Digital Commons Network^™

A Comparative Study Of Experimental And Computed Compressibility Factors Of Methane-Nitrogen-Carbon Dioxide System, Piloo Eruchshaw Ilavia

Masters Theses

"Experimentally determined compressibility factors of a natural gas with impurities like carbon dioxide and nitrogen are found to differ with the values computed by various methods making use of compositional breakup of the gas. Compressibility factors for five mixtures of known composition were experimentally determined at room temperature, 100ºF, 125ºF, and 150ºF, and at pressure ranging between 1000 psi to 4000 psi. Using the known composition of the mixtures, compressibility factors were calculated by additive volume method and by Eilerts method. The deviation between computed and experimentally determined compressibility factors are at a maximum in the lower and higher pressure …

An Analysis Of A Synchronization Scheme For 180° Biphase Modulated Signals, James Joseph Spence

Masters Theses

"The problem of analyzing a synchronization system for demodulation of 180° biphase modulated signals is considered in this thesis. The system considered utilizes the so-called squaring loop technique. Techniques derived from the theory of Markov processes are utilized in the analysis of the system. In particular the "fluctuation equation" approach for non-Markovian processes is used. After the analysis of the system is performed, an expression fro the bit error probability is obtained from knowledge of the phase error density function"--Abstract, Page ii.

Z-Form Solution Of Non-Linear Differential Equations, Allen Joseph Rushing

Masters Theses

"The "Z-Forms" developed by Boxer and Thaler from Z-Transform theory are reviewed. Iteration is shown to increase accuracy when Z-Forms are used to obtain numerical solutions to some non-linear differential equations. Machine results are presented for example problems. Error estimates and convergence conditions are discussed. The method is usable only when 2- or 3-digit accuracy is acceptable. For some classes of equations the Z-Form method compares favorably to other numerical methods in time required to set up the problem and in machine time required for solution--Abstract, Page ii.

Mass Transfer From Spherical Gas Bubbles And Liquid Droplets Moving Through Power-Law Fluids In The Laminar Flow Regime, Robert M. Wellek, Cheng Chun Huang

Chemical and Biochemical Engineering Faculty Research & Creative Works

Calculated mass transfer coefficients for the continuous phase are presented for internally circulating spheres of a Newtonian fluid traveling through a power-law-type continuous phase in the so-called creeping-flow region. The Nakano and Tien stream functions allow the Sherwood number to be computed as a function of the Peclet number, power-law index, and a viscosity ratio parameter. The Hirose and Moo-Young relation is shown to be a limiting case of this numerical solution. Mass transfer rates increase as the fluids become more pseudoplastic and/or the continuous phase consistency index increases, all other factors held constant. © 1970, American Chemical Society. All …

On-Line Digital Computer Decoding Of Radio Teletype, Julio Alberto Spiegel

Masters Theses

"Digital computer data processing is one of the newest and fastest growing technologies. The large amount of data that can be processed is practically beyond the limit of human possibilities when available time, cost and reliability of results are taken into consideration. The use of on-line digital computer data processing to decode Radio Teletype is investigated in this thesis. The first part of this thesis considers existing teletype systems and related systems, such as Pulse Code Modulation, pointing out the differences between synchronous and asynchronous codes. The most critical step in decoding Radio Teletype is synchronization, since Radio Teletype makes …

A Proposed Concept For The Rapid Field Design Of Protective Structures, John Ross Childress

Masters Theses

"This investigation proposes a simplified concept for the rapid field design of protective structures, subject to attack by conventional artillery rounds, mortar rounds and small rockets. Parameters which should be considered during a rigorous design process are discussed. The number and complexity of these parameters make the rigorous design procedure too unwieldy to be efficiently used, in a limited time period, when materials are not available to comply with Standard Designs. Since the duration of an explosion pulse is very short and uncompacted soil is capable of absorbing explosive energy, this study investigates the theory that adequate protection can be …

A Study Of The Effects Of Added Solid-Liquid Interfacial Area On The Stabilization Characteristics Of Simulated Wastewater Stabilization Lagoons, Gary Lee Gaines

Masters Theses

"Wastewater stabilization lagoons have recently become a popular and efficient method of sewage stabilization in many parts of the country. The purpose of this investigation was to determine the effect of added solid-liquid interfacial area on the treatment capabilities of simulated wastewater stabilization lagoons. The simulated lagoons consisted of six -15 gallon aquariums which were operated in the laboratory. The solid-liquid interfacial area was increased in four of these lagoons by suspending plastic panels in the aquariums. The lagoons were operated for a period of approximately two and a half months using dehydrated milk as a simulated waste substrate. During …

Computer Time-Sharing (T-S) "An Engineering Tool" For The Engineering Applications Of The Small Company, James Binford Summers

Masters Theses

"The objectives of this investigation were to illustrate the capabilities of the time-sharing (T-S) industry, identify the means by which the small sized company, with a need to solve engineering problems, can best be served through T-S, and to present T-S to these potential users. Investigation was made of distinctive T-S services to formulate a composite of the T-S industry. Examples of three distinctive T-S services were used within this composite to exemplify the variations of services within the industry. The methods a small company could use to utilize computer services were identified emphasizing T-S as the method best suited …

The Dinary Numerical System And Its Applications To Modern Parallel Processing Computers, Hai Chi Koo

Masters Theses

"The Dinary Numerical System (DNS) is an extension of Binary Numerical System. By utilizing the newly developed Large-Scale-Integration technology, DNS can be implemented as a new concept of computer organization which has the merits of parallel processing. DNS consists of three field elements: they are -1, 0, and +1. Since DNS representation is not necessarily unique, new algorithms to generate the number of representations and all equivalent representations are presented in this paper. A Block-Oriented-Computer (BOC) is developed as an array of computing systems. For each of the systems, the arithmetic unit is essentially a modified Digital Differential Analyzer. The …

A Comparative Study Of Experimental And Computed Compressibility Factors Of Ethane-Carbon Dioxide-Nitrogen System, Brij Raj Misra

Masters Theses

"The purpose of this study was to provide compressibility factor data on the ethane - carbon dioxide - nitrogen system. Compressibility factors were experimentally determined for 5 mixtures at room temperature, 100ºF, 125ºF , 150ºF and pressures ranging between 1000 psig to 4000 psig. An attempt was also made to compare the experimental data with the compressibility factors obtained by the additive volume method. The deviation of the computed compressibility factor from the experimental data was found to be in accordance with the general view of previous workers. However, the deviation was found to be a maximum in the pressure …

Fracture Surface Energy Determinations Of High Density Polycrystalline Ceramics, Gene Arthur Pahlmann

Masters Theses

"Values of fracture surface energy were measured for steatite, zircon, mullite and four densities of alumina. Rods of these high density materials were cut into thin rectangular specimens which were notched and broken in three-point loading. The resulting load necessary for fracture of the specimens was used to calculate the fracture surface energy of the materials. The value for the steatite was around 20,000 ergs/cm². The values for the zircon and mullite were on the order of 13,000 ergs/cm², and the values for the aluminas ranged from 17,000 to 24,000 ergs/cm²"--Abstract, page ii.

Cation Grain-Boundary Diffusion In Sodium Chloride, K. R. Riggs, Manfred Wuttig

Materials Science and Engineering Faculty Research & Creative Works

No abstract provided.

Traffic Operations During Maintenance, William G. Galloway

Kentucky's Annual Forum on Transportation

No abstract provided.

Public Hearings - Closing The Communications Gap, James G. Apple

Kentucky's Annual Forum on Transportation

No abstract provided.

Transportation Research In Kentucky, Robert C. Deen

Kentucky's Annual Forum on Transportation

No abstract provided.

Kentucky Parkway System, D. H. Bray

Kentucky's Annual Forum on Transportation

No abstract provided.

Twenty-First Kentucky Highway Conference Committee, Kentucky Transportation Center

Kentucky's Annual Forum on Transportation

No abstract provided.

Engineering Geognosy Of Warren County, Jerry G. Pigman, Tommy C. Hopkins

Kentucky Transportation Center Research Report

Engineering soils and geologic maps are proving to be invaluable to engineers, industrial leaders, community planners, and administrators during the preliminary stages of planning and site selection. Quantitative engineering data on soils and geological formations, and the interpretation of these data, are important factors to consider in developing the best land-use plans and providing stable foundations for highways, buildings, and other structures, such as dams. Information of this type, when available, is being used by public and private organizations in planning urban development. Engineering soils and geologic maps can be used to great advantage in four major ways by planners …

The Static And Dynamic Balance Of Rotating Mechanisms In The Automobile, Joel E. Tjelmeland

Graduate Research Papers

What are the physics and mechanics involved in the static and dynamic balance of rotating mechanisms in the automobile? To what degree is balance necessary in the various mechanisms? What machines are available for balancing the various mechanisms? What are the skills involved in the balance of these mechanisms? How can the materials available best be organized into a unit which can be used in the industrial arts power and automotive programs?

