Digital Commons Network^™

Thermal Reduction Of Beryllium Chloride With Metallic Magnesium, Mailand R. Strunk

Masters Theses

"The purpose of this research was to investigate the thermal reduction of beryllium chloride by metallic magnesium. Beryllium is a remarkable element, being characterized by its hardness, lightness and durability. Although the art of metallurgy has developed to a point at which most metals can be produced at a low cost, there are a few metals, of which beryllium is an outstanding example, which can only be obtained at high prices and in small amounts because of the difficulties of recovering the metals as such from their compounds which occur in nature. Small amounts of pure beryllium can be obtained, …

Ceramic Possibilities Of Some Missouri Clays And Shales, Leonard Nathanael Larson

Masters Theses

"Although many of the shales and clays of Missouri have in the past been, or are presently being used for the manufacture of heavy clay products such as face brick, common brick, sewer pipe, and tile, there is in these post-war years a significant shortage of these products within the state and country. Especially in the northwestern part of Missouri is there a distinct shortage, as only one structural clay plant is known to be operating in that area. The St. Louis and Southeastern Missouri districts are better prepared to meet construction demands, with several structural clay plants operating at …

A Comparison Of The Use Of Polaroid And Colored Filters In The Multiplex Aeroprojector, Robert Greig Livingston

Masters Theses

"The purpose of this thesis is the drawing of a comparison between the use of the colored filters, which are normally employed in the multiplex aeroprojector by various mapping agencies throughout the country, and the use therein of Polaroid filters. The filters in the aeroprojector serve to break the projection of a stereoscopic pair of photographs into two impressions which are viewed separately by each eye of the observer, thus providing the main requirement for the observance of a three-dimensional effect. this stereoscopic effect is utilized in the multiplex plotting machine for the delineation of contours...In order to form a …

Aircraft Finishes For Elevated Temperatures., Wilbur Louis Hayne 1922-

Electronic Theses and Dissertations

No abstract provided.

Removal Of Benzene-Insolubles From Coal Tar., John W. Mckenna 1924-2012

Electronic Theses and Dissertations

No abstract provided.

A Distillation Study : Ii. Factors Affecting Plate Efficiency : Iii. Properties Of Laminated Wood Glue Lines., Jack H. Nichols 1922-2007

Electronic Theses and Dissertations

No abstract provided.

Experiments With Pressure Methods Of Air Content Determinations For Cement Concrete, L. E. Gregg

Kentucky Transportation Center Research Report

In our report entitled "A Summary of Experiments With Air Entrainment in Cement Concrete" released last September, we recommended among other things that "The gravimetric method (A.S.T.M. Designation: C138-44) be used only as a temperary expedient for determining air contents until the pressure method or some method not dependent upon physical properties of aggregates and not influenced by other variables can be firmly established" (see item 3, page 66 of that report). At that time we were thinking of the pressure apparatus demonstrated by representatives of the Portland Cement Association during construction of the Lexington-Nicholasville Road (Project F 524 (1)-1; …

The Effects Of Low Concentrations Of Sulphur Dioxide On Oxidized Manganese Ores At Elevated Temperatures, William Henry Magill

Masters Theses

"Although there are large quantities of manganese ore in the United States, most of it is low-grade and cannot be used for the production of ferromanganese. Much government and private research has been done to concentrate the domestic low-grade ores but many problems have been encountered. A large number of treatments have been found necessary for ores from various sections of the country. Low-grade ores have been sulfated with sulfur dioxide in the gaseous state at elevated temperatures and the soluble manganous sulfate extracted with water. This gave a solution of manganous sulfate that may be used for the recovery …

Improved Techniques For Washing Iron Blue Suspensions : Ii. The Preparation Of O, O'-Dichlorobenzidine From O-Chloronitrobenzene., Marvin L. Gernert

Electronic Theses and Dissertations

I. IMPROVED TECHNIQUES FOR WASHING IRON BLUE SUSPENSIONS

The investigation of several procedures for the speeding of the washing of iron blue suspensions to remove electrolytes is reported. The use of several techniques to coagulate blue particles in the colloidal range to cause more rapid settling was found to be of little value. A conventional Oliver filter and centrifugal clarifier were found to be unsatisfactory for clearing iron blue suspensions. Considerable advantage in washing by settling and decantation was obtained with the settling of the blue suspensions in relatively shallow vessels. A continuous washing procedure was developed whereby the blue …

Ethylcellulose Lacquer Coatings For Polystyrene Plastics., Stuart V. Heil

Electronic Theses and Dissertations

An ethylcellulose lacquer system for both decorative and protective purposes was developed for use on polystyrene plastics. It was found that a one-coat lacquer containing only alcohol solvents produced the most satisfactory finish. Formulations were based on experimental work, conducted to determine the effect of the various lacquer components on the plastic. The results of a study of formulations on a two-coat system are presented.

