Physical Sciences and Mathematics Commons^™

Collision Broadening Using Alkali-Filled, Hollow Core Fibers, Luke P. Rodgers

Theses and Dissertations

The goal of this research was to demonstrate the possibility of collision broadening in a cesium-filled, hollow-core fiber as an alternative to the proven technique of pressure broadening. Theoretically, alkali electrons should relax from the ²P_3/2 to the ²P_1/2 level and the absorption spectrum should collisionally broaden due to the presence of fiber walls, as opposed to the more common pressure broadening method. An absorption dip located at 852.34nm was recorded in a pressure broadened comparison leg. This data was used as a baseline during analysis of the fiber leg's data. While the fiber was successfully …

Evanescent Field Absorption Sensing Using Sapphire Fibers, Michael Grossman

USF Tampa Graduate Theses and Dissertations

This thesis explores the application of coiled sapphire multimode optical fibers for evanescent wave chemical sensing in both the visible spectrum and the near infrared. As has been suggested in the literature pertaining to silica fibers, bending converts low-order modes to high order ones, which leads to more evanescent absorption and thus a more sensitive chemical detector. By coiling the fiber many times, it was expected that even greater sensitivity would be attained.

Experiments were performed to investigate the sensor response to different solutions and to characterize this response. In the first of three experiments, the large absorption peak of …

Direct Diode Pumped Raman Amplifier Based On A Multimode Graded Index Fiberr, Charles James Baird

Theses and Dissertations

The direct pumping of a Raman fiber amplifier (RFA) was attempted using an array of four 25W, fiber pigtailed diodes at 936nm, combined via a 7 channel fiber beam combiner. The initial attempt was conducted using a 1.8 km, 100 micron core, GRIN fiber with an NA of .29 and attenuation 3.6 dB/km at 936nm. While amplification was not achieved, over 200mW of conversion was shown, with 10.4W of pump power and 3.5W of seed. This corresponds to an average conversion efficiency of 2.2%. The subsequent effort utilized a 2km long, 200 micron core, GRIN fiber, with NA of .27 …