Digital Commons Network^™

The Missouri Miner, August 26, 1976

The Missouri Miner Newspaper

No abstract provided.

Missouri S&T Magazine, August 1976, Miner Alumni Association

Missouri S&T Magazine

No abstract provided.

Cross Sections For Excitation Of Atomic Hydrogen To The N=2, 3, And 4 States By 15-200-Kev Protons, John T. Park, John E. Aldag, Jacob M. George, Jerry Peacher

Physics Faculty Research & Creative Works

Cross sections for the processes H⁺+H(1 s)H⁺+H*(n = 2, 3, 4) have been extracted from the energy-loss spectra of 15- to 200-keV protons by using a spectrum-fitting technique. Absolute cross sections have been obtained by normalization of the spectra to the theoretical cross section through the use of the Born approximation at 200 keV. The cross-section curves are very similar in shape with maxima at 60 keV. The results have been compared with available theoretical calculations. The n = 2 and n = 3 cross-section measurements are in very good agreement in curve shape with Glauber-approximation …

Comparison Of Experimental And Theoretical Electron Ejection Cross Sections In Helium By Proton Impact From 5 To 100 Kev, M. Eugene Rudd, Don H. Madison

Physics Faculty Research & Creative Works

Absolute values of doubly differential cross sections are obtained for electron production in helium by 5- to 100-keV proton impact. The measured values along with earlier data at higher energies are compared with theoretical plane-wave Born-approximation functions obtained from a Hartree-Fock potential. Not only is good agreement obtained at high impact energies (above 300 keV), but fairly good agreement is found at low energies (below about 20 keV). For electrons ejected in the backward hemisphere, unexpectedly poor agreement is noted at intermediate energies where the measured cross sections dip to 50% of the calculated values in some cases. Singly differential …

Bolted Connections In Cold-Formed Steel Structures, Randall L. Mosby, Wei-Wen Yu

CCFSS Library (1939 - present)

INTRODUCTION A. Purpose of Investigation. The design of bolted connections in cold-formed steel structures is based on the present AISI Specification for the Design of Cold-Formed Steel Structural Members. 1 Prior to the development of the design criteria, bolted connections were tested at University of Michigan 2 in the 1940's and then at Cornell University 3,4 in the 1950's. The present design provisions were developed primarily on the basis of the tests conducted by George Winter and his associates at Cornell University. Additional tests were recently made by Popowich 5 on multi-bolt connections and by Dhalla 6 on connections with …

The Missouri Miner, April 29, 1976

The Missouri Miner Newspaper

No abstract provided.

Tentative Load And Resistance Factor Design Criteria For Connections, M. K. Ravindra, Theodore V. Galambos

CCFSS Library (1939 - present)

No abstract provided.

The Missouri Miner, March 25, 1976

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, February 19, 1976

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, February 05, 1976

The Missouri Miner Newspaper

No abstract provided.

Computer Graphics As An Aid To Teaching Geometric Transformations, Sister Joseph K. Mcadams, Arlan R. Dekock

Business and Information Technology Faculty Research & Creative Works

During the past several years, there has been much discussion and controversy over what should be taught in high school mathematics, in general, and in high school geometry, in particular. Numerous mathematicians have encouraged the teaching of transformations as part of the standard high school mathematics curriculum[1-4,6-9]. The results of a recent survey of high school teachers of mathematics indicate that 19% have taught geometric transformations, 26% feel adequately prepared to teach such a topic, and 50% would like to teach the topic if materials were available for the average college prep student[5].

Computer Graphics As An Aid To Teaching Geometric Transformations, Joseph K. Mcadams, Arlan R. Dekock

Business and Information Technology Faculty Research & Creative Works

No abstract provided.

Missouri S&T Magazine, February 1976, Miner Alumni Association

Missouri S&T Magazine

No abstract provided.

The Missouri Miner, January 29, 1976

The Missouri Miner Newspaper

No abstract provided.

Resource Recovery From Solid Waste: The Story Of Union Electric's Solid Waste Utilization System, David L. Klumb, Paul R. Brendel

UMR-MEC Conference on Energy / UMR-DNR Conference on Energy

This paper covers the design and development of a comprehensive resource recovery system capable of serving the solid waste disposal needs of the Greater St. Louis area comprising 11,500km² (4500 sq. mi.). This 7.2 x 10⁶ kg (8000 ton) per day operation will convert solid waste into milled fuel for cofiring with pulverized coal in utility boilers, and will recover magnetic and non-magnetic metals, all in an environmentally acceptable manner. Scheduled for operation in 1979, the system will be built and operated as a private enterprise venture of Union Colliery Company, a subsidiary of Union Electric Company.