An Investigation Into The Adaption Of The Induction Furnace For Determining The Equilibrim Diagram Of The System Cu2s-Fes, John R. Cole

Bachelors Theses and Reports, 1928 - 1970

This investigation was started in an effort to find an accurate and efficient method of determining the freezing points of ferrous and cuprous sulphides, mixtures of the two substances, and from this to establish the liquidus line of the equilibrium dia­gram.

The Civil Engineer, Lewis K. Downing

Department of Civil and Environmental Engineering Faculty Publications

No abstract provided.

Economic Talc Deposits Of Montana And Related Firing Problems, Charles J. Lyden

Bachelors Theses and Reports, 1928 - 1970

This thesis has to do with a study of the produc­tion of talc in Montana, describing the local geology of each deposit, and a description of the laboratory tests that were made on various grades of Montana talc in an attempt to determine why some grades of talc can be burned in solid forms while others must be ground, mixed with a binder and molded.

The Civil Engineer, Lewis K. Downing

Faculty Reprints

No abstract provided.

A Preliminary Investigation Of The Hydrometallurgy Of Philipsburg Manganese, W. L. Goodman

Bachelors Theses and Reports, 1928 - 1970

In the past the steel industry of the United States has depended almost wholly on imports for its supplies of manganese. Although it is well known that there are enormous deposits of low grade manganese ore in the United States the production of substantial amounts of ferro-grade mater­ial from domestic sources presents a field for con­structive and practical research.

Durability Of Concrete As Affected By Absorbed Moisture In Tennessee River Gravel Aggregate, S. T. Collier

Kentucky Transportation Center Research Report

This project is more or less a preliminary investigation of Tennessee River gravel relative to the effect of the moisture condition of the aggregates upon the durability of concrete. Certain observations made in the field indicated that absorbed moisture in the aggregate could have a marked effect on concrete, so this study was made in an attempt to give quantitative significance to the observation.

Study Of Proposed Specifications For Bituminous Coated Corrugated Metal Pipe, Robert F. Baker

Kentucky Transportation Center Research Report

On February 27 and 28, the author visited the Research Laboratories of the American Rolling Mills Company at Middletown, Ohio. The purpose of the visit was to investigate the technique and background of the new specifications for bituminous coated corrugated metal pipe as proposed by Armco with a view to changing the Kentucky Specifications (throughout this report "proposed specifications" will refer to the specifications recommended by the American Rolling Mills Company).

It is a rather evident fact, but the author wishes to point out that the short visit could furnish only an indication rather than a positive solution to the …

Proposed Field And Laboratory Study Of Flexible Pavements, Kentucky Highway Materials Research Laboratory

Kentucky Transportation Center Research Report

Research into the problem of the design and control of flexible pavement construction has resulted in the use of empirical and arbitrary solutions consisting of general theories for determining pavement thickness, gradation of aggregate, percent of bitumen, base requirements, etc. A desirable method would be one that is applicable to all aggregate, bitumen, and subgrade conditions. Until such a procedure is available, a determination of existing procedures are the immediate problems of highway engineers.

A Survey And Pedological Classification Of Kentucky Soils, Kentucky Highway Materials Research Laboratory

Kentucky Transportation Center Research Report

At the meeting of the Highway Research Board in Oklahoma City this year the Department of Soils Investigations devoted the major part of one session to a discussion of the pedological method of classifying soils. This was marked departure from past policies for heretofore pedology in soil classification was largely a matter for research, and incidentally, a controversial matter.

Outline Of Proposed Study Of Sands Used As Concrete Fine Aggregates, Kentucky Highway Materials Research Laboratory

Kentucky Transportation Center Research Report

This investigation is being made for the purpose of evaluating fine aggregates for concrete in which the percentages of fines, finer than the No. 50 and the No. sieves, are increased over that in the normal commercial sands meeting the present specifications for Class "A" concrete. It is a continuation of the studies made in Research Projects C-14 and C-15 (Reports submitted January, 1946), but enlarged to include physical tests on sand, and tests on mortar specimens, as well as the usual tests on concrete specimens.

An Evaluation Of Density And Stability Tests On Bituminous Mixes, Cary Burns, L. E. Gregg

Kentucky Transportation Center Research Report

During the past three years the Highway Materials Research Laboratory has experimented with bituminous aggregate mixes in an attempt to determine the densities that can be obtained through certain methods of compaction and the stability of the resulting mixes. The several investigations have resulted in the preparation and testing of approximately six hundred individual samples, most of which were designed to provide information as a guide for specification on particular field projects.

