Open Access. Powered by Scholars. Published by Universities.®

Physical Sciences and Mathematics Commons™

Open Access. Powered by Scholars. Published by Universities.®

Engineering

Air Force Institute of Technology

2015

Articles 1 - 10 of 10

Full-Text Articles in Physical Sciences and Mathematics

Modeling Napl Dissolution From Pendular Rings In Idealized Porous Media, Junqi Huang, John A. Christ, Mark N. Goltz, Avery H. Demond Oct 2015

Modeling Napl Dissolution From Pendular Rings In Idealized Porous Media, Junqi Huang, John A. Christ, Mark N. Goltz, Avery H. Demond

Faculty Publications

The dissolution rate of nonaqueous phase liquid (NAPL) often governs the remediation time frame at subsurface hazardous waste sites. Most formulations for estimating this rate are empirical and assume that the NAPL is the nonwetting fluid. However, field evidence suggests that some waste sites might be organic wet. Thus, formulations that assume the NAPL is nonwetting may be inappropriate for estimating the rates of NAPL dissolution. An exact solution to the Young‐Laplace equation, assuming NAPL resides as pendular rings around the contact points of porous media idealized as spherical particles in a hexagonal close packing arrangement, is presented in this …

Go to article

An Analysis Of Conus Based Deployment Of Pseudolites For Positioning, Navigation And Timing (Pnt) Systems, Justin H. Deifel, Albert J. Pena Sep 2015

An Analysis Of Conus Based Deployment Of Pseudolites For Positioning, Navigation And Timing (Pnt) Systems, Justin H. Deifel, Albert J. Pena

Theses and Dissertations

The Global Positioning System (GPS) developed and operated by the United States Air Force (USAF) provides a way for users to determine position, navigation and timing (PNT). GPS provides an extraordinary capability that has become instrumental in all aspects of our day to day lives. As new technologies such as automated vehicles and unmanned aircraft continue to be developed, a reliable back up to GPS is required to ensure the PNT data generated in these systems is accurate. This research studies a potential architecture for deploying a nationwide network of ground based pseudolites that would act to supplement and backup …

Go to article

Adaptive Automation Design And Implementation, Jason M. Bindewald Sep 2015

Adaptive Automation Design And Implementation, Jason M. Bindewald

Theses and Dissertations

Automations allow us to reduce the need for humans in certain environments, such as auto-pilot features on unmanned aerial vehicles. However, some situations still require human intervention. Adaptive automation is a research field that enables computer systems to adjust the amount of automation by taking over tasks from or giving tasks back to the user. This research develops processes and insights for adaptive automation designers to take theoretical adaptive automation ideas and develop them into real-world adaptive automation system. These allow developers to design better automation systems that recognize the limits of computers systems, enabling better designs for systems in …

Go to article

Improved Terahertz Modulation Using Germanium Telluride (Gete) Chalcogenide Thin Films, Alexander H. Gwin, Christopher H. Kodama, Tod V. Laurvick, Ronald Coutu Jr., Philip F. Taday Jul 2015

Improved Terahertz Modulation Using Germanium Telluride (Gete) Chalcogenide Thin Films, Alexander H. Gwin, Christopher H. Kodama, Tod V. Laurvick, Ronald Coutu Jr., Philip F. Taday

Faculty Publications

We demonstrate improved terahertz (THz) modulation using thermally crystallized germanium telluride (GeTe) thin films. GeTe is a chalcogenide material that exhibits a nonvolatile, amorphous to crystalline phase change at approximately 200 °C, as well as six orders of magnitude decreased electrical resistivity. In this study, amorphous GeTe thin films were sputtered on sapphire substrates and then tested using THz time-domain spectroscopy (THz-TDS). The test samples, heated in-situ while collecting THz-TDS measurements, exhibited a gradual absorbance increase, an abrupt nonvolatile reduction at the transition temperature, followed by another gradual increase in absorbance. The transition temperature was verified by conducting similar thermal …

Go to article

Coupling Nuclear Induced Phonon Propagation With Conversion Electron Mössbauer Spectroscopy, Michael J. Parker Jun 2015

Coupling Nuclear Induced Phonon Propagation With Conversion Electron Mössbauer Spectroscopy, Michael J. Parker

Theses and Dissertations

Mössbauer spectroscopy is a very sensitive measurement technique (10-8 eV) which prompted motivation for the experiment described in this thesis. Namely, can a sensitive detection system be developed to detect nuclear recoils on the order of 10 to 100 of eVs? The hypothesis that this thesis tests is: Nuclear induced phonon bursts caused by Rutherford scattered alphas, decayed from 241Am, in a type-310 stainless steel material can couple with 7.3 keV conversion electron Mössbauer events at the other end of the material which will have a statistically significant effect on a Mössbauer spectrum. The phonon bursts produced by …

