Open Access. Powered by Scholars. Published by Universities.®

Other Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 2 of 2

Full-Text Articles in Other Engineering

Development Of Water Coning Control Design Metrics In Naturally Fractured Reservoirs, Samir Prasun Jun 2020

Development Of Water Coning Control Design Metrics In Naturally Fractured Reservoirs, Samir Prasun

LSU Doctoral Dissertations

Naturally fractured reservoirs (NFRs) with bottom-water are known for their instant water breakthrough and severe water coning that reduces oil recovery. This is because water channels through the highly permeable fractures easily connecting the well to the aquifer bypassing the oil contained in the matrix. Remedial techniques such as producing below critical-oil rate, optimizing the well spacing and installing the downhole water sink (DWS)/ downhole water loop (DWL) technology, have already been successfully tested in single-porosity reservoirs (SPR). However, applicability of these techniques in NFRs are unknown since only a few studies have been performed on their feasibility in NFRs, …


Mechanistic Modeling Of Nanoparticle-Stabilized Supercritical Co2 Foams And Its Implication In Field-Scale Eor Applications, Doris Patricia Ortiz Maestre Nov 2017

Mechanistic Modeling Of Nanoparticle-Stabilized Supercritical Co2 Foams And Its Implication In Field-Scale Eor Applications, Doris Patricia Ortiz Maestre

LSU Master's Theses

Previous experimental studies show that nanoparticle-stabilized supercritical CO2 foams (or, NP CO2 foams) can be applied as an alternative to surfactant foams, in order to reduce CO2 mobility in gas injection enhanced oil recovery (EOR). These nanoparticles, if chosen correctly, can be an effective foam stabilizer attached at the fluid interface in a wide range of physicochemical conditions.

By using NP CO2 foam experiments available in the literature, this study performs two tasks: (i) presenting how a mechanistic foam model can be used to fit experimental data and determine required model parameters, and (ii) investigating the …