Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Thermal Conduction Simulation Based On Reconstruction Digital Rocks With Respect To Fractures, Haiyuan Yang, Li Zhang, Ronghe Liu, Xianli Wen, Yongfei Yang, Roohollah Askari, Et. Al.
Thermal Conduction Simulation Based On Reconstruction Digital Rocks With Respect To Fractures, Haiyuan Yang, Li Zhang, Ronghe Liu, Xianli Wen, Yongfei Yang, Roohollah Askari, Et. Al.
Michigan Tech Publications
Effective thermal conductivity (ETC), as a necessary parameter in the thermal properties of rock, is affected by the pore structure and the thermal conduction conditions. To evaluate the effect of fractures and saturated fluids on sandstone’s thermal conductivity, we simulated thermal conduction along three orthogonal (X, Y, and Z) directions under air- and water-saturated conditions on reconstructed digital rocks with different fractures. The results show that the temperature distribution is separated by the fracture. The significant difference between the thermal conductivities of solid and fluid is the primary factor influencing the temperature distribution, and the thermal conduction mainly depends on …
Preformed Partial Gel Injection Chased By Low-Salinity Waterflooding In Fractured Carbonate Cores, Ali K. Alhuraishawy, Baojun Bai, Mingzhen Wei, Abdullah Almansour
Preformed Partial Gel Injection Chased By Low-Salinity Waterflooding In Fractured Carbonate Cores, Ali K. Alhuraishawy, Baojun Bai, Mingzhen Wei, Abdullah Almansour
Geosciences and Geological and Petroleum Engineering Faculty Research & Creative Works
Fractures and oil-wet conditions significantly limit oil recovery in carbonate reservoirs. Gel treatment has been applied in injector wells to modify the prevailing reservoir streamlines and significantly reduce fracture permeability, whereas low-salinity waterflooding has been applied experimentally to modify rock wettability toward water-wet for improved oil recovery. However, both processes have limitations that cannot be resolved using a single method. The objective of this study was to test whether low-salinity water could enable gel particles to move deeply into fractures to efficiently increase oil recovery and control water production. A semitransparent fracture model of carbonate cores and acrylic plates was …
In Situ Mechanical Characterization Of The Mixed- Mode Fracture Strength Of The Cu/Si Interface For Tsv Structures, Chenglin Wu, Congjie Wei, Yanxiao Li
In Situ Mechanical Characterization Of The Mixed- Mode Fracture Strength Of The Cu/Si Interface For Tsv Structures, Chenglin Wu, Congjie Wei, Yanxiao Li
Civil, Architectural and Environmental Engineering Faculty Research & Creative Works
In situ nanoindentation experiments have been widely adopted to characterize material behaviors of microelectronic devices. This work introduces the latest developments of nanoindentation experiments in the characterization of nonlinear material properties of 3D integrated microelectronic devices using the through-silicon via (TSV) technique. The elastic, plastic, and interfacial fracture behavior of the copper via and matrix via interface were characterized using small-scale specimens prepared with a focused ion beam (FIB) and nanoindentation experiments. A brittle interfacial fracture was found at the Cu/Si interface under mixed-mode loading with a phase angle ranging from 16.7° to 83.7°. The mixed-mode fracture strengths were extracted …