Digital Commons Network^™

Program Evaluation And Review Technique, Anthony Immaculate Agresta

Theses

The problem of planning, controling and evaluating complex projects both engineering and non-engineering has existed as long as the projects themselves. In the past the approach of management to this problem has been one which was based heavily on the use of historical information. There have been very few attempts to predict and control the occurrence of the objective event of these projects.

This thesis deals with a review of this problem and a new approach to the planning, control, and evaluation of these complex projects. This new approach is the Program Evaluation and Review Technique (PERT) which was developed …

The Evaluation Of A Three Mode Temperature Controller By Pulse Techniques, Sanford Allen Schram

Theses

Work was performed to evaluate a commercial three mode temperature controller by pulse techniques. The extensive calculations were performed on an I. B. M. 1620 general purpose computer. Bode diagrams are presented to graphically show the instrument's dynamic response. The conclusions reached are as follows:

1. Pulse tests provide a quick method of testing the dynamic response of instruments.

2. A computer should be used for the efficient calculation of results from pulse tests.

3. Limitations of pulse tests are not yet defined but it appears that an increase in the energy of the input pulse leads to an increase …

The Corrosion Of Zinc-Stainless Steel Couples In Flowing Sea Water, Henry Shaw

Theses

The effect of sea water flow on passivated stainless steel 304 coupled to high purity zinc was studied for more than 1000 hours at 23°C. The corrosion of both members of the couple increased over that of the metals alone. Zinc suffered severe pitting while the Stainless Steel was not visibly corroded, When the metals were exposed alone, zinc corroded uniformly while the stainless steel was not affected at all. The use of zinc coupled to Stainless Steel is not recommended in systems exposed to sea water.

Crystal Habit Modification Of Sodium Chlorate, Michael R. Keegan

Bachelors Theses and Reports, 1928 - 1970

All single crystals have a particular habit or morphology. The crystal habit refers to the relative degree of development of crystallographic planes into surfaces which make up the external appearance of the single crystal.

In this paper, NaClO3 is used as a parent crystal. Its simple cubic habit is modified to tetrahedral by the use of impurities of SO4=, S2O3=, Cr2O7=, and NO3-. The degree of habit change is studied as a function of impurity concentration and temperature. The problem and phenomena are explained in terms of surface chemistry and thermodynamics.

Physico-Chemical Principles Of Sixteenth Century Metallurgy, Robert E. Johnson

Bachelors Theses and Reports, 1928 - 1970

Following a review of sixteenth century metallurgical literature and a discussion of Gibbs free energy, this thesis discusses thermodynamic considerations of galena (PbS) reduction by iron from a lead assay of this period. The importance of fluxes in this assay is emphasized. The discussion covers both equilibrium and non-equilibrium conditions at 1100 degrees Celsius. Possible substitutes for iron are also covered.

Information from twenty-one small controlled lead assays is correlated with the thermodynamic discussion to determine the purpose of each constituent in the assay.

The Beneficiation Of Titaniferous-Magnetite Sands, Ronald Lloyd Nordwick

Bachelors Theses and Reports, 1928 - 1970

The purpose of this investigation of beneficiation methods is to develop and study possible economic methods for recovering an iron-titanium concentrate of sufficient purity to meet metallurgical requirements for subsequent direct reduction to pig iron and a high titanium slag.

Stress-Corrosion Cracking Of Brass, Paul A. Fossey

Bachelors Theses and Reports, 1928 - 1970

the mechanism of stress-corrosion cracking of brass has been sought for many years. Investigators have proposed many mechanisms, but each of these mechanisms has always had several drawbacks. This paper presents an account of experimental work done in the laboratory on this subject and compares it to the work of previous investigations. It evaluates the mechanisms presented by investigators and shows the failures of these mechanisms. A theory of Nitrogen Embrittlement is presented and an evaluation of this theory with experimental work follows.

Experimental Arc Furnace Smelting Of Titaniferous Iron Sands From The Northern Oregon Coast, Allan P. Herring

Bachelors Theses and Reports, 1928 - 1970

This investigation is an attempt to experimentally smelt titaniferous iron sands from the Northern Oregon Coast in a laboratory arc furnace.

The Effect Of Ph Upon Chelation Reactions In Montmorillonite Clays, Joseph Michael Keane

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis is to investigate several chelation reactions and determine the effect of variable pH upon these reactions.

