Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Engineering
Structural Identification And Assessment Of The Inverted Tee Girder Bridge System, Garrett P. Martindale
Structural Identification And Assessment Of The Inverted Tee Girder Bridge System, Garrett P. Martindale
Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research
The Inverted Tee (IT) girder bridge system was originally developed in 1996 by the University of Nebraska–Lincoln (UNL) and Nebraska Department of Roads (NDOR) engineers. This bridge system currently accounts for over 110 bridges in Nebraska used for both state highways and local county roads. Excessive transverse and longitudinal deck cracking has been observed and noted in numerous bridge inspection reports. Since the IT girder bridge system is relatively new, limited data and knowledge exist on its structural performance and behavior. This study evaluates the IT girder bridge system by conducting twenty field observations as well as recording accelerometer time …
Investigation Of Rapid Remote Sensing Techniques For Forensic Wind Analyses, Yijun Liao, Richard L. Wood, Mohammad Ebrahim Mohammadi, Peter J. Hughes, J. Arn Womble
Investigation Of Rapid Remote Sensing Techniques For Forensic Wind Analyses, Yijun Liao, Richard L. Wood, Mohammad Ebrahim Mohammadi, Peter J. Hughes, J. Arn Womble
Department of Civil and Environmental Engineering: Faculty Publications
Perishable damage data resulting from severe windstorms require efficient and rapid field collection techniques. Such datasets permit forensic damage investigations and characterization of civil infrastructure. Ultimately, observed structural damage serves as a proxy approach to estimate wind speeds for storms that include hurricanes, tornadoes, straight-line winds, etc. One of the more common methods to collect, preserve, and reconstruct three-dimensional damage scenes is the use of an unmanned aerial system (UAS), commonly known as a drone. Onboard photographic payloads permit scene reconstruction via structure-from-motion; however, such approaches often require direct site access and survey points for accurate results, which limit its …
Behavior Of Cold-Formed Steel Metal Industrial Buildings, Adrianna M. Early, Mohammad Ebrahim Mohammadi, Richard L. Wood, Kara D. Peterma
Behavior Of Cold-Formed Steel Metal Industrial Buildings, Adrianna M. Early, Mohammad Ebrahim Mohammadi, Richard L. Wood, Kara D. Peterma
Department of Civil and Environmental Engineering: Faculty Publications
This paper presents research focused on understanding the observed behavior of cold-formed steel (CFS) metal buildings during Hurricane Harvey, which made landfall Friday, August 25, 2017 between Port Aransas and Port O’Connor, Texas. Through the Geotechnical Extreme Event Reconnaissance (GEER) association (funded by the National Science Foundation) a team of structural engineers and researchers performed rapid and detailed assessments of structural damage caused by the hurricane. The National Science Foundation gathered photographs, damage assessments sheets, and three-dimensional laser point cloud data of severely damaged cold-formed steel industrial buildings. The Port Aransas County Airport experienced severe damage to several cold-formed steel …
Post-Earthquake Structural Damage Assessment Through Point Cloud Data, Mohammad Ebrahim Mohammadi, Richard L. Wood
Post-Earthquake Structural Damage Assessment Through Point Cloud Data, Mohammad Ebrahim Mohammadi, Richard L. Wood
Department of Civil and Environmental Engineering: Faculty Publications
Structural damage assessment following an extreme event can provide valuable information and insight into unanticipated damage and failure modes to improve design philosophies and design codes as well as reduce vulnerability. Oftentimes, structural engineers create finite element models (FEM) of the structure in which numerous model parameters require calibration to simulate the current state. This information may include structural plan details (geometry), material characteristics (strength and stiffness parameters), as well as observed damage patterns (cracks, spalling, etc.). Ground-based lidar (GBL) scans and Structure-from-Motion (SfM) can rapidly capture dimensionally accurate point clouds of the structure or facility of interest. Furthermore, point …