Engineering Commons^™

Cfd Analysis For Beyond Bubbly Gas-Liquid Two-Phase Flows In A Large Diameter Pipe, Sungje Hong

Doctoral Dissertations

"Due to the complexity of multiphase flow phenomena, numerical analysis for multiphase turbulent flow is not as reliable as single-phase computational fluid dynamics (CFD). A literature review has revealed that the current efforts on multiphase flow simulation have focused on small diameter channels under very restricted flow conditions and have been conducted without identifying some important procedures. To expand CFD applications to a wide range of two-phase flow conditions in large diameter channels, this study aims to validate the current CFD models for vertical concurrent air-water two-phase flow simulations beyond bubbly flows. First, a numerical model developed to describe dynamical …

Comparison Of Reynolds-Averaged Navier-Stokes Turbulence Models For Simulating Boundary Layers In Hypersonic Flows, Jorge-Valentino Kurose Bretzke

Masters Theses

“This study describes the use of Computational Fluid Dynamics (CFD) codes to simulate hypersonic boundary layers using several different turbulent closure models and comparing Reynolds-Averaged Navier-Stokes (RANS) simulations against Direct Numerical Simulations (DNS) of similar test cases. The test cases in this study consist of a flat plate in a Mach 8 freestream with a zero pressure gradient and wall recovery ratio of 0.48, as well as a Mach 8 axisymmetric nozzle also with a cold wall. The RANS models used in this study are the Spalart-Allmaras model, Baldwin-Lomax model, Menter K-Omega Baseline and Menter K-Omega Shear Stress Transport models. …

Magnetic Control Of Transport Of Particles And Droplets In Low Reynolds Number Shear Flows, Jie Zhang

Doctoral Dissertations

“Magnetic particles and droplets have been used in a wide range applications including biomedicine, biological analysis and chemical reaction. The manipulation of magnetic microparticles or microdroplets in microscale fluid environments is one of the most critical processes in the systems and platforms based on microfluidic technology. The conventional methods are based on magnetic forces to manipulate magnetic particles or droplets in a viscous fluid.

In contrast to conventional magnetic separation method, several recent experimental and theoretical studies have demonstrated a different way to manipulate magnetic non-spherical particles by using a uniform magnetic field in the microchannel. However, the fundamental mechanism …

The Effects Of Low Aspect Ratio And Heat Exchanging Internals On The Bubble Properties And Flow Regime In A Pilot-Plant Bubble/Slurry Bubble Column For Fischer-Tropsch Synthesis, Hayder Al-Naseri

Doctoral Dissertations

"Fischer-Tropsch synthesis (F-T) is a process utilized to convert the syngas mixture of CO and H₂ to synthetic fuel and chemicals that executed commercially by using the bubble/slurry bubble column reactor. The experimental results reveal that the investigated parameters, in terms the presence of internals, and reducing the aspect ratio and the solids loading, increase the local gas holdup, interfacial area, bubble passage frequency, and decrease the bubble rise velocity, bubble chord length. Meanwhile, the aspect ratio H/D = 4, and 5 provide enough height to established the fully developed flow regime. As a result of the variation in …

Hydrodynamics Related Performance Evaluation Of Upflow Moving Bed Hydrotreater Reactor (Mbr) Using Developed Experimental Methods And Cfd Simulation, Vineet Alexander

Doctoral Dissertations

"Upflow Moving Bed Hydrotreater (MBR) reactor is used for hydrotreating resid crude oil. It is a two-phase upflow reactor having a catalyst bed with conical bottom, and plena. At industrial conditions the reactor is not performing at its best and encountering issues such as hot spots, catalyst agglomeration inside the catalyst bed leading to frequent shutdown of the reactor. The root cause of these problems are linked to the improper hydrodynamics inside the catalyst bed. To investigate this, the industrial scale MBR is scaled down to a pilot scale and indicative and key hydrodynamic parameters are investigated using developed experimental …

Design And Analysis Of An Axisymmetric Aerospike Supersonic Micro-Nozzle For A Refrigerant-Based Cold-Gas Propulsion System For Small Satellites, Abdalla Ali Bani

Masters Theses

"The cold-gas propulsion system being developed by M-SAT requires improvements to its original nozzle design. This study documents the research, design, and analysis of a supersonic plug nozzle concept that could be integrated to the refrigerant-based cold-gas propulsion system to possibly improve its performance. As documented in this thesis, CFD analysis showed that the outlined nozzle design method resulted in a feasible nozzle concept that has the ability to out-perform a conventional nozzle of the same area ratio. The flow-fields and thrust of the aerospike nozzle, for the full and truncated nozzles, were investigated. The purpose of this study is …

Analysis Of A Ventilation Network In A Multiple Fans Limestone Mine, Ali Haghighat

Masters Theses

"As mining progresses the total resistance of an excavation is increased, the mine characteristic curve becomes steeper, and the operating point moves up the fan curve, reducing the total air quantity and increasing the system pressure. For multi-level ventilation networks with a number of fans the process can be tedious, and on a count of numerous dependent factors the optimal combination of fans is very hard to be achieved. The design of a ventilation network in conjunction with multi surface fans and booster fans entails a complex procedure.

The objective of this study is to provide a plan to improve …