An Investigation Of The Sintering Of Iron-Wire Compacts, George L. Vivian

Bachelors Theses and Reports, 1928 - 1970

A study of the sintering of iron has been made by observing the rate of bonding of iron wires wound on iron spools. The specimens were sintered at a constant temperature of 850c in vacuum furnaces capable of producing pressures of 10-5 to 10-4 mm of mercury, and the growth of the bond between wires was observed as a function of time.

It has been concluded that the volume-diffusion mechanism is strongly operating in the sintering of iron at 850c, but in an evacuated system, the evaporation-condensation mechanism also contributes to the sintering process.

A Study Of Sprinkler Uniformity Evaluation Methods, Baha Dabbous

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The use of water in homes, on farms, by factories, and for recreational purposes has been increasing rapidly. Water use has doubled in the last three decades. By 1980, water use is expected to be double the current use. In arid and semi-arid regions, the practice of successful profit-yielding agriculture often depends on irrigation. Irrigation is, in turn, dependent upon a water supply which is limited. The highest possible efficiency should be maintained if maximum utilization of the available water resources for irrigation is desired. Sprinkler irrigation allows, among other things, high water application efficiencies with good distribution uniformities.

The Aerodynamic Drag Of Spheres, Leon Rouzelle Scott

Theses and Dissertations

A literature survey was conducted to determine the factors which affect aerodynamic drag of spheres. Graphs are presented which show the effect of each variable where such information was available. Equipment was designed and built for the purpose of studying the effects of acceleration on the aerodynamic drag of spheres. Special emphasis was placed on the measurement and control of each of the other variables which can affect the drag. Tests were conducted using large spheres in air and water to show that the method presented can produce a valid determination of the drag coefficients. The numerical values of the …

Development In Nuclear Moisture Density Testing, R. C. Deen

Kentucky's Annual Forum on Transportation

No abstract provided.

Ultimate Strength Of Reinforced Concrete Beams In Combined Torsion And Bending, Fred Schuette

Kentucky's Annual Forum on Transportation

No abstract provided.

Farm Water Storage : Circular Brick Reservoirs, R P. Harington

Journal of the Department of Agriculture, Western Australia, Series 4

A circular brick tank is a cheap and efficient water storage which can be easily built on any farm. The method described below by Kimberley Research Station manager R. P. Harington was used to build a swimming pool—storage on the station.

Flooding And Salt Problems In The Wheatbelt, Department Of Agriculture, Western Australia

Journal of the Department of Agriculture, Western Australia, Series 4

VALUABLE land has become salty in parts of the West Australian agricultural areas because most of the surrounding land has been cleared and developed for agriculture.

This salting of a small proportion of the land is part of the price paid for the development of agriculture in this State.

Drainage is not the answer to the wheatbelt flooding and salt land problems.

A more practical approach is to limit runoff from sloping land, and to make good use of salt-affected land by growing salt tolerant perennial pastures on it, says the Soils Division of the Department of Agriculture.

Us Army Foreign Science And Technology Center Planning Document, Robert Bolin , Depositor

United States Department of Defense Military Intelligence

In August 1962, the Army Foreign Science and Technology Center (FSTC) was created as a special-purpose military unit to produce technical intelligence. FSTC was subordinate to the commander of the newly created US Army Materiel Command (AMC). FSTC was created using personnel and resources of a number of Army technical intelligence agencies including:

• The Chemical Corps Intelligence Agency
• The Ordnance Technical Intelligence Agency
• The Signal Corps Intelligence Agency
• The Transportation Intelligence Agency
• The Quartermaster Intelligence Agency
• Organizations subordinate to the Corps of Engineers.

As well as from the Technical Intelligence Field Agency, ACSI

Background

On May 18, 1962, the Army …

Test 825: International 606 (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 829: John Deere 2010 C Gasoline, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 830: John Deere 2010 C Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Advertising Brochure: 1962 Ford 600, 800, 2000 - 4000 Series, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Advertisting Brochure: Ford Industrial Tractors, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 824: Oliver 1900 Series B Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 831: Oliver 1800 Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 832: Oliver 1800 Diesel 4wd, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 809: Nuffield 460 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 812: Allis-Chalmers D10 (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 815: International 4300 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 819: Farmall 504 (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 818: Farmall 404 (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …