Social and Behavioral Sciences Commons^™

A Randomized Controlled Trial To Evaluate The Impact Of A Geo-Specific Poster Compared To A General Poster For Effecting Change In Perceived Threat And Intention To Avoid Drowning 'Hotspots' Among Children Of Migrant Workers: Evidence From Ningbo, China, Yinchao Zhu, Xiaoqi Feng, Hui Li, Yaqin Huang, Jieping Chen, Guozhang Xu

Faculty of Social Sciences - Papers (Archive)

Background

Drowning among children of migrant workers is a major, though neglected public health issue in China.

Methods

A randomised controlled trial was used to examine the potential impact of viewing a preventive health poster with/without geo-located drowning events on perceptions of drowning risk among Chinese migrant children. A total of 752 children from three schools in Jiangbei district were selected by multi-stage sampling and randomly assigned to the intervention (n = 380) or control (n = 372). Multilevel models were used to analyse changes in responses to the following questions after viewing the assigned poster for 10 …

Wheat, Sheep Or Elvis Presley? Rural Australia Has Had To Change Its Tune, John Connell, Christopher R. Gibson

Faculty of Social Sciences - Papers (Archive)

Rural and regional Australia have had a hard time of late. The economies of Sydney and Melbourne are growing, but much of the rest of their states are not. The population of regional areas is stagnating and agriculture is struggling. Perhaps worst of all there is a feeling that no-one in Canberra or in the booming coastal periphery cares about this. The people of Orange have apparently spoken. Outside Sydney, behind what seems like an impervious sandstone curtain, not all is well. Even the largest towns in regional New South Wales are struggling to retain their populations and have faced …

Development Of Microencapsulated Phase Change Material For Solar Thermal Energy Storage, Weiguang Su, Jo Darkwa, Georgios Kokogiannakis

Faculty of Engineering and Information Sciences - Papers: Part A

In this paper a novel microencapsulated phase change material (MF-3) has been developed and tested for solar assisted hot water storage systems. Even though the morphology of the sample was affected by the type of emulsifier used for fabrication it recorded the highest energy storage capacity of 126 kJ/kg with encapsulation efficiency of 97.4% as compared with other developed samples. For the purpose of assessing its thermal effectiveness it was theoretically evaluated in a compacted fixed bed TES unit and found to be capable of achieving a higher energy storage density as well as relatively smaller physical storage size than …

Heat Transfer Analysis Of An Integrated Double Skin Facade And Phase Change Material Blind System, Yilin Li, Jo Darkwa, Georgios Kokogiannakis

Faculty of Engineering and Information Sciences - Papers: Part B

In this study, the heat transfer in an integrated double skin facade (DSF) and phase change material (PCM) blind system has been theoretically analysed. Both heat transfer and airflow models with CFD methods have been developed for the integrated DSF and PCM blind system. Data from an existing typical DSF building have been obtained in order to define input parameters for the simulation exercise and validate the numerical models. The temperature and velocity fields in DSF with the PCM blind system has been predicted under overheating scenario using the ANSYS Workbench FLUENT software and been compared with case of conventional …

Performance Evaluation Of A Novel Frost-Free Air-Source Heat Pump Integrated With Phase Change Materials (Pcms) And Dehumidification, Zhihua Wang, Fenghao Wang, Zhenjun Ma, Chun Li, Yibo Xu

Faculty of Engineering and Information Sciences - Papers: Part B

Air-source heat pump (ASHP) has been widely used in domestic and commercial buildings because of its energy savings, high efficiency and environmental friendliness. However, the heating capacity of an ASHP system is greatly influenced by the frost accumulation on the surface of the outdoor exchanger. To solve this problem, a novel frost-free ASHP system, integrating with Phase Change Materials (PCMs) and dehumidification, has been developed. In this paper, the schematic design of this system is first presented. The effect of the match relationship between the desiccant materials and PCM thermal energy storage on the performance of the novel system is …

Thermal Performance Evaluation Of An Integrated Photovoltaic Thermal-Phase Change Material System Using Taguchi Method, Haoshan Ren, Wenye Lin, Zhenjun Ma, Wenke Fan

Faculty of Engineering and Information Sciences - Papers: Part B

This paper presents the performance evaluation of an integrated photovoltaic thermal (PVT) collector-phased change material (PCM) thermal energy storage (TES) system. The PVT collectors can generate both electricity and low-grade thermal energy during the daytime, and the thermal energy generated can be temporarily stored in the PCM TES unit and used for space heating during the night-time. Taguchi method and analysis of variance are used for the simulation design and data analysis, respectively. The thermal performance of the proposed system was evaluated in terms of the useful energy stored in the TES system. The results showed that the outlet air …

Preparation Of Microencapsulated Phase Change Materials (Mepcm) For Thermal Energy Storage, Weiguang Su, Jo Darkwa, Georgios Kokogiannakis, Tongyu Zhou, Yilin Li

Faculty of Engineering and Information Sciences - Papers: Part B

Microencapsulated phase change materials (MEPCM) could be used for energy saving applications in buildings due to their relatively high energy storage capacities at constant temperature, which could passively reduce peak cooling loads in summer. In this study, poly(methyl methacrylate-co-methacrylic acid) (PMMA-MAA) was used as a shell material to fabricate MEPCM by crosslinking methyl methacrylate (MMA) and methacrylic acid (MAA) through in-situ suspension-like polymerization method. The effects of initiator weight percentage and the ratio of shell monomers for the preparation of MEPCM were also investigated. The experimental results showed that the best MEPCM sample was achieved with a shell monomer weight …