subject to date, a review has been made of pertinent information culled from accounts of work in related fields. From this study, a set of equations representing the most likely pyrrhotite oxidation reactions has been evolved and tests supporting these equations performed. Samples of fill, each containing from one to six percent of pyrrhotite, were cemented in the laboratory. They were then examined microscopically, subjected to unconfined compressive …

The Missouri Miner, October 30, 1964

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, October 23, 1964

The Missouri Miner Newspaper

No abstract provided.

A Ti-Hg Collision Cross Section, Edward E. Stepp, Richard A. Anderson

Physics Faculty Research & Creative Works

The lifetime of the 6³P₁ state of Hg was observed as a function of Tl density at two different Hg pressures. From these data it appears that at high Tl densities the lifetime of the 6³P₁ state of Hg is controlled by collisions with Tl atoms. Using this assumption and simple gas kinetic theory, a cross section for these collisions was calculated.

Missouri S&T Magazine, June 1964, Miner Alumni Association

Missouri S&T Magazine

No abstract provided.

On The Calculation Of Multicenter Two-Electron Repulsion Integrals Involving Slater Functions, Russell A. Bonham, Jerry Peacher, Henry L. Cox

Physics Faculty Research & Creative Works

Integral transforms are used to evaluate many-center two-electron repulsion integrals involving Slater s-type functions. The reduction of a general four-center integral of this type to a form convenient for computational purposes is presented. The technique described has the important advantage that all lesser many-center and one-center integrals can be obtained from the four-center case by proper choice of constants. The form of the result is such that simple single-precision numerical techniques yield rapid and accurate evaluations of many-center integrals. Several numerical examples are presented.

The Missouri Miner, April 24, 1964

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, April 17, 1964

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, March 20, 1964

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, January 17, 1964

The Missouri Miner Newspaper

No abstract provided.

A Study Of Rotational Critical Speeds For A Multi-Mass System By Influence Coefficients, Kantikumar G. Patel

Masters Theses

"In this investigation an attempt has been made to determine the critical speeds of a multi-mass rotational system by using influence coefficients. Modes of vibrations are also examined at these critical speeds.

A shaft carrying five masses, supported by bearings at the ends, has been studied analytically. The length of the bearings is considered small with respect to the shaft length and therefore, the configuration is assumed to be point supported as a simple beam. The five masses, each weighing one pound, were placed at equal distances of 10 inches on a 60 inch shaft. The critical speed was examined …

On A Numerical Solution Of Dirichlet Type Problems With Singularity On The Boundary., Randall Loran Yoakum

Masters Theses

No abstract provided.

Minimum Frictional Characteristics Of Optimum Journal Bearings., Navinchandra F. Shah

Masters Theses

"This investigation was conducted to develop a graphical representation to determine the optimum bearing conditions for minimum friction and to establish a theoretical approach for journal bearing design.

A series of graphs has been plotted for· the coefficient of friction versus the eccentricity ratio based on the. Sommerfeld number derived from Reynolds' differential equation, f or optimum journal bearings.

The results obtained in this research have been compared with those developed by other investigators. This comparison confirms the validity of the results presented in this thesis, so that it could be used advantageously for the design of optimum journal bearings"-- …

On Optimum Receiver Using Decision Theory, Philip T. Tai

Masters Theses

“In recent years communication engineers have given increased attention to the study of communication through random media. The name random is used to describe a medium the properties of which are stated only in a statistical sense. For example the impulsive response of a certain medium may only be known as one of an ensemble of possible impulsive responses; the particular member of interest being drawn up according to some statistical rule. In other words there exists some "uncertainty" concerning the characteristic description of the medium. Significant work on these problems has been done by Price and Turin. Related work …

An Analysis Of The Simulated Inductande Obtained From Forward Biased Semiconductor Diodes., Everett Harold Vannoy

Masters Theses

"The problem undertaken in this thesis is to study the simulated inductance observed in forward-biased abrupt junction p-n diodes with a highly doped p region and a nearly intrinsic n region and show that it is due to conductivity modulation. Unlike other analyses of this phenomenon, a voltage step is applied to the diode in such a direction as to forward bias it and the behavior of the injected minority carriers are observed. By comparing the resultant current through the diode to the relationship predicted by the equivalent circuit of the diode, an expression is obtained for the simulated inductance. …

The Effects Of Granular Size On The Thermal Conductivity Of Sand, Kanubhai M. Patel

Masters Theses

"The thermal conductivity of granular materials can be determined by the Thomas method. This method was used here to determine the effects of granular size on the thermal conductivity of sand. A river sand was secured and screened. The sand retained between the Tyler Standard Screen Scale, mesh 10 and 14, 14 and 28, 28 and 40, 40 and 48, 48 and 60, and below mesh 60, was used for tests.

The thermal conductivity for the above six samples obtained by the author coincide fairly well with published data.

It is reported in the International Critical Tables that the thermal …

The Plastic Behavior Of Beams With Butt Welded Connections., Paul George Hayes

Masters Theses

"The purpose of this study is to determine the length of butt welds required to develop the full plastic section modulus of a 6 WF 20 rolled section of A-36 steel. The members were electric arc welded with LR 6070 electrodes. Two-point loading was used to develop a zone of pure moment with zero shear where these members were joined.

