Open Access. Powered by Scholars. Published by Universities.®

Social and Behavioral Sciences Commons

Open Access. Powered by Scholars. Published by Universities.®

Science and Technology Studies

2010

During

Articles 1 - 2 of 2

Full-Text Articles in Social and Behavioral Sciences

Mechanical Property Development During Uoe Forming Of Large Diameter Pipeline Steels, Andrii Kostryzhev, Martin Strangwood, Claire L. Davis Jan 2010

Mechanical Property Development During Uoe Forming Of Large Diameter Pipeline Steels, Andrii Kostryzhev, Martin Strangwood, Claire L. Davis

Faculty of Engineering and Information Sciences - Papers: Part A

Mechanical properties of large diameter welded steel pipes depend on the thermomechanically controlled rolled (TMCR) plate microstructure and UOE pipe-forming cold deformation sequence. Strength from plate to pipe may increase (work-hardening) or decrease (the Bauschinger effect). Bauschinger effect parameters depend on steel composition and plate processing history. The present study is examining two pipeline grades: X60 (Nb-alloyed) and X65 (Nb- and V-alloyed). Mechanical properties are determined by grain refinement, solid solution, precipitation strengthening mechanisms, and work-hardening (work-softening). The reverse deformation yield drop increases with an increase in the precipitate particle volume fraction and pre-strain. Annealing, leading to a decrease in …


Flicker Mitigation Strategy For Dfigs During Variable Wind Conditions, Lasantha Meegahapola, Brendan Fox, Damian Flynn Jan 2010

Flicker Mitigation Strategy For Dfigs During Variable Wind Conditions, Lasantha Meegahapola, Brendan Fox, Damian Flynn

Faculty of Engineering and Information Sciences - Papers: Part A

This paper presents a flicker mitigation scheme for the doubly-fed induction generator (DFIG) during variable wind conditions. The flicker mitigation strategy was developed based on the distribution line X/R ratio and the active power deviation from the average active power during variable wind conditions. Flicker emission was analyzed using a flicker meter based on the IEC standards. Both short-term and long-term flicker severities were analyzed during the time period of study. The flicker mitigation strategy was evaluated under different system conditions such as X/R ratio, distribution line length, shortcircuit capacity (SCC), and wind variability. It is shown that the proposed …