Social and Behavioral Sciences Commons^™

The Dependence Of Measured Modulation Error Ratio On Phase Noise, Ron D. Katznelson

Ron D. Katznelson

This paper reviews the algorithms used by Vector Signal Analyzers to measure Modulation Error Ratio (MER) and derives the explicit functional dependence of measured MER on phase noise of digital transmitters. The modulation error model is introduced and the analytical expression for key estimated parameters required to obtain MER measure are derived. The essential elements of algorithms employed by MER measurement instruments to estimate amplitude scale, frequency offset, and initial phase intercept and the resulting MER are identified. The frequency response of the effective phase-noise rejection filtering action associated with a given measurement epoch is derived. It is shown that …

Comments On A Proposed Change For Eurodocsis Specifications, Ron D. Katznelson

Ron D. Katznelson

This submission provides support and explanations to the recommendation that specifications adopted for European applications of CableLabs’® Downstream RF Interface specifications (“DRFI”) should be maintained in accordance with the existing North American DRFI. It contains responses to a proposed changes offered by European proponents. This note addresses the in-channel (Active Output Channel) return loss requirements and the ‘Other Channels’ spurious and noise requirements.

The Case Against A Proposed Relaxation Of Out-Of-Band Noise And Spurious Specifications For Docsis Edge-Qam Rf Devices, Ron D. Katznelson

Ron D. Katznelson

This submission supported Broadband Innovations' (BI) opposition to relaxing the Out-of-Band Noise and Spurious specifications in QAM downstream transmission of Edge-QAM (“EQAM”) devices. The specifications relaxation was proposed by a consortium of equipment vendors who called it the Joint Proposal for Self-Aggregate noise and spurious (“JPSA”). This note explains why the adoption of the JPSA would strip CATV systems from having sufficient operational noise and interference margins.

Post submission note: Despite the overwhelming majority of the Working Group's acceptance and recommendation of the JPSA, CableLabs' Technical Board voted to accept BI's proposal and to reject the JPSA.

A Case For Including Harmonic Distortion Components In Docsis’ Rf Specifications For Non Aggregating Spurious Components, Ron D. Katznelson

Ron D. Katznelson

This note is submitted in support of a change in DOCSIS specifications for spurious performance. It shows that the impact of a proposed change is negligible and that the advantages far outweigh the perceived disadvantages of adopting such a change.

Specifying And Measuring Aggregate Broadband Noise Of Catv Modulators And Upconverters, Steven I. Rubin, Andre Basovich, Brani Petrovic, Ron D. Katznelson

Ron D. Katznelson

This paper discusses the practical limitations and the subtle assumptions that must be incorporated into the specifications and measurements of Aggregate Broadband Noise of CATV upconverters and digital QAM transmitters. Considerations that govern the accuracy and measurement dynamic range required for such Aggregate Broadband Noise measures are identified. Novel methods involving the separation of the Aggregate Broadband Noise measure into its composites, namely, modulated distortion noise components and other broadband noise components are discussed. Optimal ways in which such measurement techniques have been automated to enable rapid and efficient evaluation of transmitter devices are also presented along with examples of …