Engineering Commons^™

Simulating Flood Control In Progress Village, Florida Using Storm Water Management Model (Swmm), Azize Minaz

USF Tampa Graduate Theses and Dissertations

Flooding is a natural event caused by heavy rains, melting snow, high tides, and anthropogenic impacts such as channel clogging, improper land use, and deforestation. In this study, the strategies for controlling flooding seek to establish flood prevention systems by implementing grey infrastructure and green infrastructure practices. The main objective of this thesis is to analyze the study area, Progress Village Neighborhood in Delaney Creek Watershed, regarding flood risk and flood mitigation techniques. The analysis was performed using EPA SWMM 5.1 and Arcmap 10.7.1. The study used design storms,10-years 24 hours and 25-years 24 hours, to analyze flood risk in …

Testing And Packaging For Mems Acoustic Emission Sensors, Ting-Hung Liu

USF Tampa Graduate Theses and Dissertations

The goal of this research is to improve the structure and dimension of the MEMS acoustic emission sensor. Acoustic emission sensor (AE sensor) based on the piezoelectric transducer is a well-developed technology in non-destructive testing that is widely used to determine permanent damage such as cracks and corrosions in buildings and structures. The AE sensor can be used to monitor cracks in structures and to check leakage in pressurized systems. The location of cracks in a structure or system leakage causes a high-frequency surface vibration while releasing ultrasonic energy. The frequency of this energy is typically between 30 kHz to …

Development Mems Acoustic Emission Sensors, Adrian Enrique Avila Gomez

USF Tampa Graduate Theses and Dissertations

The purpose of this research is to develop MEMS based acoustic emission sensors for structural health monitoring. Acoustic emission (AE) is a well-established nondestructive testing technique that is typically used to monitor for fatigue cracks in structures, leaks in pressurized systems, damages in composite materials or impacts. This technology can offer a precise evaluation of structural conditions and allow identification of imminent failures or minor failures that can be addressed by planned maintenances routines. AE causes a burst of ultrasonic energy that is measured as high frequency surface vibrations (30 kHz to 1 MHz) generated by transient elastic waves that …

High Performance Digitally Manufactured Microwave And Millimeter-Wave Circuits And Antennas, Eduardo A. Rojas

USF Tampa Graduate Theses and Dissertations

The potential of Additive Manufacturing (AM) for microwave and mm-wave applications is increasingly being revealed thanks to recent advancements in research. AM empowers engineers with new capabilities to manufacture complex conformal geometries quicker and at lower costs. It allows, for instance, the embedding of RF front ends into functional structures. In this dissertation, two aspects of AM are explored: (a) The development and characterization of techniques that improve the performance of AM microwave circuits and antennas, and (b) study of complex geometries, such as meshed structures, as an alternative to reduce material usage, cost, and weight of the components.

Micro-dispensing …

Enhancement Of Supercapacitor Energy Storage By Leakage Reduction And Electrode Modification, Tete Tevi

USF Tampa Graduate Theses and Dissertations

Supercapacitors have emerged in recent years as a promising energy storage technology. The main mechanism of energy storage is based on electrostatic separation of charges in a region at the electrode-electrolyte interface called double layer. Various electrode materials including carbon and conducting polymers have been used in supercapacitors. Also, supercapacitors offer high life cycle and high power density among electrochemical energy storage devices. Despite their interesting features, supercapacitors present some disadvantages that limit their competitivity with other storage devices in some applications. One of those drawbacks is high self-discharge or leakage. The leakage occurs when electrons cross the double layer …

Self-Assembly Kinetics Of Microscale Components: A Parametric Evaluation, Jose Miguel Carballo

USF Tampa Graduate Theses and Dissertations

The goal of the present work is to develop, and evaluate a parametric model of a basic microscale Self-Assembly (SA) interaction that provides scaling predictions of process rates as a function of key process variables. At the microscale, assembly by “grasp and release” is generally challenging. Recent research efforts have proposed adapting nanoscale self-assembly (SA) processes to the microscale. SA offers the potential for reduced equipment cost and increased throughput by harnessing attractive forces (most commonly, capillary) to spontaneously assemble components. However, there are challenges for implementing microscale SA as a commercial process. The existing lack of design tools prevents …

Forecasting Corrosion Of Steel In Concrete Introducing Chloride Threshold Dependence On Steel Potential, Andrea Nathalie Sanchez

USF Tampa Graduate Theses and Dissertations

Corrosion initiates in reinforced concrete structures exposed to marine environments when the chloride ion concentration at the surface of an embedded steel reinforcing bar exceeds the chloride corrosion threshold (CT) value. The value of CT is generally assumed to have a conservative fixed value ranging from 0.2% to - 0.5 % of chloride ions by weight of cement. However, extensive experimental investigations confirmed that CT is not a fixed value and that the value of CT depends on many variables. Among those, the potential of passive steel embedded in concrete is a key influential factor on the value of CT …

Effect Of Cement Chemistry And Properties On Activation Energy, Andre J. Bien-Aime

