Digital Commons Network^™

Experiences Of A Highway Commissioner, B. T. Moynahan

Kentucky's Annual Forum on Transportation

No abstract provided.

A Study Of Runoff From Small Drainage Areas And The Openings In Attendant Drainage Structures, Eugene M. West, J. O. Cornell

Kentucky Transportation Center Research Report

In 1926, John T. Lynch read to the Kentucky Academy of Sciences a paper entitled, "The Relation Between Drainage Area and Waterway Required for Culverts and Small Bridges in Kentucky." The paper was based on a study of many small drainage structures then existing in the highway system, and a general evaluation of the performance of the structures in relation to rainfall and runoff from contributing watersheds.

As a result of this report, and in accordance with the suggestions contained in it, the Department of Highways adopted a system of runoff coefficients applicable to different sections of the state and …

An Early Tertiary Stream Channel Between Fish And Pipestone Creeks, Ten Miles West Of Whitehall, Montana, Henry D. Olson

Bachelors Theses and Reports, 1928 - 1970

Driving between Butte, and Whitehall, Montana, on highway U.S. 10S, one observes an interesting phenomenon in the lower end of Little Pipestone Creek canyon. One side and the bottom of the canyon is cut inthe hard igneous rocks of the Boulder Batholith, and the other side of the canyon is made of unconsoli­dated sand, gravel, and cobbles.

The Effect Of Various Binders And Moisture Content On The Apparent Thermal Conductivity Of Green Foundry Sand, Robert V. Wolf

Masters Theses

"The broad field of heat transfer is well developed in its theory and mathematics, however, some few applications of varying heat transfer rates have been explored only recently.

Previous to the nineteen-thirties, foundrymen had apparently been interested in heat transfer measurements only from the standpoint of the melting of metals and the heat treatment of the finished castings, with the rate of solidification and the transfer of heat from the casting through the mold being ignored, or at least accepted as an uncontrollable factor. This does not apply, of course, to the use of metal chills to adjust solidification rates …

Test 488: Cockshutt 50 *, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 472: John Deere 60, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT: John Deere 60

TEST A: The manufacturer's representative operates the tractor for a minimum of 12 hours using light to heavy drawbar loads in each gear.

This serves as a period for limber up, general observation and adjustments. Adjustments that are permissible include valve tappet clearance, breaker ,point gap, spark plug gaps, clutch and others of a similar nature. No new parts or accessories can be installed without having mention made of it in the report. No data' are recorded during this preliminary run except the time that the engine is operated.

BELT HORSEPOWER TESTS

TEST …

Test 472: John Deere 60 Gas, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Comparative Refining Methods Of A Cane Sugar Solution., Pramod Lal Sarma

LSU Historical Dissertations and Theses

No abstract provided.

Clipper Amplitude Modulator, Durmuş Öcal

Masters Theses

"An amplitude modulated wave is defined as a wave form in which the amplitude of a sinusoidal signal (carrier) is varied in accordance with a modulating signal whose frequency is much lower than the frequency of the carrier signal. Numerous devices have been found for generating an amplitude modulated wave. In some modulators the amplitude of the carrier is actually varied in accordance with the modulating signal. In other types of modulators the carrier and the modulating signal are simultaneously applied to a nonlinear element or circuit. The output of this non-linear element is a distorted wave containing many frequencies. …

Porosity-Permeability Relationships Of Unconsolidated Sands, Robert Marchel Ponder

Masters Theses

"Unconsolidated sand reservoirs containing oil and gas present difficult problems to the petroleum engineer. Among these problems is that of the determination of the reservoir porosity to facilitate oil and gas reserve and evaluation calculations.

This problem is especially difficult because, to the author's knowledge, no method has been devised to obtain a core sample of the unconsolidated sand that retains the same porosity and permeability characteristics in the laboratory as it had underground. As a result, the petroleum engineer must rely upon empirical methods of calculating the reservoir porosity when the sand is not consolidated.

