Digital Commons Network^™

Land Preparation For Border Irrigation, B Swan

Journal of the Department of Agriculture, Western Australia, Series 4

LARGE amounts of water may be lost through excess run-off and deep percolation.

Proper preparation of irrigation land can help to minimise these losses.

This preparation is done by grading or levelling so that the original ground surface is shaped to allow for a more uniform distribution of water.

Swing Fence Flood Crossing For Creeks In The Kimberleys, A L. Payne

Journal of the Department of Agriculture, Western Australia, Series 4

FENCING is the basis of the regeneration programme on the eroded Ord River catchment area, and the fences constructed must cross numerous creeks.

But heavy downpours of short duration characterise the wet season experienced in this area.

Because the rain falls on to bare, compacted ground, run-off is intense and gullies and creeks rise rapidly, causing serious damage to conventional fences and flood gates across watercourses.

The Hydrometallurgy Of Uranium, John E. Cesarani

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

A Practical Guide To Building Contour Banks With A Road Grader, J E. Watson

Journal of the Department of Agriculture, Western Australia, Series 4

THOUSANDS of miles of contour banks have been built in Western Australia, and most of this earthmoving has been done by tractor and disc plough* or by road grader.

This article describes the technique recommended for bank construction with the road grader.

Farm Dams In The Wheatbelt, J E. Watson

Journal of the Department of Agriculture, Western Australia, Series 4

MANY new farm dams are sunk each year in the wheatbelt and much money is spent on them.

With continued development of new land, and increasing stock carrying capacity of older land under legume pastures, the need for more water supplies will continue for a long time.

Firebreaks Without Erosion : Hints To Prevent Firebreak Erosion, Department Of Agriculture, Western Australia

Journal of the Department of Agriculture, Western Australia, Series 4

AGRICULTURAL fire risks are now greater than they have been in the past and are steadily increasing with the advance of agriculture in Western Australia.

During the past 20 years the area of cleared arable land and the area under crop have more than doubled.

The area of established pasture is four times as great as it was. Pastures and crops are much more productive —and more liable to carry destructive fires than they were.

Developing A State Water Plan Utah's Water Resources--Problems And Needs--A Challenge, Utah Water Research Laboratory

Reports

Of all the natural resources with which Utah has been endowed none is more vital to the social and economic well-being of the people than it water resource. We cannot manufacture water. We have found no acceptable substitute. Not one more drop of water is available for our use today than was available to the pioneers. Yet water uses and water demands have multiplied over the years. Since we can do little to change nature's water allotment to Utah we must learn how to utilize our existing supplies more judiciously. This means devoting increasingly more attention to problems of water …

Test 859: Farmall 806 (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 861: Farmall 806 (Lpg), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 833: Minneapolis-Moline G706 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 834: Minneapolis-Moline G706 (Lpg), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 836: Minneapolis-Moline G705 (Lpg), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 835: Minneapolis-Moline G705 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 856: Farmall 706 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 839: Oliver 1800 Series B Gasoline, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 841: Oliver 1600, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 837: Allis-Chalmers Series Ii D15 (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 857: Farmall 806 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 858: Farmall 706 (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 860: Farmall 706 (Lpg), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Effects Of Gamma Radiation On Ion Exchange Membranes., John R. C. Roop

Masters Theses

No abstract provided.

Digital Computer Design Of Compensation For Linear Control Systems, Larry C. Amsler

Masters Theses

"If a control system is to be synthesized, it is inferred that a plant or process is present which must be controlled, and the problem of how to design the control system then arises. The first step is to decide on performance specifications to which the complete system must conform. These specifications may involve such things as the system steady state response, transient response, or frequency response. Any of several synthesis methods may then be applied to complete the system design.

In this study a synthesis method is developed for single-loop linear feedback systems. First, the number of compensating poles …

Parameters In Ablation Heat Sheilds, Franklin Chang Liang Lin

Masters Theses

"The desired result of this paper is a method of determining temperature distribution and burn off rate in a semi-infinite rod or shield subjected to a large heat flux. The possible methods of determination were investigated, and it was felt that an analytical approach turned out to be the most feasible.