Electrical Degradation In High Purity Barium Titanate, Jeffrey Duncan Keck

Doctoral Dissertations

"The stability of BaTiO₃-type insulators to DC fields has long been recognized as one of the important factors in determining the quality of a capacitor which uses such a material as its dielectric. The slow increase of the electrical conductivity of an insulator which is stressed by DC fields at levels below the breakdown strength is normally termed degradation. Since degradation is a very common malady to the ceramic capacitor manufacturers, many studies have been conducted over the past two decades in efforts to learn how to remedy the problem.

The results of previous studies have shown that …

Optimal Process Overdesign With A Flowsheet Simulator, Frank Joseph Doering

Doctoral Dissertations

"Overdesign is applied to chemical processes to include additional equipment for improved process reliability or to account for deviations from average conditions. An efficient method to optimize the overdesign of a complex chemical process is developed for use on a flowsheet simulation program. The effectiveness of the method is demonstrated by simulating the sulfuric acid process with metallurgical feed gas on the flowsheet program PROPS. The process is optimized for reliable and variable performance by the adaptive random search algorithm"-- Abstract, p. xi

Part I. Thermodynamic Acidities Of Substituted Phenylacetylenes. Part Ii. Mercury Accumulation In Trout Of Southern Missouri, Eric T. Lloyd

Masters Theses

"PART I: THERMODYNAMIC ACIDITIES OF SUBSTITUTED PHENYLACETYLENES The thermodynamic acidities (pKa) of phenylacetylene and several para substituted phenylacetylenes in methanol were determined at 25ºC. These acidity constants were determined using a quenching technique which involves converting the phenylacetylenic anion, present at equilibrium as sodium phenylacetylide, to the tritium labelled carbon acid. By liquid scintillation counting techniques, the concentration of the anion was determined and the pKa of the phenylacetylene compound calculated. The resulting pKa's are: p-nitrophenylacetylene, 17.98, p-bromophenylacetylene, 18.10, p-fluorophenylacetylene, 18.14, phenylacetylene, 18.50, and p-methylphenylacetylene, 18.60. The effect of a substituent in the para position on the relative acidities is …

Comments On “A Counterexample To Harmonic Linearization”, D. Ronald Fannin

Electrical and Computer Engineering Faculty Research & Creative Works

No abstract provided.

Computer Analysis Of 3-Phase Induction Motor Operation On Rural Open-Delta Distribution Systems, Stephen C. Seematter, Earl F. Richards

Electrical and Computer Engineering Faculty Research & Creative Works

Open-delta/open-delta and open-wye/open-delta transformer banks are often used as an economic means of supplying simultaneous single-phase and 3-phase loads in rural areas. If the 3-phase load is an induction motor, the inherent voltage unbalance causes increased losses and uneven heating that may lead to motor failure. Often these motors are submersible or deep well pump motors located in remote unattended areas or air conditioning motors which may not have sufficient over-design to handle the voltage unbalance. The theory analyzing the open-delta distribution system has existed for many years, however, because of the tedious and almost infinite differences in distribution topology, …

Kalman Filter Equalization For Qpsk Communications, T. S. Lee, David R. Cunningham

Electrical and Computer Engineering Faculty Research & Creative Works

The discrete complex Kalman filter is considered as an equalizer for quadrature phase-shift keyed (QPSK) systems in the presence of additive noise and InterSymbol interference (ISI). When the channel is unknown, an adaptive Kalman equalizer is used in which the channel complex tap gains are estimated by decision feedback. Copyright © 1976 by The Institute of Electrical and Electronics Engineers, Inc.

Horizon Profile Checkpoints For Low-Altitude Aircraft, Gordon E. Carlson, George L. Bair, Charles M. Benoit

Electrical and Computer Engineering Faculty Research & Creative Works

A technique for utilizing on-board sensed horizon profiles and computer stored reference horizon profiles to provide navigation check points for low-altitude aircraft is described. The technique has been analyzed using digitized terrain data and computer simulations to select the best method of horizon profile comparison, to determine horizon data density requirements, and to provide performance comparisons, system error limitations, and tradeoffs. Results of these analyses are shown to support feasibility conclusions and system parameter tradeoffs. Copyright © 1976 by The Institute of Electrical and Electronics Engineers, Inc.