Many investigators have attempted …

The Effect Of Grain Size On Shearing Strength Of Sand, Keyhan Samimi

Masters Theses

"The object of this study is to determine experimentally the effect of definite grain size on the shearing characteristics of sandy soils. As it will be discussed in detail under the article - The Mechanics of Shear, the shearing characteristics of sandy soils depends on many factors such as grain size and shape, soil structure and relative density, the water content of soil. An attempt is made throughout the entire investigation to determine the effect of definite grain size on the shearing value and the angle of internal friction under the dry and saturated conditions. Furthermore, the results of shear …

A Comparison Of The Real Price And Market Price Of Some Common Metals, Kon-Hock Khaw

Masters Theses

"A number of complex factors influence the fluctuation of the price of a metal. In this investigation, the writer is concerned with the influence of the purchasing power of the dollar and, therefore the difference between the value (real price) and market price of nine metals. That is, this is a study of metal prices and their corresponding values. No attempt is made to analyze the supply and demand of the past or the future, except as they are expressed by their function -- price.

To aid in the comparison, a set of index numbers for metals is compiled and …

Test 470: Oliver 77 Lpg, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 479: Harris Power Horse 53, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Hydrology Of Small Drainage Areas, James Kinchen Searcy

Masters Theses

"Realizing the need for data on small drainage areas the Missouri Highway Commission in 1947 began a cooperative project with the Water Resources Division of the United States Geological Survey which includes the establishment of small area gaging stations and recording rain gages.

The purpose of this investigation is to study some of the data collected in the few years of operation of these small area stations with the aim of testing some of the hydrologic tools useful in the study of larger drainage basins to determine their applicability on small drainage basins. The relationship between the runoff of large …

The Design Of A Closed-Loop Voltage Regulator For A D-C Generator, Ernest P. Longerich

Masters Theses

"The methods of obtaining voltage regulation for a d-c generator are many, and they vary in complexity according to the requirements of the loads being supplied.

A need for zero voltage regulation is not uncommon in power supplies that are used in laboratory work. It is frequently not enough, however, to have a supply whose steady state regulation is zero; the need may also exist for fast transient response to changes in load.

In general, then, the criteria for excellent voltage-versus-load characteristics of a d-c power supply might be stated as follows:

1. It has zero steady state error.
2. It has …

Photoelastic Investigation Of Notched Corners In Square Apertures In Flat Plates Subjected To Tension, Lloyd E. Byrd Jr.

Masters Theses

"Photoelastic stress analysis is one of the most effective methods available to the engineer for solving problems of stress distribution. The effect of forces, such as pressure and tension may be studied using a scale model of a structural part. Special transparent models are subjected to forces proportional to those acting on the real object. The stress problem produced in the model indicates the stress distribution through a cross-section of the structural part.

Analysis of the photographic record of the stress analysis pattern provides data with a high degree of accuracy within a relatively short time. In simple cases, this …

X-Ray Studies Of Zirconium Cyanonitride, John T. Ballass

Masters Theses

"The purpose of this research was to study, by means of x-ray and metallographic analysis, a material reported to be zirconium cyanonitride.

The x-ray analysis had a three fold purpose, the determination of the symmetry of the constituents, the number of phases present, and the crystal structure type. Metallography was used to confirm some of the results obtained by x-ray analysis establishing certain definite phase relationships present in the microstructure.

The sample investigated contained three principal elements namely zirconium, nitrogen, and carbon. On the basis of constitution this work is a contribution toward the development of the three component equilibrum …

The Effect Of Impeller Speed And Air-Volume On The Flotation Rate With Respect To Particle Size, William Edward Horst

Masters Theses

"Today the ore being mined is low grade and the mineralization has become very complex. In order to concentrate a complex ore, the requirement of grinding the ore very fine is imposed. The process of flotation was developed to concentrate the finely ground ore particles; however, the finer size fractions of the ore still present a concentrating problem.

The fact has been established that the flotation rate which is the recovery that can be attained during a given time interval varies with particle size. The flotation rate increases with an increase in particle size until the maximum flotation rate is …

Experimental Techniques In The Kinetic Study Of Rapid Gas Phase Reactions, William Dean Burch

Masters Theses

“In recent years chemical kinetics has assumed a prominent role in Chemical Engineering studies. While a considerable amount of data is available in the general field, very little is available for rapid gas phase reactions, i. e., reactions that are completed in from a few milliseconds up to a few seconds. Recently techniques have been developed for the measurement of the rate of such reactions.

