Open Access. Powered by Scholars. Published by Universities.®

Physical Sciences and Mathematics Commons™

Open Access. Powered by Scholars. Published by Universities.®

Aerospace Engineering

2006

Articles 1 - 17 of 17

Full-Text Articles in Physical Sciences and Mathematics

Robust Control Techniques Enabling Duty Cycle Experiments Utilizing A 6-Dof Crewstation Motion Base, A Full Scale Combat Hybrid Electric Power System, And Long Distance Internet Communications, Marc Compere, Jarrett Goodell, Miguel Simon, Wilford Smith, Mark Brudnak Nov 2006

Robust Control Techniques Enabling Duty Cycle Experiments Utilizing A 6-Dof Crewstation Motion Base, A Full Scale Combat Hybrid Electric Power System, And Long Distance Internet Communications, Marc Compere, Jarrett Goodell, Miguel Simon, Wilford Smith, Mark Brudnak

Publications

The RemoteLink effort supports the U.S. Army's objective for developing and fielding next generation hybrid-electric combat vehicles. It is a distributed soldierin- the-Ioop and hardware-in-the-Ioop environment with a 6-DOF motion base for operator realism, a full-scale combat hybrid electric power system, and an operational context provided by OneSAF. The driver/gunner crewstations rest on one of two 6-DOF motion bases at the U.S. Army TARDEC Simulation Laboratory (TSL). The hybrid power system is located 2,450 miles away at the TARDEC Power and Energy System Integration Laboratory (P&E SIL). The primary technical challenge in the RemoteLink is to operate both laboratories together …

Go to article

Capillary-Driven Flows Along Rounded Interior Corners, Yongkang Chen, Mark M. Weislogel, Cory L. Nardin Nov 2006

Capillary-Driven Flows Along Rounded Interior Corners, Yongkang Chen, Mark M. Weislogel, Cory L. Nardin

Mechanical and Materials Engineering Faculty Publications and Presentations

The problem of low-gravity isothermal capillary flow along interior corners that are rounded is revisited analytically in this work. By careful selection of geometric length scales and through the introduction of a new geometric scaling parameter Tc, the Navier–Stokes equation is reduced to a convenient∼O(1) form for both analytic and numeric solutions for all values of corner half-angle α and corner roundedness ratio λ for perfectly wetting fluids. The scaling and analysis of the problem captures much of the intricate geometric dependence of the viscous resistance and significantly reduces the reliance on numerical data compared with several previous solution methods …

Go to article

Development And Testing Of A High-Speed Real-Time Kinematic Precise Dgps Positioning System Between Two Aircraft, Christopher J. Spinelli Sep 2006

Development And Testing Of A High-Speed Real-Time Kinematic Precise Dgps Positioning System Between Two Aircraft, Christopher J. Spinelli

Theses and Dissertations

This research involves the design, implementation, and testing of a high-speed, real-time kinematic, precise differential GPS positioning system for use in airborne applications such as automated aerial-refueling and close formation flying. Although many of the current ambiguity resolution techniques use the residuals from the least squares position estimation to determine the true ambiguity set, this thesis presents a novel approach to the ambiguity resolution problem, called the minimum indicator. Instead of assuming the ambiguity set with the lowest residuals is the true set, other special characteristics of the residuals are examined. This increases the confidence that the algorithm has selected …

Go to article

Characterizing A Co-Flow Nozzle For Use In A Filtered Rayleigh Scattering System, David S. Miceli Jun 2006

Characterizing A Co-Flow Nozzle For Use In A Filtered Rayleigh Scattering System, David S. Miceli

Theses and Dissertations

Research was conducted on the flow field exiting a co-annular flow nozzle for use in filtered Rayleigh scattering flow visualizations. More specifically, the flow visualizations were of the flow field exiting a coflow nozzle and illuminated by a tunable, nominal 4.2 watt narrow line width Argon laser operating at 514.5nm. ND:YAG lasers are typically used in this application, but some of the properties of a tunable Argon laser make it an attractive alternative. Before generating flow visualizations, the coflow nozzle was characterized both experimentally and computationally. Due to a flow asymmetry in the outer annulus flow field, the nozzle was …

Go to article

Development And Validation Of Reentry Simulation Using Matlab, Robert E. Jameson Jr. Jun 2006

Development And Validation Of Reentry Simulation Using Matlab, Robert E. Jameson Jr.