A Liquid Extraction Column With Reciprocated Wire Mesh Packing, Robert M. Wellek, M. Uran Ozsoy, J. J. Carr, Dudley Thompson, Thomas V. Konkle

Chemical and Biochemical Engineering Faculty Research & Creative Works

In a new type of pulsating, liquid extractor, pulsating energy is added to the counter currently flowing liquid streams by a stainless-steel wire mesh packing which is reciprocated vertically in a 3-inch i.d. extraction column. The mass transfer performance and flooding characteristics are studied as a function of the frequency and amplitude of reciprocation, the total solvent and feed throughputs, and choice of phase dispersion. The benzene-HAc-H₂O and MIBK-HAcH₂O systems were used. Extraction data for the benzene system were correlated in terms of a dimensionless pulse velocity group. Operating throughputs are significantly higher than those achieved …

Industrial Arts Research Methods, Clinton E. Langstraat

Graduate Research Papers

This report has been compiled as one of the culminating activities of 33:292 Industrial Arts Research Methods. This paper can be considered as a written record of the students' and instructor's efforts in establishing further guidelines for work in 33:270, and related activities. Consequently, the report is not highly technical in nature and the number of citations is considerably less than may be found in a typical report written for graduate credit.

However, it is the opinion of the writer that some valuable information has been recorded and it is his hope that some future graduate student may find it …

A Noise Figure Lower Bound And A Frequency Converter, Grant Myers

Department of Electrical and Computer Engineering: Faculty Publications

This article establishes a lower bound for the noise figure of two networks in cascade. This is illustrated by means of a passive low-level frequency converter which utilizes a back diode as a nonlinear conductance. Other investigators have analyzed the properties of low-level frequency converters. However, the greatest lower bound of a combination of the converter and intermediate frequency amplifier system was not considered previously and is the subject of this paper. Knowledge of this lower bound has practical significance because if a measured value of noise figure is less than this lower bound, it follows that the measurement is …

A New Technique For The Solution Of Free Convection Mass Transfer Boundary Value Problems, James Lewis Putman

Theses

Free convection mass transfer in boundary layer flow due to density difference in an isothermal model was studied. Previous work was examined and a quasilinearization technique was chosen to linearize the system of nonlinear partial differential equations resulting from the boundary layer continuity, momentum, and diffusion equations. This system of linear ordinary differential equations was solved by a computer program utilizing an iterative Gauss Jordan matrix solution technique. Results are presented and the convergence rate of the variables is plotted for each variable as a function of the distance from the boundary layer.

Rheology Of Asbestos Filled Polystyrene, Richard Henry Young

Theses

A capillary rheometer was used to generate data showing the volumetric flow rate at various pressures for a polystyrene resin and for an asbestos filled polystyrene. Variables evaluated were per cent asbestos and temperature. These data were then used to calculate the maximum shear stress at the capillary wall and the corresponding maximum velocity gradient (shear rate) at the capillary wall. A rheological equation containing three constants was employed to relate the shear stress to the shear rate. In addition, a simple relationship was found between the values of two of the constants and the per cent asbestos. There is …

A Study Of Evaporation And Evapotranspiration In Peru, Fernando Chanduvi-Acuña

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Twenty-four equations for estimating evaporation and/or evapotranspiration were compared with measured Piche evaporation. At least 1728 months of records from 12 Peruvian stations were analyzed in this study.

Computer programs were developed to work this study and the results were compared by plotting.

It has been found that the equation that best fits the Piche evaporation in the low elevation stations in Peru is Christiansen's formula (ET2) which was used as a base for his formula for Class A pan evaporation (EVC).

Governmental Viewpoint, John F. O'Leary

Mining Environmental Conference

No abstract provided.

Panel Discussion, J. Allen Overton Jr., John F. O'Leary, Bryce I. Mcdonald Jr.

Mining Environmental Conference

No abstract provided.

Summary And Conclusions Of The Mining Environmental Conference, Thomas Ware

Mining Environmental Conference

No abstract provided.

Missouri Stream Studies Relating To The "New Lead Belt", Bobby G. Wixson, Ernst Bolter

Mining Environmental Conference

No abstract provided.

Proceedings Of The Mining Environmental Conference (1969, Rolla, Mo), University Of Missouri--Rolla

Mining Environmental Conference

FORWARD: Environmental problems in our complex industrial society have, in the past decade, assumed immense proportions. A population growth which will double the number of persons in the United States and in the total world in the next thirty years makes it imperative that greater care and consideration be given to the effects of industrialization on all our lives.

All industry is fair game for the advocate that suggest that there should be no change in what nature has given us. If these persons were to be followed, there would be no industrialization, no improvement in living conditions, working hours, …