Digital Commons Network^™

Direct Measurement Of Dynamic Capacitance, Norman G. Dillman

Electrical and Computer Engineering Faculty Research & Creative Works

No abstract provided.

Measurement Of Positron Annihilation Line Shapes With A Ge(Li) Detector, H. (Henry) P. Hotz, J. M. Mathiesen, J. P. Hurley

Physics Faculty Research & Creative Works

We observed that the annihilation radiation photopeak in a Ge(Li) detector is considerably broader than that of a γ ray of the same energy. It seems reasonable to assume that the increased width is the result of the Doppler broadening of the annihilation photopeak, i.e., the longitudinal Doppler shift of the radiations is measured, while the transverse shift is measured in the usual angular-correlation experiments. By using a computer stripping program to remove the distortion produced by the finite energy resolution of our detector, we obtain momentum distributions in agreement with those which have been published. Only one detector is …

The Missouri Miner, November 13, 1968

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, November 06, 1968

The Missouri Miner Newspaper

No abstract provided.

Behavior Of Steel Building Connections Subjected To Inelastic Strain Reversals, E. P. Popov, R. B. Pinkney

CCFSS Library (1939 - present)

Inelastic design of steel structures to withstand seismic forces requires a knowledge of the behavior of connections when subjected to cyclically reversed loading. This report contains a description of the design and testing of selected steel beam-to-column connection specimens. The motivations for the choice of connection types and overall geometry of the specimens are discussed, relating them to full-size prototypes used in actual building frames. The characteristics of the test installation are described, including means of loading, type of lateral support provided, etc. The programs of cycling of all tests are presented in terms of the deflection of the tip …

Behavior Of Steel Building Connections Subjected To Inelastic Strain Reversals Experimental Data, E. P. Popov, R. B. Pinkney

CCFSS Library (1939 - present)

No abstract provided.

The Missouri Miner, October 02, 1968

The Missouri Miner Newspaper

No abstract provided.

Design Recommendations For Diaphragm-Braced Beams, Columns And Wall-Studs, T. V. S. R. Apparao, George Winter, S. J. Errera

CCFSS Library (1939 - present)

INTRODUCTION Light gage steel panels are often used as wall sheathing, roof decking or floor covering in steel framed buildings. These panels carry loads normal to their plane by virtue of their bending strength. Also, diaphragms formed by interconnecting such panels can resist shear deformation in their plane. Because of this shear resisting capacity, diaphragms can be very effective in bracing columns and beams of a steel frame against lateral buckling and, thus, increase the load carrying capacity of these members. For wall columns, such diaphragm bracing may be either directly attached or connected to girts which in turn are …

The Missouri Miner, September 25, 1968

The Missouri Miner Newspaper

No abstract provided.

Critical Assessment Of The Polarized-Orbital Method In Atomic Scattering, Marvin H. Mittleman, Jerry Peacher

Physics Faculty Research & Creative Works

The method of polarized orbitals used in calculating electron-atom scattering amplitudes has two obvious flaws: the wave function is discontinuous, and the method is not variationally based. These are corrected in a somewhat arbitrary manner, and it is found that the results then depend upon a parameter of the theory sufficiently strongly that there are serious doubts about the predictive nature of the theory.

Modified Dispersion Relations And Π Π Scattering, David J. George, Barbara N. Hale, Arnold Tubis

Physics Faculty Research & Creative Works

The ππ S-wave scattering-length predictions of Weinberg have been tested by using dispersion sum rules for the infinite-energy cross section. Reasonable agreement is obtained with the infinite-energy cross section (≈15 mb) estimated from the factorization theorem for the Pomeranchon Regge residues. Experimental phase-shift data of Gutay et al., Walker et al., and Baton et al. are used in estimating the dispersion integrals. The analysis seems to rule out an I = 0 S-wave scattering length ⪞0.4μ^-1.

The Missouri Miner, April 23, 1968

The Missouri Miner Newspaper

No abstract provided.