Theses and Dissertations

This research effort develops a program using MATLAB to solve the equations of motion for atmospheric reentry and analyzes the validity of the program for use as a tool to expeditiously predict reentry profiles. The reentry vehicle is modeled as a point mass with constant aerodynamic properties as defined by the user. The equations of motion for reentry are based on the two-body problem. The atmosphere is modeled as a single layer exponentially decreasing in density. The MATLAB program has the ability to derive the initial trajectory conditions from the position and velocity relative to the rotating surface of the …

Go to article

An Experimental Study Of A Pulsed Dc Plasma Flow Control Actuator, Jennifer D. Wall Jun 2006

An Experimental Study Of A Pulsed Dc Plasma Flow Control Actuator, Jennifer D. Wall

Theses and Dissertations

An experiment on the effects of a pulsed DC plasma actuator on a separated flow in a low speed wind tunnel was conducted. The actuator consisted of two asymmetric copper electrodes oriented normal to the flow separated by a dielectric barrier and mounted on a flat plate in the center of the tunnel. A contoured insert was constructed and used to create an adverse pressure gradient in the test section comparable to a Pak-B low pressure turbine blade distribution. Suction was applied from the upper wall to induce separation along the flat plate over the electrodes. The DC power supply …

Go to article

2nd Annual Undergraduate Research Conference Abstract Book, University Of Missouri--Rolla Apr 2006

2nd Annual Undergraduate Research Conference Abstract Book, University Of Missouri--Rolla

Undergraduate Research Conference at Missouri S&T

No abstract provided.

Go to article

Dynamics Of Nonlinear Diffusion Processes, Dustin A. Sipka Apr 2006

Dynamics Of Nonlinear Diffusion Processes, Dustin A. Sipka

Master's Theses - Daytona Beach

The purpose of this thesis is to analyze nonlinear diffusion processes. In particular, some of the results arrived at by Newman and Sagan in their 1981 paper "Galactic Civilizations: Population Dynamics and Interstellar Diffusion," will be reproduced by different means. First, a thorough analysis of the linear diffusion equation will be performed in order to test a numerical algorithm that can solve the nonlinear diffusion equation and look at the processes of interest with sufficient accuracy. Once the algorithm is tested and shows good resolution it is used to solve the nonlinear equation. The post processing is then done to …

Go to article

Assessing The Potential For Improved Scramjet Performance Through Application Of Electromagnetic Flow Control, Martin F. Lindsey Mar 2006

Assessing The Potential For Improved Scramjet Performance Through Application Of Electromagnetic Flow Control, Martin F. Lindsey

Theses and Dissertations

Hypersonic flight using scramjet propulsion bridges the gap between turbojets and rockets. Recent efforts focus on magnetogasdynamic (MGD) flow control to mitigate the problems of high thermomechanical loads and low efficiencies associated with scramjets. This research is the first flight-scale, three-dimensional computational analysis of a realistic scramjet to assess how MGD flow control improves scramjet performance. Developing a quasi-one dimensional design tool culminated in the first open source scramjet geometry. This geometry was tested with the Air Force Research Laboratory's electromagnetic computational code. To increase fidelity, an algorithm was developed to incorporate thermochemistry, resulting in the only open-source model of …

Go to article

Spatially-Resolved Temperature Diagnostic For Supersonic Flow Using Cross-Beam Doppler-Limited Laser Saturation Spectroscopy, Grady T. Phillips Mar 2006

Spatially-Resolved Temperature Diagnostic For Supersonic Flow Using Cross-Beam Doppler-Limited Laser Saturation Spectroscopy, Grady T. Phillips

Theses and Dissertations

Optical techniques for measuring the temperature in three-dimensional supersonic reactive flows have typically depended on lineshape measurements using single-beam laser absorption spectroscopy. However, absorption over extended path lengths in flows with symmetric, turbulent eddies can lead to systematically high extracted temperatures due to Doppler shifts resulting from flow along the absorption path. To eliminate these problems, Cross-Beam Saturation Absorption Spectroscopy (CBSAS) and Cross-Beam Inter-Modulated Fluorescence (CBIMF) have been developed which utilize two crossed and nearly copropogating laser beams.to record the spectral signal of an I2 ro-vibrational line in a small three-dimensional volume using a tunable CW dye laser. Temperature …

Go to article

Control Demonstration Of A Thin Deformable In-Plane Actuated Mirror, Gina A. Peterson Mar 2006

Control Demonstration Of A Thin Deformable In-Plane Actuated Mirror, Gina A. Peterson

Theses and Dissertations

Current imaging satellites are limited in resolution and coverage area by the aperture size of their primary optical mirror. To get a large optical mirror into space, current launch weight and size restrictions must be overcome. Membrane-like optical mirrors can overcome these restrictions with their very lightweight and flexible properties. However, thin, deformable membrane mirrors are very susceptible to the space environment and require active control for surface stabilization and shaping. The primary goal of this research is to demonstrate that an in-plane actuated membrane-like deformable optical mirror can be controlled to optical wavelength tolerances in a closed-loop system. Fabrication …

Go to article

A Comparison Of Main Rotor Smoothing Adjustments Using Linear And Neural Network Algorithms, Nathan A. Miller Mar 2006

A Comparison Of Main Rotor Smoothing Adjustments Using Linear And Neural Network Algorithms, Nathan A. Miller