At the cross-section to be welded, all the flange edges were prepared to receive a single-vee butt weld and the webs were prepared for a double-vee butt weld. In all cases the full length of the flange was welded. However, …

Optimum Zero-Memory Nonlinear Filter, Benjamin Shaw-Hu Wang

Masters Theses

“The purpose of this report is to review the basic work described by Zadeh insofar as systems of class N₁ are concerned and to apply his general results to a specific problem in which a non-linear filter is mandatory simply because the linear filter is essentially ineffective. The ineffectiveness stems from the fact that the autocorrelation function of the signal plus the noise has essentially the same variational character as the signal alone. Therefore, the transfer function of the linear filter turns out to be simply a constant. Thus, the output of the linear filter is just an attenuated …

Investigation Of Zero Sidesway For Rigid Frames, Dolatray S. Mehta

Masters Theses

"This study was made to determine the location of a point at which a vertical load may be applied to a rigid frame structure and produce zero sidesway, the so called zero sidesway axis. For concentrated loads equations have been derived for zero sidesway. For uniform and triangular loads graphs showing zero sidesway for various ratios of column and beam stiffnesses and height ratios have been plotted"--Abstract, page ii.

Compensator Design For Unity Feedback Systems Using An Analytical Method, Chang-Yu Wu

Masters Theses

“In control systems engineering it is frequently necessary to compensate a fixed plant whose transfer function cannot be changed. Usually the characteristics of the resulting system are established in terms of steady-state and transient performance specifications. Generally it is necessary to insert a compensator which insures stability as well as satisfies the specifications.

In this thesis an analytical method is developed to determine the transfer function of the compensator in order to satisfy the following set of specifications. The fixed system is assumed to contain one non-linearity, saturation. The input to the saturable device is constrained in a statistical …

The Design, Construction, And Evaluation Of A Vortex Stabilized Plasma Generator, Ronald Ray Williams

Masters Theses

“This report presents the design, construction, and evaluation of a vortex stabilized arc plasma generation facility operating on argon.

The facility consisted of five basic systems; the plasma genera- tor, the electrical power system, the argon flow system, the cooling system, and instrumentation.

The facility was designed to meet four general requirements; stable arc operation, low electrode deterioration, low cost of construction, and provisions for determination of the operating characteristics and thermal properties of the plasma.

Experimental results obtained in the laboratory agreed well with the design conditions. The rate of energy dissipated in the electric arc varied from 7. …

Effect Of Poly-Ethylene Glycol, A Non-Shrinking Agent, On Strength Properties Of Concrete., Vasantrai Vallabhbhai Desai

Masters Theses

"This thesis describes laboratory test made on plain concrete cylinders and ~earns for compressive strength, flexural strength, durability and shrinkage, using poly-ethylene glycol (ElOOO) as a non-shrinking admixture. The tests were conducted in the Materials Laboratory of the Civil Engineering Department.

The test results show that poly-ethylene glycol has the effect of reducing the compressive and flexural strength of plain concrete. The admixture also has the effect of reducing shrinkage, and reversing it, causing expansion with large percentage of its use. For the number of cycles of alternate freezing and thawing reported the admixture did not have any effect on …

Artifact Filter., Kent William Swearingen

Masters Theses

"Peripheral blood pulse monitors are highly susceptible to noise-artifact-- in their present stage of development. The purpose of this thesis is to demonstrate a feasible means for filtering the artifact, using existing monitors. Since no peripheral pulse monitor (transducer) was available for experimentation, a simulated test input was devised with frequency variations from JO cycles/minute to 1.50 cycles/minute.

The filtering circuit predicts the time location of each input pulse. The location of the prediction is governed by the accuracy of the preceding prediction. This is controlled by an R-C timing circuit with a Schmitt Trigger and relay.

From the data …

The Effect Of Matrix Condition In The Solution Of A System Of Linear Algebraic Equations., Herbert R. Alcorn

Masters Theses

"The solution of a system of linear non-homogeneous equations may contain errors which originate from many sources. A system of linear equations in which small changes in the coefficients cause large changes in the solution is unstable and the coefficient matrix is ill- conditioned .

The purpose of this study is to define several measures of matrix condition and to test them by correlation with a measure of the actual errors introduced into a system of equations.

The study indicates that three of the five measures of condition tested were reliable indices of the magnitude of error to expect in …

Solid-Phase Welding Of Nodular Iron To Low Carbon Steel., Scott H. Carriere

Masters Theses

“This paper presents an experimental investigation of the possibility of using solid-phase welding to join nodular iron to low carbon steel. Included is a review of available literature on solid-phase welding, tracing its origin from early Egypt to the present day. There was no previously reported work found on the welding of nodular iron to steel.

Experiments were performed to determine what temperature-pressure combination gave the greatest ultimate tensile strength These experiments resulted in the best welds being produced with an end load of 7000 pounds (35.700 psi) on a half inch diameter sample. The majority of these welds proved …