Engineering Commons^™

Integrative Physiology-Coupled Pilot-Centered Flight Simulation, Shawn C. Harrison

Electrical & Computer Engineering Theses & Dissertations

Maintaining the pilot’s physiological performance envelope within the limits of human capabilities may be crucial for avoiding hazardous physiological episodes in fighter aircraft that compromise safety. The main physiological episode of interest is impaired pilot respiration, better known as hypoxia caused by a high fraction of inspired oxygen (FiO₂) at high altitudes and variation in accelerative gravitational forces (g-forces). Integrated into fighter aircraft is an Onboard Oxygen Generating System (OBOGS) developed to mitigate the necessity of gaseous and liquid oxygen cannisters [1]. OBOGS act as a life support in hypoxic environments by providing oxygen-rich air, thereby oxygenating the …

Overcoming Supply Disruptions During Pandemics By Utilizing Found Hardware For Open Source Gentle Ventilation, S. Oberloier, N. Gallup, J. M. Pearce

Michigan Tech Publications

This article details the design of an open source emergency gentle ventilator (gentle-vent) framework that can be used in periods of scarcity. Although it is not a medical device, the system utilizes a wide range of commonly-available components that are combined using basic electronics skills to achieve the desired performance. The main function of the gentle-vent is to generate a calibrated pressure wave at the pump to provide support to the patient's breathing. Each gentle-vent permutation was tested using a DIY manometer as it would be utilized in the field in low-resource settings and validated with an open source VentMon. …

Nebulizer-Based Systems To Improve Pharmaceutical Aerosol Delivery To The Lungs, Benjamin M. Spence

Theses and Dissertations

Combining vibrating mesh nebulizers with additional new technologies leads to substantial improvements in pharmaceutical aerosol delivery to the lungs across therapeutic administration methods. In this dissertation, streamlined components, aerosol administration synchronization, and/or Excipient Enhanced Growth (EEG) technologies were utilized to develop and test several novel devices and aerosol delivery systems. The first focus of this work was to improve the poor delivery efficiency, e.g., 3.6% of nominal dose (Dugernier et al. 2017), of aerosolized medication administration to adult human subjects concurrent with high flow nasal cannula (HFNC) therapy, a form of continuous-flow non-invasive ventilation (NIV). The developed Low-Volume Mixer-Heater (LVMH) …

Ventilation And Recirculation Airway Design For An Autonomous, Climate Controlled, Hydroponic Demonstration Unit, Nicholas Cross

Biological and Agricultural Engineering Undergraduate Honors Theses

For this Honors Thesis project, I designed and fabricated a ventilation and recirculation airway sub-system prototype for a hydroponic demonstration unit to be used as an educational demonstration for prospective students, illustrating the capabilities of biological engineers. This thesis focuses on the design of an autonomous air system that toggles between ventilation and recirculation modes based upon sensor output. In the literature review I discuss how ventilation can be used to achieve a targeted climate, the benefits of hands-on projects for education, and the optimum parameters for growing herbs in a hydroponic system.

In the design and fabrication process, every …

Partially Reprapable Automated Open Source Bag Valve Mask-Based Ventilator, Aliaksei Petsiuk, Nagendra G. Tanikella, Samantha Dertinger, Adam Pringle, Shane Oberloier, Joshua M. Pearce

Michigan Tech Publications

This study describes the development of a simple and easy-to-build portable automated bag valve mask (BVM) compression system, which, during acute shortages and supply chain disruptions can serve as a temporary emergency ventilator. The resuscitation system is based on the Arduino controller with a real-time operating system installed on a largely RepRap 3-D printable parametric component-based structure. The cost of the materials for the system is under $170, which makes it affordable for replication by makers around the world. The device provides a controlled breathing mode with tidal volumes from 100 to 800 mL, breathing rates from 5 to 40 …

Reprapable Automated Open Source Bag Valve Mask-Based Ventilator, Aliaksei Petsiuk, Nagendra Gautam Tanikella, Samantha C. Dertinger, Adam Pringle, Shane Oberloier, Joshua M. Pearce

Michigan Tech Publications

This study describes the development of an automated bag valve mask (BVM) compression system, which, during acute shortages and supply chain disruptions can serve as a temporary emergency ventilator. The resuscitation system is based on the Arduino controller with a real-time operating system installed on a largely RepRap 3-D printable parametric component-based structure. The cost of the system is under $170, which makes it affordable for replication by makers around the world. The device provides a controlled breathing mode with tidal volumes from 100 to 800 milliliters, breathing rates from 5 to 40 breaths/minute, and inspiratory-to-expiratory ratio from 1:1 to …