Proposed Working Plan For A Study Of The Properties Of Coarse Aggregates, Kentucky Highway Materials Research Laboratory

Kentucky Transportation Center Research Report

Among the numerous materials used in the construction of highways probably none is more important or perplexing than coarse aggregate. Through past research and experience a group of procedures and specifications for selecting aggregates suitable for pavements has been developed. These acceptance tests deal almost entirely with physical properties such as gradation, soundness, absorption, abrasion, etc. However, recent data accumulated by field observations and surveys (1), (7), (8)* have indicated that some materials passing the specifications have undesirable properties which cause difficulties over a long period of time. Consequently, research directed toward a more thorough investigation of aggregates has become …

History Of Ordnance Technical Intelligence In World War Ii, Part 1: History, Orders & Circulars, And Publicity, Robert Bolin , Depositor

United States Department of Defense Military Intelligence

During World War II, the Ordnance Department was one of the army technical services. There were a number of technical services including the Chemical Warfare Service, the Army Medical Department, the Corps of Engineers, the Quartermaster Corps, the Signal Corps, and the Transportation Corps. The technical services were bureaus providing weapons, equipment, and services to the Army. They managed the careers of officers in their corresponding branches, and organized special military units. They also ran schools to train individual and military units in their specialties.

During World War II the emphasis of technical intelligence was foreign weapons and equipment. The …

The Characteristics Of Fiberglas As Column Packing : I. Design Of Column : Ii. Mass-Velocity Characteristics., Robert B. Akell 1921-

Electronic Theses and Dissertations

No abstract provided.

Nebraska Farm Building Data For Panhandle Counties Taken From U.S. Census, R. M. Loper

Department of Agricultural and Biological Systems Engineering: Faculty Publications

The Material given on the following pages was selected from united States Census data for the years indicated.

It has been arranged to permit analysis and comparison of building trends since 1900, both in the state and in individual counties. Such a study often reveals areas in which effective educational programs could be develol)ed and indicates the phases of such programs which are needed most.

Unfortunately, complete 1945 figures are not available yet, but space has been left for them so that they may be added when released by the Census Buroau.

Nebraska Farm Building Data For North-East Counties Taken From U.S. Census, R. M. Loper

Department of Agricultural and Biological Systems Engineering: Faculty Publications

Fluctuation in the number of farms since the start of the century reflects economic trends, drouth effects and the results of increasing mechanization, particularly since 1935.

The 1945 figures also show the influence of land taken out of production for use as air bases, ordnance plants and ammuition depots. No doubt some of this will be returned eventually to agricultural uses. Since the buildings were removed from this land during the war some new sets probably. will be constructed when individual ownership is obtained again. Such activities present excellent opportunities for developing farmsteads efficiently and attractively arranged; buildings designed to …

Nebraska Farm Building Data For South-East Counties Taken From U.S. Census, R. M. Loper

Department of Agricultural and Biological Systems Engineering: Faculty Publications

The material given on the following pages was selected from United States Census data for the years indicated.

It has been arranged to permit analysis and comparison of building trends since 1900, both in the state and in individual counties. Such a study often reveals areas in which effective educatinal programs could be developed and indicates the phases of such programs which are needed most.

Unfortunatel, complete 1945 figures are not available yet, but the space has been left for them so that they may be added when released by the Census Bureau.

Test 379: Bear Cat Model 3000-1, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

The Age Hardening Of Copper-Manganese-Nickel Alloys, William James Barnett

Masters Theses

"The Bureau of Mines in conjunction with their Electrolytic Manganese Alloys program has developed a series of age hardening copper-manganese-nickel alloys having properties which compare favorably with those of copper-beryllium alloys...An unusual and highly desirable characteristic of these alloys is their insensitiveness to rate of cooling from the solution temperature. Air cooled and water quenched samples will have identical time hardness curves on being aged. Instead of requiring closely controlled conditions characteristic of many age hardening alloys, these alloys cannot be subjected to a thermal mechanical handling which will prevent hardening on their being subsequently heated to the aging temperature. …

The Mechanical Properties Of Mine Rocks And A Standardized Test Procedure For Their Determination, Walter Edwin Lewis

Masters Theses

"The problem involves studies of the mechanical properties of rocks and was undertaken in an attempt to determine practical data that will help in estimating the supports required to maintain the roofs of mines during and after mining operations. One of the most important problems in mining today is that of the analysis of the action of mine-rock under stresses. From such an analysis in any given mining venture it should be possible to obtain cheaper methods of mining because the supports necessary to maintain the walls and roof of an excavation may be determined on the basis of how …