USF Tampa Graduate Theses and Dissertations

The objective of this work is to examine the effect of cement chemistry and physical properties on activation energy. Research efforts indicated that time dependent concrete properties such as strength, heat evolution, and thermal cracking are predictable through the concept of activation energy. Equivalent age concept, which uses the activation energy is key to such predictions. Furthermore, research has shown that Portland cement concrete properties are affected by particles size distribution, Blaine fineness, mineralogy and chemical composition. In this study, four Portland cements were used to evaluate different methods of activation energy determination based on strength and heat of hydration …

Packet Coalescing And Server Substitution For Energy-Proportional Operation Of Network Links And Data Servers, Mehrgan Mostowfi

USF Tampa Graduate Theses and Dissertations

Electricity generation for Information and Communications Technology (ICT) contributes over 2% of the human-generated CO2 to the atmosphere. Energy costs are rapidly becoming the major operational expense for ICT and may soon dwarf capital expenses as software and hardware continue to drop in price. In this dissertation, three new approaches to achieving energy-proportional operation of network links and data servers are explored.

Ethernet is the dominant wireline communications technology for Internet connectivity. IEEE 802.3az Energy Efficient Ethernet (EEE) describes a Low Power Idle (LPI) mechanism for allowing Ethernet links to sleep. A method of coalescing packets to consolidate link idle …

Investigation Of Mercury Use, Release, Deposition, And Exposures In The Tampa Bay Area, Ryan Algernon Michael

USF Tampa Graduate Theses and Dissertations

I investigate the links between mercury use, release, deposition, and population exposure in Tampa Bay, with the focus of identifying levers for reducing population mercury exposures. To achieve this, I investigated the trends in mercury use and release by products and processes in the Tampa Bay area using a Material Flow Analysis. Analysis of USEPA National Emissions Inventory data over time (1999 - 2008) identified relevant air source emission categories, and explored and compared state and regional trends in mercury emissions. To understand source contributions to wet deposited mercury in the Tampa Bay area, I analyzed trends in mercury deposition …

Development Of Catalytic Technology For Producing Sustainable Energy, Syed Ali Z Gardezi

USF Tampa Graduate Theses and Dissertations

This dissertation explores catalyst technology for the production of renewable liquid fuels via thermo-chemical conversion of biomass derived syngas. Fischer-Tropsch synthesis is a process for converting syngas, i.e. a mixture of CO and H2, into energy rich long chain hydrocarbons and oxygenated compounds. This synthesis process involves a number of elementary reactions leading to an array of polymeric products. The economic operation of an FTS process lie in the interplay of both catalyst and reactor design. In relation to catalysis, the nature of chemisorbed species, and the fractional availability of active metal sites determines rate, conversion and yield. Similarly, reactor …

Effect Of Localized Corrosion Of Steel On Chloride-Induced Concrete Cover Cracking In Reinforced Concrete Structures, Ezeddin Rafaa Busba

USF Tampa Graduate Theses and Dissertations

Abstract: Concrete cover cracking due to reinforcement corrosion is widely accepted as a limit-state indicator in defining the end of functional service life for existing reinforced concrete (RC) structures undergoing corrosion. Many of the currently available durability prediction models are incapable of providing realistic estimates of remaining service lives of RC structures beyond the corrosion initiation point. Therefore, the need to incorporate the length of the corrosion propagation stage in a comprehensive durability prediction approach has recently received much research attention. Previous research focus however was mostly limited to the case of uniformly corroding reinforcement with only few studies addressing …

Design Of Contact Line Friction Measurement Machine Apparatus, Seyed Kamran Najafi

USF Tampa Graduate Theses and Dissertations

The purpose of this project is to design and manufacture a high precision machine to directly measure the surface force of fluids. Knowing how to move droplets easier with less resistance can increase the potential of a wide range of applications and improve the performance of things such as self-assembly applications. This machine has the ability to measure forces of up to 100 N with a MEMS based sensor. The motion system on this machine moves a substrate underneath of a droplet for 100 mm and applies dragging force to the sensor. It moves with a controlled speed with high …

Use Of Innovative Computer Technology And Optical Texture Properties In The Analysis Of Pavement Digital Images, Saumya Priyadari Amarasiri

USF Tampa Graduate Theses and Dissertations

Digital image based automated pavement crack detection and classification technology has seen vast improvements in the recent years. In spite of these developments, although pavement crack lengths and widths can be evaluated using state-of-the-art software with a reasonable accuracy, no reported evidence is found in extending this technology to evaluate crack depths. Hence a preliminary study was carried out to model the digital image formation of cracked concrete pavements based on the Bidirectional Reflection Distribution Function. It was revealed that a definitive theoretical relationship exists among the crack widths and depths and the maximum pixel intensity contrasts in the images …

Gate Level Dynamic Energy Estimation In Asynchronous Circuits Using Petri Nets, Ryan Mabry

USF Tampa Graduate Theses and Dissertations

This thesis introduces a new methodology for energy estimation in asynchronous circuits. Unlike existing probabilistic methods, this is the first simulative work for energy estimation in all types of asynchronous circuits.

The new simulative methodology is based on Petri net modeling. A real delay model is incorporated to capture both gate delays and interconnect delays. The switching activity at each gate is captured to measure the average dynamic energy consumed per request/acknowledge handshaking pair. The new type of Petri net is called Hierarchical Colored Asynchronous Hardware Petri net (HCAHPN). The HCAHPN is able to capture the temporal and spatial correlations …