Adaptive Closed-Loop Neuromorphic Controller For Use In Respiratory Pacing, Ricardo Siu

FIU Electronic Theses and Dissertations

Respiratory pacing can treat ventilatory insufficiency through electrical stimulation of the respiratory muscles, or the respective innervating nerves, to induce ventilation. It avoids some of the adverse effects associated with mechanical ventilation such as risk of diaphragm atrophy and lung damage. However, current respiratory pacing systems provide stimulation in an open-loop manner. This often requires users to undergo frequent tuning sessions with trained clinicians if the specified stimulation parameters are unable to induce sufficient ventilation in the presence of time-varying changes in muscle properties, chest biomechanics, and metabolic demand. Lack of adaptation to these changes may lead to complications arising …

Cuffed Pediatric Endotracheal Tubes, Jennifer Nutter, Emmanuela Oppong, Colleen Pouliot

Honors Theses

Endotracheal tubes (ET) are used to provide patients with an adequate airway when they are unable to breathe on their own. ET tubes can be used in emergency situations, surgical procedures, and on-floor intubations. The two main types of ET tubes are cuffed and uncuffed. Due to the fragile structure of a child's throat, uncuffed tubes are primarily used in pediatric patients. Uncuffed tubes can slip out of place resulting in air leakage and improper oxygenation. In contrast, cuffed ET tubes provide a proper seal to the airway and prevent against aspiration. The following work proposes an improved design for …

The Second Wind, Jacob Heiss, Logan Neidert

Williams Honors College, Honors Research Projects

The Second Wind device is a set of sensors and a data processing unit capable of recording data necessary to conduct a simplified version of a complex cardiopulmonary stress test (CPET). This data includes VO2, VCO2, ventilation, and pulse oximetry data. VO2 and VCO2 are the percent, by volume, of oxygen and carbon dioxide in the patient's breath, spirometry is the measure of air flow, and the pulse oximetry data includes heart rate (HR) and percent oxygen in the blood (SpO2). In addition, the device was designed to be portable, so this test could be run from patients’ homes or …

Computational Fluid Dynamics Model For Air Velocity Through A Poultry Transport Trailer In A Holding Shed, Christian Heymsfield

Graduate Theses and Dissertations

Broiler production in Arkansas was valued at over $3.6 billion in 2013 (University of Arkansas Division of Agriculture Cooperative Extension Service). Consequently, improvement in any phase of the production process can have significant economic impact and animal welfare implications. One area of concern for the poultry industry is thermal stress experienced by the birds after arrival at the processing plant and before they are taken in to be processed, during which time they are left to wait in holding sheds. Various cooling strategies exist to mitigate heat stress in holding sheds, but in most cases it is unlikely that they …

Small Animal Thermal Support Device: Thermoregulation System For Scireq Flexivent Chamber, Alexander Dickey, Ashkhan Hojati, Matthew James, Kathleen Vermillera

Capstone Design Expo Posters

During ventilation induced lung injury (VILI) experiments, anesthetized mice lose the ability to regulate their core body temperature. Without maintaining homeostasis, the experimental data may be compromised due to changes in the rodent’s internal functions. Traditional heating techniques utilize a water circulation heating system that is unable to fit inside flexiVent ventilator testing chambers. The objective of this project is to design and build an automatic thermoregulatory feedback system to regulate the core body temperature of a mouse inside individual testing chambers throughout the duration of the experiment. The project deliverables include a functioning prototype that achieves safe and effective …

Electroventilation, L A. Geddes, William D. Voorhees, Charles F. Babbs, J A. Deford

Weldon School of Biomedical Engineering Faculty Publications

Electroventilation is a term used to describe the production of inspiration by applying rhythmic bursts of short duration stimuli to extrathoracic electrodes to stimulate motor nerves to the inspiratory muscles. In the dog, the optimum site for the electrodes was found to be on the upper chest wall, bilaterally. The inspired volume increased with increasing current intensity. The maximum tidal volume attainable was about four times resting tidal volume. The ability of electroventilation to maintain arterial blood oxygen saturation without the production of cardiac arrhythmias was demonstrated in pentobarbital-anesthetized dogs. The technique has several potential applications and offers promise in …