Digital Commons Network^™

The Missouri Miner, April 01, 1940, Special Issue

The Missouri Miner Newspaper

No abstract provided.

Tests On Cold Formed Steel Studs American Iron And Steel Institute, American Iron And Steel Institute

CCFSS Library (1939 - present)

I. PURPOSE OF THE INVESTIGATION The purpose of the investigation is to provide technical information for the development of standard specifications for steel stud wall construction, suitable for inclusion in building codes.

The Missouri Miner, March 27, 1940

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, March 15, 1940, Special Issue

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, March 13, 1940

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, March 06, 1940

The Missouri Miner Newspaper

No abstract provided.

Cornell University School Of Civil Engineering Tests On Light Beams Of Cold-Formed Steel, Cornell University School Of Civil Engineering

CCFSS Library (1939 - present)

I. SCOPE OF THIS REPORT 1. A.stress investigation has been made on beam E-18-12-816 b at the load points with 6 and 12 ft. span and center load and with 12 ft. span and quarter point load. 2. The results of these tests seem to show that, after the completion of similar tests on two more beams of the present shipment enough data will have been gathered to answer the question of stress distribution. It was therefore thought advisable to carry out a more complete investigation on this beam. For this purpose the stress distribution at five additional cross sections …

The Missouri Miner, February 28, 1940

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, February 21, 1940

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, February 14, 1940

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, February 07, 1940

The Missouri Miner Newspaper

No abstract provided.

Cornell University School Of Civil Engineering Tests On Light Beams Of Cold-Formed Steel, Cornell University School Of Civil Engineering

CCFSS Library (1939 - present)

I. OBJECT OF THIS REPORT 1. Investigation of the stress distribution in the bottom flange of beam A-14-612a after its reconstruction. 2. Investigation of the strain distribution in the bottom flange of beam D-18-12-816a. 3. Observations on beams E-18-12-816a and b.

The Missouri Miner, January 31, 1940

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, January 24, 1940

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, January 17, 1940

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, January 10, 1940

The Missouri Miner Newspaper

No abstract provided.

A Study Of Opacity Produced By Insoluble Refractory Opacifiers, Theodore J. Planje

Bachelors Theses

"To investigate opacification produced by insoluble, refractory opacifiers in an effort to obtain some knowledge and reliable data concerning the electrical charge on the particles - its quality and quantity, and the effect of heavy metallic ions upon the flocculation and deflocculation of the opacifying particles"--Object, page 1.

The Effect Of Clays On The Properties Of Masonry Cement, William Joseph Smothers

Bachelors Theses

"Portland cement is not a material of great antiquity. It was discovered only a little over a century ago and quite by accident. It has been the custom in the manufacture of hydraulic limes to heat argillaceous limestones to temperatures not greatly above that at which the carbon dioxide would be liberated, but this process was carried out in a stack furnace under conditions such that some parts of the material were heated to temperatures which produced sintering. These hard lumps of sintered material were discarded because they were so much more difficult to grind than the unsintered However, in …

The Rollamo 1940, The University Of Missouri School Of Mines And Metallurgy

Yearbooks

No abstract provided.

Consumption And Uses Of Crude Barite And Its Derivatives, Peter Simonds

Masters Theses

"Barite is a widely distributed mineral composed of barium sulphate - BaSO₄. Its most striking feature is its weight - its specific gravity of 4.5 being about twice that of salt and many other of the colorless, transparent and vitreous minerals of its general appearance. The Mineral is usually found in a state of considerable chemical purity. However, small amounts of strontium and calcium sulphates may isomorphously replace the barium salt. Crystals of barytes are orthorhombic; usually very perfectly developed and have a wide variety of forms. The simplest crystals are rhomb-shaped tables bounded by two faces of a basal …

Electrolytic Reduction Of Galena In Fused Salt, Peter Simonds

Masters Theses

"A demand has long existed for a method of directly recovering elemental Sulphur, in addition to the Lead, from Galena ore. At the present time, the sulphur of this ore is dissipated in the lead blast furnace as sulphur dioxide fumes. While the fumes are trapped to avoid damage to the vegetation of the surrounding countryside, their concentration is usually too low to make sulphuric acid as a profitable by-product. Thus, contrary to some speculation, the sulphuric acid produces under the circumstances is usually not a true by-product in the money-making sense of the term in many cases, but a …