The analytical analysis employed involves the use of the Fourier's general equation for one dimensional heat flow. Transformations from stationary to moving coordinates reduces the problem from unsteady state to steady state boundary conditions. The resulting equations can be applicable to the extent for the heat flow problems involving …

Thermocouple Shape Influence On Response In A Dynamic Compressible Fluid Atmosphere, Philip J. Steger

Masters Theses

"This investigation was performed to determine whether the geometrical shape of a thermocouple used to measure the temperature of a dynamic fluid atmosphere had any affect on its recovery factor and time response.

A converging nozzle was used to establish a dynamic fluid stream in which shaped silver solder junctions of copper-constantan thermocouples were tested. The velocity of the working fluid, air, was about 1000 ft/sec at the test point.

The investigation was successful, within experimental limits, in determining that the recovery factor of a bare thermocouple junction is not influenced by geometrical shape The results agreed substantially with available …

An Investigation Of Optimum Journal Bearings., Kulin Purshotam Maskai

Masters Theses

"Not much has been done towards calculating the "Optimum Bearing" from the point of view of maximum load capacity or minimum friction. It has been found that there 1 is not much difference in the "Optimum Bearing" proportions, as calculated, considering either minimum friction or maximum load capacity

Journal bearings are commonly used and they play a very important role in reducing friction and wear. Engineers use past experience in choosing a bearing for the given conditions. A bearing design can be obtained if 'Optium Bearing' proportions are calculated as suggested by Kingsbury (1) in his article on 'Optium Conditions …

A Preliminary Study Of The Dielectric Properties Of Bismuth Ferrate Ceramics., John Joseph Schwaller

Masters Theses

"In this investigation some of the results of Fedulov¹⁸ for a composition of 30 percent lead titanate - 70 percent bismuth ferrate were verified. The system of lead zirconatebismuth ferrate was studied with sintering data determined for the series. By X-ray and microscopic analysis the system was determined to be not a solid solution. The dielectric measurements show a linear relation between the dielectric constant and the percent lead zirconate from 100 percent BiFeo₃ to 10 percent BiFeo₃ - 90 percent PbZro₃"--Abstract, p. ii

Investigation Of Stresses And Deflections In An Inclined Beam., Jayant Chhaganlal Soni

Masters Theses

"In this thesis an investigation has been made of the effect of inclination on strains and deflections in an inclined rectangular steel beam. To compute the strains and deflections Newmark's Numerical Procedure has been used. An experiment has been carried out on a rectangular steel beam for four different load increments and eight different inclinations. To compare the experimental and analytical data, graphs have been drawn for the experimental and analytical quantities of strains and deflections for all the four load increments and eight different angles of inclination. Results of the investigation indicate that the strains and deflections at inclinations …

A Study Of The Relationships Between The Structure And The Consolidation And Swell Characteristics., Victor Foute Spruill

Masters Theses

"This paper reports the experimental results of an investigation of the relationships between the consolidation and swell characteristics of a cohesive soil and the structure of the soil. Consolidation and swell tests were run on samples prepared at their liquid limits in order to permit the effects of structure to show up in the results. The series of samples tested consisted of Putnam Clay Soil with (1) 2% sodium carbonate added, (2) no admixture, (3) 1% calcium hydroxide, and (4) 4% calcium hydroxide. Determinations were made of the per cent consolidation and per cent swell, decrease and increase in height …

A Study Of Rotational Critical Speeds For A Multi-Mass, Multi-Span System, Pravinchandra M. Upadhyay

Masters Theses

"It is well known that the unbalanced inertia forces present in rotating shafts set up violent vibrations in a transverse direction at certain speeds known as critical speeds, whirling speeds or whipping speeds. Therefore one who deals with the design of rotating machine parts, such as turbine rotors, multi-cylinder engine crankshafts etc., must consider transverse vibrations of rotating parts.

Practical solutions for finding the critical speeds of simple rotating systems, such as a single disk on a shaft with a single span, were derived by many authors. But as the number of loads and spans increases the problem becomes complex …

Heat Transfer Through A Honeycomb Sandwich Panel, Jayantilal J. Darji

Masters Theses

"Progress brought about by human ingenuity and technological developments has been always accompanied by fresh problems, the successful solution of which enables still further progress.

The recent developments in space exploration and exploitations are astounding. The coming years are likely to bring forth many remarkable achievements. Except for several engineering problems encountered with these developments the pace of progress is to study the heat transfer from honeycomb sandwich panels as an outer skin of high performance flight vehicles. The quantity of heat transferred through the panel is important in study of such vehicles, and methods or equations for determining this …