Open Access. Powered by Scholars. Published by Universities.®

Physical Sciences and Mathematics Commons

Open Access. Powered by Scholars. Published by Universities.®

Physics

Wright State University

Theses/Dissertations

2017

Carbon Nanotube

Articles 1 - 2 of 2

Full-Text Articles in Physical Sciences and Mathematics

Multiscale Modeling Of Carbon Nanotube Synthesis In A Catalytic Chemical Vapor Deposition Reactor, Jonathan Troville Jan 2017

Multiscale Modeling Of Carbon Nanotube Synthesis In A Catalytic Chemical Vapor Deposition Reactor, Jonathan Troville

Browse all Theses and Dissertations

The bottom-up analysis of Carbon Nanotube synthesis is not well understood. Specifically, the question as to how carbon adsorbs to a substrate inclusive of a supported catalyst may lead to the energetically favorable structure of a hexagonal close- packed structure along the wall, or walls, of the tube. A first time simulation using COMSOL Multiphysics has been generated in order to capture the gas-phase mech- anism which leads to carbon production. It is thought that the carbon adsorbs and the walls are formed from the bottom up and the inside out for multi-wall CNTs. The studies involved accurately setting up …


Extraordinary Optical Transmission In Aligned Carbon Nanotube Devices At Terahertz Frequencies., Shaikhah F. Almousa Jan 2017

Extraordinary Optical Transmission In Aligned Carbon Nanotube Devices At Terahertz Frequencies., Shaikhah F. Almousa

Browse all Theses and Dissertations

In the phenomenon known as extraordinary optical transmission (EOT), a narrow band of selected frequencies are transmitted when incident on an array of subwavelength periodic apertures where the resonant frequency is determined by the geometry of the array of apertures and optical properties of the metal-dielectric interface. This takes place due to the excitation of surface plasmon polaritons (SPPs) at the metal and dielectric interface. Using the COMSOL Multiphysics software RF Module, a unit cell of a carbon nanotube (CNT) based EOT device is modeled in order to verify theoretical calculations of the resonant frequency using S-parameter calculations. The simulation …