Constitution And Properties Of Manganese-Copper Alloys, James Harrison Jacobs

Masters Theses

"This work was undertaken because of the recently revived interest in the use of manganese as an alloying element. This revival of interest has been mainly due to the development of the process for electro-deposition of manganese by the U. S. Bureau of Mines. Prior to the work of the bureau of Mines there was no commercial source of high purity manganese. Manganese made by the electrolytic process contains less than .03% impurities, while manganese made by other methods contains as high as 3% impurities. The use of high purity manganese as a base for alloys should open up an …

Photoelastic Investigation Of Short Beams, Ross R. Carrolla

Masters Theses

"In this investigation the author used beams made of Bakelite. They were of rectangular cross-section and centrally loaded. These beams were viewed in polarized light and the maximum fiber stresses observed in that manner were compared with those computed from the flexure formula. The purpose was to determine the minimum length-depth ratio for which the latter gave fairly accurate results"--Preface, page 6.

The Volumetric Determination Of Alumina In Clays And Related Materials, David Ferdinand Boltz

Masters Theses

"The primary purpose of this thesis was to develop a direct method for the determination of alumina in certain silicates. The classical gravimetric procedure for the analysis of alumina in clays and related materials has often been regarded as being too lengthy and troublesome, especially when only the percentage of alumina was desired. The correct determination of alumina is undoubtedly one of the most unsatisfactory of the chemical constituents of siliceous materials, and therefore the development of a direct volumetric method for the determination of this constituent was made the main objective of this research, page [1].

Absorption Of Carbon Dioxide In A Bubble Plate Tower, William Arthur Enderson

Masters Theses

"Gas absorption, one of the chief operations of chemical engineering, has occupied investigators for a long time. Results of many experiments on the general subject of gas absorption has been published. However, relatively few data have appeared in the literature on the use of bubble cap towers for gas absorption although they constitute one of the three major classifications of absorption equipment. Bubble cap towers are used extensively in the petroleum industry. More performance data would increase the versatility of existing equipment"--Introduction, page 1.

A Preliminary Report On The Placer Gold Deposits Of The Rio Acandi Seco, Choco, Republic Of Colombia, South America And A Possible Method Of Their Exploitation., Emmett Lee Arnold

Professional Degree Theses

"This property covers the valley of the Rio Acandi Seco, in the district of Acandi, Intendencia (Territory) of Choco, Republic of Columbia, South America.

It consists of four claims, or pertenencias, each straddling and paralleling the course of the Acandi Seco River. Each claim is two kilometers in width, one kilometer on each side of the stream bed, and five kilometers in length, making an area two kilometers (1 1/4 miles) in width by 20 kilometers (12 1/2 miles) in length, containing about 10,000 acres, the conversion being only approximate. These four claims are shown on the attached map as …

Essentials Of Rock Drill Design, Lister Merriken Cummings

Professional Degree Theses

"The earliest history of the rock drill is obscure and only fragmentary evidence concerning it is recorded in the Patent Office. However, no other tool has played a more important part in mining and excavating work. There have been two general classes of pneumatic rock drills -- the reciprocating, or piston machine, and the hammer drill. Fowler played an important part in the early development of piston machines, and the first hammer drill was made in about 1895 by a man named Brothers"--History, page 1.

The Application Of Fluid Level Measurements To Oil Wells In Kansas, Charles Calvert Rodd

Professional Degree Theses

"The mechanics of determining fluid levels and a knowledge of the depth-to-fluid in a well are matters of general interest. To the oil-producer, however, such information is of value only as it may affect the operation of a well or reservoir"--Uses of Fluid-Level Measurements, page 9.

The Clark National Forest Of Missouri, Walter A. Werner

Professional Degree Theses

"The question might logically arise as to the appropriateness of a thesis with a forestry title being submitted for an engineering degree. The writer has been connected with the United States Forest Service for the past four years in an advisory capacity on staff of the Forest Supervisor of the Clark National Forest, during which time he has found that the engineers and construction men have performed a major function in the development of the forest.

As the initial development consisting of lineal surveys, construction of roads and telephone lines, erection of fire lookout towers, planning and erection of ranger …

Firing Behavior Tests And Other Tests On A Missouri Stoneware Clay To Determine Its Commercial Possibilities, Ivan Martin Niedling

Bachelors Theses

"A clay's essential character is its plasticity, whether it is to be used for common brick purposes, the manufacture of refractory articles, or merely as a bonding agent for nonplastic materials. Plasticity is a very large subject; there are many theories as to its cause and many methods have been developed to record it, but so far no satisfactory quantitative measure of plasticity has been found. Perhaps the most satisfactory method is to judge by handling the clay, and with constant practice one can become expert in judging the plasticity of a clay by its feel. Such a method is, …