Open Access. Powered by Scholars. Published by Universities.®
- Discipline
- Institution
- Publication
- Publication Type
Articles 1 - 4 of 4
Full-Text Articles in Engineering
Real-Time Dynamically Feasible B-Spline Trajectory Generation For Unmanned Aircraft, David Lavae Christensen
Real-Time Dynamically Feasible B-Spline Trajectory Generation For Unmanned Aircraft, David Lavae Christensen
Theses and Dissertations
Onboard aircraft systems must frequently plan dynamically feasible paths or trajectories to safely and quickly reach their goal position. Optimized B-splines are promising because they can guarantee kinematic feasibility in a computationally efficient manner and can be applied to a variety of vehicle models. However, current B-spline solutions do not adequately constrain trajectories to the physical limitation of the vehicles they are planning for, or are often too conservative. Most are also limited to path smoothing or require pre-optimized timing parameters. This thesis develops a real-time B-spline optimization-based trajectory generator capable of minimizing time while respecting the velocity, acceleration, and …
Numerical Analysis Of A Multi-Stage Elastohydrodynamic Seal For Aircraft Engines, Md Wasif Hasan
Numerical Analysis Of A Multi-Stage Elastohydrodynamic Seal For Aircraft Engines, Md Wasif Hasan
Electronic Theses and Dissertations
At present, both governmental and private aviation enterprises are trying to develop aircraft that are swifter, more lightweight, and more cost-effective in order to maintain competitiveness on both the domestic and global stage. Continuous innovation and sustainability efforts are necessary to achieve advancements in aviation systems, such as fans, compressors, combustors, and turbines, as well as sub-systems, like engine seals. Advanced engine seals exhibit considerable potential in enhancing the engine's pressure ratio and cycle temperatures, leading to reduced engine weight, increased thrust, and improved fuel economy. In this study, a novel multistage seal idea has been proposed for the supercritical …
Effect Of Post-Cured Through Thickness Reinforcement On Disbonding Behavior In Skin-Stringer Configuration, Jimesh D. Bhagatji, Christopher Morris, Yogaraja Sridhar, Bodhisatwa Bhattacharjee, Krishnanand N. Kaipa, Oleksandr G. Kravchenko
Effect Of Post-Cured Through Thickness Reinforcement On Disbonding Behavior In Skin-Stringer Configuration, Jimesh D. Bhagatji, Christopher Morris, Yogaraja Sridhar, Bodhisatwa Bhattacharjee, Krishnanand N. Kaipa, Oleksandr G. Kravchenko
Mechanical & Aerospace Engineering Faculty Publications
An experimental investigation of interlaminar toughness for post-cured through-thickness reinforcement (PTTR) skin-stringer sub-element is presented. The improvement in the crack resistance capability of skin-stringer samples was shown through experimental testing and finite element analysis (FEA) modeling. The performance of PTTR was evaluated on a pristine and initial-disbond of the skin-stringer specimen. A macro-scale pin-spring modeling approach was employed in FEA using a non-linear spring to capture the pin failure under the mixed-mode load. The experimental results showed a 15.5% and 20.9% increase in strength for the pristine-PTTR and initial-disbond PTTR specimens, respectively. The modeling approach accurately represents the overall structural …
Comparative Analysis Of Aviation And Ground Transportation Safety Standards Applicable To The Integration Of Unmanned Aircraft Operations, Andrew Walker
International Journal of Aviation, Aeronautics, and Aerospace
This study performed a comparative analysis of SMS in both the aviation and ground transportation industries to identify any gaps that may impact aviation safety by incorporating UAS operations within the ground transportation industry. The study reviewed relevant literature and compared the FAA SMS and FMCSA SMC policy components. The study also compared the implementation of OSHA requirements within the aviation and ground transportation industries. After reviewing the relevant policy components, the study finds that differences in safety standards between the FAA SMA and FMCSA SMC would impact safety. The study recommends that the SMC incorporate process descriptions for SRM …