Go to article

Interstitial Silicon Ions In Rutile Tio2 Crystals, Eric M. Golden, Nancy C. Giles, Shan Yang, Larry E. Halliburton Apr 2015

Interstitial Silicon Ions In Rutile Tio2 Crystals, Eric M. Golden, Nancy C. Giles, Shan Yang, Larry E. Halliburton

Faculty Publications

Electron paramagnetic resonance (EPR) is used to identify a new and unique photoactive silicon-related point defect in single crystals of rutile TiO2. The importance of this defect lies in its assignment to interstitial silicon ions and the unexpected establishment of silicon impurities as a major hole trap in TiO2. Principal g values of this new S=1/2 center are 1.9159, 1.9377, and 1.9668 with principal axes along the [¯110],[001], and [110] directions, respectively. Hyperfine structure in the EPR spectrum shows the unpaired spin interacting equally with two Ti nuclei and unequally with two Si nuclei. These silicon …

Go to article

Con-Resistant Trust For Improved Reliability In A Smart Grid Special Protection System, Crystal M. Shipman, Kenneth M. Hopkinson, Juan L. Lopez Jr. Feb 2015

Con-Resistant Trust For Improved Reliability In A Smart Grid Special Protection System, Crystal M. Shipman, Kenneth M. Hopkinson, Juan L. Lopez Jr.

Faculty Publications

This paper applies a con-resistant trust mechanism to improve the performance of a communications-based special protection system to enhance its effectiveness and resiliency. Smart grids incorporate modern information technologies to increase reliability and efficiency through better situational awareness. However, with the benefits of this new technology come the added risks associated with threats and vulnerabilities to the technology and to the critical infrastructure it supports. The research in this paper uses con-resistant trust to quickly identify malicious or malfunctioning (untrustworthy) protection system nodes to mitigate instabilities. The con-resistant trust mechanism allows protection system nodes to make trust assessments based on …

Go to article

Theoretical Investigation Of Stabilities And Optical Properties Of Si12C12 Clusters, Xiaofeng F. Duan, Larry W. Burggraf Jan 2015

Theoretical Investigation Of Stabilities And Optical Properties Of Si12C12 Clusters, Xiaofeng F. Duan, Larry W. Burggraf

Faculty Publications

By sorting through hundreds of globally stable Si12C12 isomers using a potential surface search and using simulated annealing, we have identified low-energy structures. Unlike isomers knit together by Si–C bonds, the lowest energy isomers have segregated carbon and silicon regions that maximize stronger C–C bonding. Positing that charge separation between the carbon and silicon regions would produce interesting optical absorption in these cluster molecules, we used time-dependent density functional theory to compare the calculated optical properties of four isomers representing structural classes having different types of silicon and carbon segregation regions. Absorptions involving charge transfer between segregated …

Go to article

Monolithic Optofluidic Ring Resonator Lasers Created By Femtosecond Laser Nanofabrication, Hengky Chandrahalim, Qiushu Chen, Ali A. Said, Mark Dugan, Xudong Fan Jan 2015

Monolithic Optofluidic Ring Resonator Lasers Created By Femtosecond Laser Nanofabrication, Hengky Chandrahalim, Qiushu Chen, Ali A. Said, Mark Dugan, Xudong Fan

Faculty Publications

We designed, fabricated, and characterized a monolithically integrated optofluidic ring resonator laser that is mechanically, thermally, and chemically robust. The entire device, including the ring resonator channel and sample delivery microfluidics, was created in a block of fused-silica glass using a 3-dimensional femtosecond laser writing process. The gain medium, composed of Rhodamine 6G (R6G) dissolved in quinoline, was flowed through the ring resonator. Lasing was achieved at a pump threshold of approximately 15 μJ/mm2. Detailed analysis shows that the Q-factor of the optofluidic ring resonator is 3.3 × 104, which is limited by both solvent …

Go to article

Reconfigurable Solid-State Dye-Doped Polymer Ring Resonator Lasers, Hengky Chandrahalim, Xudong Fan Jan 2015

Reconfigurable Solid-State Dye-Doped Polymer Ring Resonator Lasers, Hengky Chandrahalim, Xudong Fan

Faculty Publications

This paper presents wavelength configurable on-chip solid-state ring lasers fabricated by a single-mask standard lithography. The single- and coupled-ring resonator hosts were fabricated on a fused-silica wafer and filled with 3,3′-Diethyloxacarbocyanine iodide (CY3), Rhodamine 6G (R6G) and 3,3′-Diethylthiadicarbocyanine iodide (CY5)-doped polymer as the reconfigurable gain media. The recorded lasing threshold was ~220 nJ/mm2 per pulse for the single-ring resonator laser with R6G, marking the lowest threshold shown by solid-state dye-doped polymer lasers fabricated with a standard lithography process on a chip. A single-mode lasing from a coupled-ring resonator system with the lasing threshold of ~360 nJ/mm2 per pulse …

Go to article