With the advent of jet aircraft, the study of very rapid oxidation reactions becomes imperative. One such reaction that presents itself in this category is the oxidation of anhydrous ammonia in the vapor state by …

Activation Energy For Recrystallization In Rolled Silver, Krishan Kumar Tangri

Masters Theses

"In several metals the process of recrystallization is accompanied by a change in the orientation of the recrystallized material with respect to the cold rolled material. If the change is sufficiently large, the changing position of the crystals can be determined by measuring the change in the intensity of the characteristic Bragg-reflection with a Geiger counter x-ray spectrometer. Recent determinations of the activation energies of copper and a 50/50 iron-nickel alloy have been made by using this x-ray technique. Both of these metals show a decided shift in the orientation as the material is recrystallized.

Silver was examined to find …

Analysis Of Magnetic Amplifiers Based On Assumed Analytical Expressions Of B-H Characteristics, Wiley Talley Ruhl

Masters Theses

"In the past 10 years, magnetic amplifiers have received much attention in many different fields of engineering. Although the principles of this amplifier have been known since 1915, it has been forced into the background by the development of the vacuum tube amplifier, the need of better core material and better dry disk rectifiers.

The basic magnetic amplifier, or saturable reactor, is nothing more than an iron core reactance coil whose a-c impedance is controlled by a d-c premagnetization of the core. This d-c premagnetization may be obtained in a number of ways, the simplest of which is a separate …

An Experimental Study Of The Effect Upon The Current Distribution And Radiation Pattern Of Crossbars On Yagi Receiving Antennas, Gerald F. Sinnamon

Masters Theses

"The development and widespread use of radar systems in World War 11, and the post-war television boom, has brought about a large amount of investigation in antenna arrays. One of the types of antennas commonly used on radar systems during the early part of the war, and one which finds wide usage today as a television receiving antenna, is the well known Yagi antenna...

Since television antennas are usually mounted out of doors, the antenna must be made mechanically strong to prevent whipping or twisting due to wind, and to prevent sagging due to icing or to its own weight. …

Design Of A Galvanometer To Be Placed Within A Tubular Antenna For The Purpose Of Measuring Antenna Current Distribution, Ferdinand Henry Mullersman

Masters Theses

"The object of this paper is to design such a galvanometer for application to cylindrical UHF antennas and to discuss the procedure involving its use. The galvanometer will then be placed inside a completely isolated parasitic antenna and the distribution of current along the antenna will be measured"--Introduction, page 5.

Shaped Charges: Their Mechanism And Applications In Mining, Pranlal Girdharlal Sheth

Doctoral Dissertations

"A shaped charge, confined or unconfined, is a unit of explosive material with a cavity or hollow at the base. It behaves differently than an ordinary charge, and, when detonated, has been found to produce curious effects of concentrating the force of the explosive on an area opposite the cavity"--Introduction, page 1.

Transfer Function Of The Modified Kramer System, David L. Hillhouse

Masters Theses

"The use of operational mathematics in the solution of engineering problems has grown tremendously in the last two decades, particularly during the last war. This has come about because of the facility with which problems which would be almost impossibly complicated or tedious to solve by classical methods can be solved using operational calculus.

The operational calculus, particularly the Laplace transform method, has become especially useful in the field of servomechanisms and controls. Here the constantly increasing complexity of systems used has resulted in very high order differential equations. The fact that the Laplace transform method makes it possible to …

A Study Of The Effect Of Jointing On The Blasting Of Granite, Graniteville, Missouri, Avery Ala Drake

Masters Theses

"Purpose of investigation: The purpose of this investigation is to attempt to determine the influence that joints exert upon the blasting of granite and if joints are induced by blasting. The problem grew out of an explosive evaluation project that was conducted by the Mining Department, Missouri School of Mines. In late May 1950, the project was moved into the granite area near Graniteville, Missouri. It became apparent upon study of this area that the jointing would have certain effects upon the results obtained. Dr. J. D. Forrester, Chairman, Department of Mining Engineering, Missouri School of Mines, Rolla, Missouri, suggested …

Nttl Engine Test 2 Petter Av2 Diesel Engine, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Engine Test 1 Petter Ava2 Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Clay Mineralogy And Soil Stabilization, James H. Havens, William A. Goodwin

Kentucky Transportation Center Research Report

This paper attempts to resolve a general concept of soil rheology from the standpoint of clay mineralogy, ion-exchange, properties of clay-water systems, and volume relationships existing between clay-water systems and granular structures. Both theory and experimental data are presented.

In the experimental phase, synthetic soils of varying clay contents were prepared from carefully fractionated soil constituents. These were subjected to combined-stress analyses, tests for plasticity characteristics, and detenninations of other physical properties.