Theses and Dissertations

Helicopter main rotor smoothing is a maintenance procedure that is routinely performed to minimize airframe vibrations induced by non-uniform mass and/or aerodynamic distributions in the main rotor system. This important task is both time consuming and expensive, so improvements to the process have long been sought. Traditionally, vibrations have been minimized by calculating adjustments based on an assumed linear relationship between adjustments and vibration response. In recent years, artificial neural networks have been trained to recognize non-linear mappings between adjustments and vibration response. This research was conducted in order observe the character of the adjustment mapping of the Vibration Management …

Go to article

Macroscopic Computational Model Of Dielectric Barrier Discharge Plasma Actuators, Timothy R. Klein Feb 2006

Macroscopic Computational Model Of Dielectric Barrier Discharge Plasma Actuators, Timothy R. Klein

Theses and Dissertations

Recent progress in the generation and sustainment of gas discharges at atmospheric pressure has energized research in the field of plasma-aerodynamics. Plasma actuators are promising devices that achieve flow control with no moving parts, do not alter the airfoil shape and place no parts in the flow. The operation of a plasma actuator is examined using a macroscopic (force and power addition) computational fluid dynamic model of a dielectric barrier discharge, DBD, in Fluent. A parametric approach is adopted to survey the range of requisite magnitudes of momentum and energy delivered to the flow field and to identify the effects …

Go to article

Variational Approach To The Volume Viscosity Of Fluids, Allan J. Zuckerwar, Robert L. Ash Jan 2006

Variational Approach To The Volume Viscosity Of Fluids, Allan J. Zuckerwar, Robert L. Ash

Mechanical & Aerospace Engineering Faculty Publications

The variational principle of Hamilton is applied to develop an analytical formulation to describe the volume viscosity in fluids. The procedure described here differs from those used in the past in that a dissipative process is represented by the chemical affinity and progress variable (sometimes called "order parameter") of a reacting species. These state variables appear in the variational integral in two places: first, in the expression for the internal energy, and second, in a subsidiary condition accounting for the conservation of the reacting species. As a result of the variational procedure, two dissipative terms appear in the Navier-Stokes equation. …

Go to article

An Internet Based Intelligent Argumentation System For Collaborative Engineering Design, Xiaoqing Frank Liu, Samir Raorane, Man Zheng, Ming-Chuan Leu Jan 2006

An Internet Based Intelligent Argumentation System For Collaborative Engineering Design, Xiaoqing Frank Liu, Samir Raorane, Man Zheng, Ming-Chuan Leu

Computer Science Faculty Research & Creative Works

Modern product design is a very complicated process which involves groups of designers, manufacturers, suppliers, and customer representatives. Conflicts are unavoidable in collaboration among multiple stakeholders, who have different objectives, requirements, and priorities. Unfortunately, current web-based collaborative engineering design systems do not support collaborative conflict resolution. In this paper, we will develop an intelligent computational argumentation model to enable management of a large scale argumentation network, and resolution of conflicts based on argumentation from many participants. A web-based intelligent argumentation tool is developed as a part of a web-based collaborative engineering design system based on the above model to resolve …

Go to article

Neural Network-Based Output Feedback Controller For Lean Operation Of Spark Ignition Engines, Brian C. Kaul, Jagannathan Sarangapani, J. A. Drallmeier, Jonathan B. Vance, Pingan He Jan 2006

Neural Network-Based Output Feedback Controller For Lean Operation Of Spark Ignition Engines, Brian C. Kaul, Jagannathan Sarangapani, J. A. Drallmeier, Jonathan B. Vance, Pingan He

Electrical and Computer Engineering Faculty Research & Creative Works

Spark ignition (SI) engines running at very lean conditions demonstrate significant nonlinear behavior by exhibiting cycle-to-cycle dispersion of heat release even though such operation can significantly reduce NOx emissions and improve fuel efficiency by as much as 5-10%. A suite of neural network (NN) controller without and with reinforcement learning employing output feedback has shown ability to reduce the nonlinear cyclic dispersion observed under lean operating conditions. The neural network controllers consists of three NN: a) A NN observer to estimate the states of the engine such as total fuel and air; b) a second NN for generating virtual input; …

Go to article

Response To "Comment On Variational Approach To The Volume Viscosity Of Fluids" [Phys. Fluids 18, 109101 (2006)], Allen J. Zuckerwar, Robert L. Ash Jan 2006

Response To "Comment On Variational Approach To The Volume Viscosity Of Fluids" [Phys. Fluids 18, 109101 (2006)], Allen J. Zuckerwar, Robert L. Ash

Mechanical & Aerospace Engineering Faculty Publications

We respond to the Comment of Markus Scholle and therewith revise our material entropy constraint to account for the production of entropy. (c) 2006 American Institute of Physics.

Go to article