Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Engineering
An Experimental Investigation On A Single Tubular Sofc For Renewable Energy Based Cogeneration System
Faculty of Engineering University of Malaya
Having negative impacts on environment and the scarcity of resources of conventional fossil fuels, fuel cell technology draws more attention as an alternative for providing the electrical energy in parallel with thermal energy. In this study, a single tubular solid oxide fuel cell (SOFC) with an electrolyte of Yttria-Stabilized Zirconia 8 mol% ceramic powder was experimentally investigated. The investigation illustrated the effects of three different fuel flow-rates (175 ml/min, 250 ml/min and 325 ml/min) and two operating temperatures (650 degrees C and 750 degrees C) on the output electrical and thermal powers. The highest electrical voltage (open circuit) and overall …
Too Enthusiastic To Care For Safety: Present Status And Recent Developments Of Nanosafety In Asean Countries
Faculty of Engineering University of Malaya
Nanotechnology has the prospect to vibrate the imagination of human being and has the ability to be used in almost every sector of human need. With its limitless potentials, there are many environmental, health and safety related concerns due to extremely ambivalent effects of nanoparticles. Studies revealed that nanoparticles can enter the human body through the lungs, intestinal tract, and skin. Therefore, the researchers and workers who handle nanoparticles and nanomaterials can theoretically and primarily be affected, whereas on the consumers this will have secondary effects. This paper aims at sharing and evaluating the investment scenario, present status and recent …
Comparative Kinetic Study Of Functionalized Carbon Nanotubes And Magnetic Biochar For Removal Of Cd2+ Ions From Wastewater
Faculty of Engineering University of Malaya
We did a comparative study between functionalized multiwall carbon nanotube (FMWCNTs), and magnetic biochar was carried out to determine the most efficient adsorbent to be employed in the Cd2+ ion removal. We optimized parameters such as agitation speed, contact time, pH and adsorbent dosage using design expert vrsion 6.08. The statistical analysis reveals that optimized condition for highest removal of Cd2+ are at pH 5.0, with dosage 1.0 g, agitation speed and contact time of 100 rpm and 90 minutes, respectively. For the initial concentration of 10mg/l, the removal efficiency of Cd2+ using FMWCNTs was 90% and and 82% of …