Engineering Commons^™

Synthesis, Structural, Optical And Mechanical Characterization Of Srb2O4 Nanorods, Rui Li, Lihong Bao, Xiaodong Li

Faculty Publications

Single crystalline strontium borate (SrB₂O₄) nanorods were synthesized for the first time via a facile sol–gel route at low temperature. The SrB₂O₄ nanorods have a good crystalline nature with the growth direction along the [511] orientation and they are transparent from the ultraviolet to the visible regimes. Nanoscale three-point bending tests were performed directly on individual nanorods to probe their mechanical properties using an atomic force microscope. The elastic modulus of SrB₂O₄ nanorods was measured to be 158.2 ± 2.8 GPa, exhibiting a significant increase compared with other borate nanostructures …

Measuring The Nanoindentation Properties Of Alendronate-Time Treated Canine Cortical, Folorunso Ashaolu

Master's Theses

This study examines the nanoindentation (energy inclusive) properties of 0.2 mg/kg alendronate treated ribs at one and three years against a vehicle treated control in a fresh-frozen, non-cold-mounted, condition. This was to verify if the tissue-level properties for 0.2 ALN treated beagles would increase because of an increased level of mineralization despite a microdamage increase.

A total of twelve (12) skeletally mature (1–2 years old) female beagle dogs were treated daily for three years and one year with oral doses of vehicle (VEH, 1 mL/kg saline) or alendronate (ALN, 0.2 Merck, Rahway, NJ). The 0.2 mg dose corresponds, on a …

Low Cycle Fatigue Behavior Of Concrete With Recycled Concrete Aggregates, Paul Mark Gordon

Master's Theses

A comparison of concrete containing recycled concrete coarse aggregates and natural coarse aggregates subjected to high strain, low cycle compressive fatigue is presented. Using a strain based feedback control loop, concrete cylinders are compressed at 15µε/s to a specified strain then unloaded to zero stress for 10 cycles. After cycling, all samples are loaded to a strain of 0.008. Direct concrete material variables are the water to cement (w/c) ratio, taken as 0.60, 0.45, and 0.39, and percent coarse recycled concrete aggregate content, varied from zero to 100 percent. The primary testing variable is the specified unloading strain. Unloading strains …

Polydimethylsiloxane Mechanical Properties Measured By Macroscopic Compression And Nanoindentation Techniques, Zhixin Wang

USF Tampa Graduate Theses and Dissertations

In this thesis, the relationship between the elastic modulus of PDMS and the base/agent ratio (the amount of crosslinking) is studied. Reliable macroscopic compression test instrument was developed. Preload method was applied for the nanoindentation flat punch test to develop full contact.

In chapter 2, an easy instrument setup for macroscopic compression test is described. A series of PDMS samples with different base/agent ratios were tested using the macroscopic compression method. The relationship between PDMS elastic modulus and its base/agent ratio was established.

In chapter 3, PDMS nanoindentation DMA tests provide stable data with different test control models. The storage …

Ultrasound Elasticity Measurements As A Predictor For Arteriovenous Fistula Maturation, Anna Sorace

All ETDs from UAB

This research thesis examines the applicability of using ultrasound imaging to quantify arterial elasticity and assess potential of arteriovenous fistula maturation in chronic kidney disease (CKD) patients. Tissue-specific abnormalities have proven useful for identifying disease states within oncology, cardiovascular and musculoskeletal system. Using ultrasound-based imaging to evaluate arterial elasticity is a noninvasive and novel technique. It has the potential to contribute further insight into chronic kidney disease fistula failure and become a noninvasive prognostic indicator. Reliable vascular access is critical for delivery of adequate hemodialysis treatment to CKD patients and to maintain long-term connections for dialysis. An arteriovenous fistula is …