Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 5 of 5

Full-Text Articles in Engineering

Integration Of Sel Relays To Provide Motor, Transmission Line, And Transformer Protection, Christopher Ewing, Bryce Keefer Jun 2016

Integration Of Sel Relays To Provide Motor, Transmission Line, And Transformer Protection, Christopher Ewing, Bryce Keefer

Electrical Engineering

The objective of this project is to familiarize the performers with the principles of operation of the Schweitzer Engineering Laboratories (SEL) protective relays in both normal and fault conditions. The SEL-587, SEL-311L and SEL-710 microprocessor-based relays are used to provide protection for a system composed of transformers, simulated transmission lines and a 3-phase induction motor. Each of these relays provides protection by sending a trip signal to local breakers upon sensing a fault condition. The SEL-587 provides overcurrent and differential protection for a 3-phase transformer, while the SEL-311L provides differential and distance protection for a transmission line, and negative sequence. …


Automatic Water Pump Controller, Alam D. Salguero, Kyle Russell Marquez Weeks Jun 2016

Automatic Water Pump Controller, Alam D. Salguero, Kyle Russell Marquez Weeks

Electrical Engineering

In countries including Indonesia, Mexico, Guatemala, and El Salvador, a city water authority supplies the clean water and pumps it into large ground-level storage tanks. A resident’s water pump then pumps the water to a water tank on top of his/her house. When the water level in the ground-level storage tank becomes too low, the pump siphons air and shuts down, requiring a resident to manually prime the water pump to get it running again. Residents struggle to monitor the water level of the tanks effectively and keep the pump running properly. To remedy the issue, the Automatic Water Pump …


Implementation Of New System For Oxygen Generation And Carbon Dioxide Removal, Angelo Peter Karavolos Jan 2016

Implementation Of New System For Oxygen Generation And Carbon Dioxide Removal, Angelo Peter Karavolos

Open Access Theses & Dissertations

This research effort develops an integrated system for CO2 removal and O2 production. A unique material, dodeca-tungsto-phosphoric acid (H3PO4W12O3; henceforth referred to as DTPA) is mixed with tetra-ethyl-ortho-silicate Si(OC2H5)4 or TEOS. This mixture exhibits unique properties of heat absorption and high electrical conductivity. In the system described herein, the DTPA resides within a cross linked arrangement of TEOS. The DTPA furnishes a source of O2, while the TEOS furnishes structural support for the large DTPA crystals. In addition, the large amount of H2O within the crystal also adsorbs CO2. It can also be cross-linked with other polymers such as polycarbonate, …


Solar Photovoltaic System Control Topology Investigation For Power Source Mismatch, Lynette O'Callaghan Jan 2016

Solar Photovoltaic System Control Topology Investigation For Power Source Mismatch, Lynette O'Callaghan

Conference papers

An investigation into solar photovoltaic (PV) system control topology selection, when partial shade is anticipated in the solar array, is presented. As available area is maximised in Building Integrated PV (BIPV) systems, shading is an inevitable consequence. The presence of partial shading in a PV array leads to multiple power peaks in the power-voltage curve, due to bypass diode sections being triggered, and an increase in module mismatch losses in the array. A building energy design software, Integrated Environmental Solutions, is used to determine the shadowed area on PV modules throughout the year, incorporating the PV system location and geometrical …


Titan Wireless Camera Control System, Matthew J. Trowbridge, Ian Drake, Samuel Davis, Ognjen Krco Jan 2016

Titan Wireless Camera Control System, Matthew J. Trowbridge, Ian Drake, Samuel Davis, Ognjen Krco

Williams Honors College, Honors Research Projects

The Titan Camera Control System is an eletromechanical device that allows the user to wirelessly control a camera’s digital operations as well as physical orientation through the use of a mobile device application. The Titan system accepts input in the form of virtual user commands on the mobile app and performs system output in the form of sending photos/video from the camera back to the app as well as changing the orientation of the camera in accordance with the user’s commands.