Mining Engineering Commons^™

Comparing Distributed Acoustic Sensing To Three-Component Geophones In An Underground Mine, Nikolas Nesladek

Graduate Theses & Non-Theses

Geophones have become the industry standard for seismic data collection. However, a relatively new method is gaining popularity called Distributed Acoustic Sensing (DAS). DAS uses changes in backscattered light of a fiber-optic cable to detect strain from acoustic energy. The purpose of this project was to make a direct comparison between DAS and three component geophones, specifically in a mining setting. Experiments were done in the Underground Education Mining Center on the campus of Montana Tech. The sources used for this project were vertical sledgehammer shots, oriented shear sledgehammer shots, and blasting caps set off in both unstemmed and stemmed …

Responsiveness Of Mining Community Acceptance Model To Key Parameter Changes, Mark Kofi Boateng, Kwame Awuah-Offei

Mining Engineering Faculty Research & Creative Works

The mining industry has difficulties predicting changes in the level of community acceptance of its projects over time. These changes are due to changes in the society and individual perceptions around these mines as a result of the mines' environmental and social impacts. Agent-based modeling can be used to facilitate better understanding of how community acceptance changes with changing mine environmental impacts. This work investigates the sensitivity of an agent-based model (ABM) for predicting changes in community acceptance of a mining project due to information diffusion to key input parameters. Specifically, this study investigates the responsiveness of the ABM to …

Embrace The Unknown: Stop Saying “It’S Too Hard” And Start Embracing Uncertainty In Your Mine Plans, C. Roos

Mining Engineering

Nearly every input to a mine plan is based on an estimate. The estimates may be from sample data, historical information, models, or personal opinion, but in all cases, these values are simply expected values (means). In real life, we do not get to iterate the exact conditions at our mining operation many times to ensure that that average value is attained. The expected value also tells us nothing about the spread of values that that input might take on. The result is a significant amount of unquantified uncertainty in our mine plans. Unfortunately, it is often too expensive or …

Evaluation & Selection Of Novel Surveying Systems For Use In Surface Coal Mining, M. Drake, C. Roos, P. Conrad, T. Stack

Mining Engineering

This paper presents the evaluation Montana Tech completed for the Western Energy Company Rosebud Mine relating to the benefits of survey data collected using novel technologies over traditional methods for topographic surveys. These technologies include Unmanned Aircraft Systems (UAS), photogrammetry, and laser scanning/LIDAR. Utilizing these technologies, large areas such as reclamation areas and cast blasts can be surveyed in a timely manner for use by the mining operation. The areas that were evaluated were the improvements in the safety of employees and the time required to collect data. In addition, there is also a potential cost savings for the operation, …

Determine The Potential Drill Utilization Improvements And Rock Fragmentation Requirements Using Directional Drilling In A Coal Mining Overburden Highwall Application, K. D. Dill, S. D. Rosenthal

Mining Engineering

This project analyzed the efficiency of incorporating the use of directional drilling technology into coal overburden blasting. Directional drilling is currently in use in the petroleum industry and it is believed that it will be a valuable asset in the mining industry. This project has shown that directional drilling can be a viable technology for use in the coal overburden removal process resulting in increased drill utilization and potential for cost savings. Future work regarding blasting and geotechnical evaluation should be performed to solidify the concept.

Electromagnetic Signal Feedback Control For Proximity Detection Systems, Adam K. Smith

Dissertations, Master's Theses and Master's Reports

Coal is the most abundant fossil fuel in the United States and remains an essential source of energy. While more than half of coal production comes from surface mining, nearly twice as many workers are employed by underground operations.

One of the key pieces of equipment used in underground coal mining is the continuous mining machine. These large and powerful machines are operated in confined spaces by remote control. Since 1984, 40 mine workers in the U. S. have been killed when struck or pinned by a continuous mining machine. It is estimated that a majority of these accidents could …

The Andacollo's Mining Community: Ethnographic Work-Based Approach To Corporate Social Responsibility Policies And Practices, Ubirata De Oliveira

Walden Dissertations and Doctoral Studies

This ethnographic study was designed to explore the phenomenon of corporate social responsibility (CSR) in the mining industry. The research addressed the impacts of a problematic, systemic, and ethnocentric (top-down) CSR approach driven by a transnational mining company, and proposed a novel cultural relativist (bottom-up) CSR approach looking at the social needs of the community. Solving the problem stemming from the ethnocentric approach is important for both the mining company and the community affected by the CSR program, as it will alter dynamics between actors and mitigate social conflicts. The purpose of this study was to investigate factors that improve …