A Closed-Form Solution For The Radiosity At The Edge Of A Rectangular Cavity, Alfred L. Crosbie

Mechanical and Aerospace Engineering Faculty Research & Creative Works

No abstract provided.

Deformation Produced By A Simple Tensile Load In An Isotropic Elastic Body, R. C. Batra

Mechanical and Aerospace Engineering Faculty Research & Creative Works

It is shown that a simple tensile load produces a simple extension provided the empirical inequalities (Truesdell and Noll [1], eqn. 51.27) hold. © 1976 Noordhoff International Publishing.

The Effects Of Main-Flow Radial Velocity On The Stability Of Developing Laminar Pipe Flow, F. C.T. Shen, T. S. Chen, L. M. Huang

Mechanical and Aerospace Engineering Faculty Research & Creative Works

In studying the stability due to axisymmetric disturbances of the developing flow of an incompressible fluid in the entrance region of a circular tube, a generalized version of the Orr-Sommerfeld equation was derived which takes account of the radial velocity component in the main flow. The new terms in the generalized Orr-Sommerfeld equation are inversely proportional to the Reynolds number. The resulting eigenvalue problem consisting of the disturbance equation and the boundary conditions was solved by a direct numerical integration scheme along with an iteration procedure. Neutral stability curves and critical Reynolds numbers at various axial locations are presented. A …

Evaluation Of The Results Of Gravity And Load Tests Of C And Z Purlin Roof Systems, Teoman Peköz

CCFSS Library (1939 - present)

No abstract provided.

Mass Transfer In Dispersed And Continous Phases For Creeping Flow Of Fluid Spheres Through Power Law Fluids, Türker Gürkan, Robert M. Wellek

Chemical and Biochemical Engineering Faculty Research & Creative Works

The diffusion equation was numerically solved by an implicit finite-difference method for the purpose of calculating the continuous phase Sherwood number, Sh, for mass transfer from an internally circulating Newtonian droplet traveling through a non-Newtonian power-law-type continuous phase in the creeping flow regime. The Mohan stream functions were used in the calculations in order to approximate the velocity profile inside and outside the droplet. The calculated Sh is presented as a function of the Peclet number, Pe, power-law index, n, and a viscosity ratio parameter, X. Sh increases as n decreases in the pseudoplastic region. The dependence of Sh on …

Generalized Correlations For Molecular Weight And Concentration Dependence Of Zero-Shear Viscosity Of High Polymer Solutions., J. L. Zakin, R. Wu, H. Luh, Kenneth G. Mayhan

Chemical and Biochemical Engineering Faculty Research & Creative Works

Results of a study are presented which show that two correlations of viscosity-concentration data are useful representations for data over wide ranges of mol. wt and up to at least moderately high concentrations for both good and fair solvents. Low mol. wt polymer solutions (below the critical entanglement mol. wt M//c) generally have higher viscosities than predicted by the correlations. One correlation is eta //s//p/c left bracket eta right bracket versus k prime left bracket eta right bracket c, where eta //s//p is specific viscosity, c is polymer concentration, left bracket eta right bracket is intrinsic viscosity, and k prime …

Steel Roof Deck Design Manual, Steel Deck Institute

Steel Deck Institute (SDI) Specifications and Manuals (1939 - present)

No abstract provided.

The Magnification Factor For Sodium Chloride Liesegang Circles Established With An Aerosol Centrifuge, O. Preining, Josef Podzimek, P. Yue

Physics Faculty Research & Creative Works

Sodium chloride particles deposited on a gelatin film containing silver nitrate form in a humid environment clearly visible dark brown reaction spots (Liesegang circles) after development in u.v.-light. The size of these reaction spots depends on the mass of NaCl in the particles. To establish the spot size vs particle size relation, particles produced by nebulising NaCl-solutions and sea water were sampled in an aerosol centrifuge. The location of deposition yields the aerodynamic diameter of the particle, and the spot size is measured microscopically. In this way the spot size vs aerodynamic diameter relation is established experimentally in the so …