Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 3 of 3

Full-Text Articles in Engineering

Methodology To Convert A Transportation Planning Origin-Destination Matrix Into A Microscopic Traffic Simulation Origin-Destination Matrix, Jose Osiris Vidana-Bencomo Jan 2011

Methodology To Convert A Transportation Planning Origin-Destination Matrix Into A Microscopic Traffic Simulation Origin-Destination Matrix, Jose Osiris Vidana-Bencomo

Open Access Theses & Dissertations

Microscopic traffic simulation (MTS) is a cost-effective approach for the evaluation of traffic conditions in urban highways networks. In MTS models, traffic demand that is entered into the network is specified by one or several Origin-Destination (O-D) matrices. A major challenge in the application of MTS for large urban networks is the specification of the O-D matrices. This dissertation proposes a methodology that may be used to transform a O-D matrix from a transportation planning model (which is based on Traffic Analysis Zone, or TAZ, and is readily available) into a O-D matrix for a MTS model (which is traffic …


Strategies To Improve And Preserve Flexible Pavements At Intersections, Imad N. Abdallah Jan 2011

Strategies To Improve And Preserve Flexible Pavements At Intersections, Imad N. Abdallah

Open Access Theses & Dissertations

Many rural intersections originally constructed with thin untreated flexible base and hot mix or a two-course surface treatment experience severe pushing, shoving and rutting. These failures cause an extremely rough surface that can cause damage to small vehicles and potentially cause motorists to lose control of their vehicle. These distresses almost always result in complete failure of the existing pavement that must be repaired several times during the life of the roadway by maintenance forces. Pavement sections constructed with the same materials adjacent to the intersection perform adequately until the approach (approximately 150 ft in advance) of the intersection and …


Evaluation And Recommendation Of Mix Design For Emulsion Stabilized Bases, Samuel Franco Jan 2011

Evaluation And Recommendation Of Mix Design For Emulsion Stabilized Bases, Samuel Franco

Open Access Theses & Dissertations

Asphalt emulsion has been used for base material stabilization in a few TxDOT districts. Results from these practices were quite different. The initial performance of two projects on US287 constructed around 2000 in the Amarillo District has been found to be satisfactory. However, the Yoakum District has reported problems with asphalt emulsion for base work in a project on FM 237. The preliminary conclusion from these trials has been that asphalt emulsion may not perform well in the high humidity/high rainfall areas like east Texas. On the other hand, using calcium-based additives to stabilize base courses in road construction has …