Open Access. Powered by Scholars. Published by Universities.®
Social and Behavioral Sciences Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Social and Behavioral Sciences
Sensitization Behaviour Of 11-12% Cr Aisi 409 Stainless Steel During Low Heat Input Welding, Cornelis Janise Van Niekerk, Madeleine Du Toit
Sensitization Behaviour Of 11-12% Cr Aisi 409 Stainless Steel During Low Heat Input Welding, Cornelis Janise Van Niekerk, Madeleine Du Toit
Faculty of Engineering and Information Sciences - Papers: Part A
The study comprised of the investigation into the sensitization characteristics of AISI 409 titanium stabilized ferritic stainless steel during low heat input welding. AISI 409 is a fully ferritic stainless steel used in catalytic converters and tubing for automotive exhaust systems due to the supposition that sensitization does not occur during low heat input welding. Two plates of 2 and 4 mm were tested for sensitization during low heat input welding. The study confirmed that chromium carbide (M23C6) precipitation occurs on the grain boundaries in the heat-affected zone with consequent depletion of Cr adjacent to the …
Hardness And Microstructural Gradients In The Heat Affected Zone Of Welded Low-Carbon Quenched And Tempered Steels, W Pang, N Ahmed, D Dunne
Hardness And Microstructural Gradients In The Heat Affected Zone Of Welded Low-Carbon Quenched And Tempered Steels, W Pang, N Ahmed, D Dunne
Faculty of Engineering and Information Sciences - Papers: Part A
This paper concentrates on the form of the hardness gradient in the heat affected zones (HAZs) produced by submerged arc welding of two low-carbon Q & T steels. The results show unequivocally that the gradient differs from that found in steels of lower carbon equivalent in that the peak HAZ hardness is displaced from the grain coarsened heat affected zone (GCHAZ) into the grain refined heat affected zone (GRHAZ). Weld thermal cycle simulation has been used to confirm the results obtained from actual welds and to clarify the cause of this unexpected phenomenon.