Problems In Structural Diaphragm Bracing 1. Beams Continuously Braced By Diaphragms 2. I-Section Columns Braced By Girts And A Diaphragm, T. V. S. R. Apparao, S. J. Errera, Gordon P. Fisher

CCFSS Library (1939 - present)

Shear-resistant light-gage metal diaphragms can be very effective in increasing the load carrying capacity of beams continuously braced by diaphragms, or of columns braced by girts which in turn are braced by diaphragms, if proper connections are made between the individual elements. In this thesis, behavior of diaphragm-braced I-beams, channel beams, and Z-beams under uniform moments, and the behavior of axially loaded I-section columns braced by girts which in turn are braced by diaphragms are investigated.

Load-deflection relationships of diaphragm-braced beams are obtained taking into consideration the initial imperfections of the beams and using the equilibrium method. Critical moments of …

The Atlantic Continental Margin, Bruce C. Heezen

UMR Journal -- V. H. McNutt Colloquium Series

Turbidity currents, surface, and subsurface currents carry detritus from the land across the continental shelf to the adjacent continental slope where slumps and turbidity currents transport the sediment downslope for hundreds of miles to greater depths, and deep geostrophic contour currents transport it thousands of miles down-current in a direction parallel to the bathymetric contours. The combined effect of these processes has been to create a wide, thick, geosynclinal apron of sediment at the base of the continental slope.

Subsidence of the continental shelf has continued since mid-Mesozoic, carrying down Lower Cretaceous reefal limestones to depths of 5,000 meters off …

Major Structures Of The Rocky Mountains Of Colorado And Utah, A. J. Eardley

UMR Journal -- V. H. McNutt Colloquium Series

This paper describes the major structures of Colorado and Utah and presents a theory of origin based on new knowledge of the layering and constitution of the upper mantle and lower crust. It proposes that the Ancestral Rockies and the more modem ones of Cretaceous and early Tertiary age of both the shelf of Colorado and eastern Utah and the miogeosyncline of western Utah are the result of vertical uplifts of the silicic crust. The uplifts are caused by the rise, from the upper mantle, of basalt in scattered places to the base of the silicic crust. This rise domed …

Profile Of The Folded Appalachians Of West Virginia, Byron N. Cooper

UMR Journal -- V. H. McNutt Colloquium Series

The Appalachian folded belt of southwestern Virginia exemplifies most of the structural and stratigraphic features that are considered typical of the Appalachians as a whole. The folded belt which is only 36 miles wide along the valley course of New River is generally well-defined on the southeast by the western foothills of the Blue Ridge and on the northwest side by a sharp structural front beyond which the beds are relatively gently folded.

Despite the fact that Paleozoic shelf successions of the Central Interior region are known to have controlled the thickness and facies of sedimentary formations within them and …

Missouri S&T Magazine, April 1968, Miner Alumni Association

Missouri S&T Magazine

No abstract provided.

Umr Journal: A Coast To Coast Tectonic Study Of The United States, University Of Missouri--Rolla

UMR Journal -- V. H. McNutt Colloquium Series

The UMR Journal publishes scholarly papers of scientific research and humanistic studies. These publications are distributed from Rolla, Missouri, as exchanges to scientific and humanistic institutions and libraries throughout the world.

The Missouri Miner, March 08, 1968

The Missouri Miner Newspaper

No abstract provided.

Interaction Potential Between The Ground States Of H And Hˉ, Joseph C.Y. Chen, Jerry Peacher

Physics Faculty Research & Creative Works

An investigation of the interaction potential for H and H^- in both ungerade and gerade modes is carried out by a semiempirical method in which the recently observed isotope effect in dissociative attachment of electrons to hydrogen molecules is used. The interaction obtained is complex, and the imaginary parts of the interaction account for electron emissions during the course of the interaction. A comparison of the present result with other calculations is presented. The isotope effect in dissociative attachment is also discussed. It is shown that the ratios of the survival probabilities alone do not provide an adequate approximation …

The Missouri Miner, January 12, 1968

The Missouri Miner Newspaper

No abstract provided.

Rings Of Continuous Functions On Open Convex Subsets Of R, Lyle E. Pursell

Mathematics and Statistics Faculty Research & Creative Works

No abstract provided.

The Rollamo 1968, University Of Missouri - Rolla

Yearbooks

No abstract provided.

Zener Disaccommodation In Dilute F.C.C. Co-Ti Alloys, H. B. Aaron, M. (Manfred) Wuttig, H. K. Birnbaum

Materials Science and Engineering Faculty Research & Creative Works

The magnetic Dis accommodation, i.e., the time dependence of the low field magnetic permeability, was investigated in cobalt base alloys containing 0-5.1 at.% (0-4.2 wt.%) titanium in the temperature range 400-700°C. A strong temperature dependence of the Dis accommodation observed in the range 430-530°C could be accounted for predominantly by a single first order relaxation process. Analyzing the data in terms of (a) a single exponential relaxation, (b) a lognormal distribution of relaxation times, and (c) a sum of exponential relaxations, it was shown that the relaxation strength varies as the square of the titanium concentration and that the relaxation …

Electron-Impact Lonization Cross Section In Cesium, Kaare J. Nygaard

Geosciences and Geological and Petroleum Engineering Faculty Research & Creative Works

The total ionization due to the passage of an electron beam in cesium vapor has been measured with a Tate and Smith-type apparatus. The retarding potential difference method was used in the electron gun to obtain energy resolution better than 0.1 eV. The density of Cs atoms was determined from the Taylor and Langmuir formula and also measured with a surface-ionization detector. The two methods gave the same density to within ±3% when the apparatus was in thermodynamic equilibrium with the Cs reservoir. The cross section for production of Cs+ has been determined from threshold to 100 eV. For energies …

Prediction Of Drag Reduction With A Viscoelastic Model, Gary Kent Patterson, J. L. Zakin

Chemical and Biochemical Engineering Faculty Research & Creative Works

No abstract provided.

Influence Of Continuous Precipitation Upon The Growth Kinetics Of The Cellular Reaction In An Al-Ag Alloy, H. I. Aaronson, J. B. Clark

Materials Science and Engineering Faculty Research & Creative Works

The influence of the prior formation of a continuous precipitate upon the growth kinetics of the cellular reaction has been evaluated in an Al-17.9 wt. % Ag alloy. The continuous precipitate, in the form of intragranular plates of the γ′ transition phase, was shown to have reduced the upper bound of the driving force for the cellular reaction from the silver content of the untransformed alloy to that corresponding to the coherent solvus. When this reduction (≥ 98 %) is taken into account, the growth of cells is found to be controlled by cell boundary rather than by volume diffusion …

Zap - A Computer Program To Predict Fission Product Concentrations As A Function Of Neutron Flux, Irradiation And Cooling Times, Bruce Earl Koopmann

Masters Theses

"The development of a computer code was undertaken to calculate the fission product nuclide concentration for spent fuel discharged from a nuclear reactor, as a function of irradiation time, cooling time, neutron flux, and element cross section. The necessary input data was prepared from the basic nuclear data for fission of uranium-235 and plutonium-239. Calculations are also made for total or selective element beta heating and total gamma flux according to user selected input groups. These calculations would be useful in fuel element shielding, cooling, shipping and processing studies"--Abstract, page ii.

A Direct Method Of Measuring Stray Load Loss In Dc Machines, Kanaiyalal R. Shah, George Mcpherson

Electrical and Computer Engineering Faculty Research & Creative Works

Stray load loss in dc machines is denned as the difference between the actual loss under load and the well-recognized loss. This paper describes a simple, reliable, and direct method of measuring this loss by means of a proposed short-circuit test with a correction factor for uncompensated-type dc machines. It also describes the sources and components of stray load losses as they occur under short-circuit test. Copyright © 1968 by The Institute of Electrical and Electronics Engineers, Inc.

A Numerical (Matrix) Solution For The Vibration Frequencies And Modes Of A Nonuniform Rectangular Plate With Arbitrary Edge Conditions, F. David Utterback

Masters Theses

"The material presented in this thesis is designed to provide the practicing engineer with a practical, approximate method of solution for the increasingly important problem of plate vibrations. The technique presented herein is basically an application of the use of generalized coordinates to describe the elastic and inertial properties of a finite element representation of a nonuniform rectangular plate. The plate will be idealized by utilizing a modification of the grid work technique developed by Hrennifkoff as a lattice work of interconnecting beams. By employing the elastic displacements as generalized coordinates, the only required compatibility conditions are that the displacements …