Engineering Commons^™

Nanostructured Thin Film Synthesis By Aerosol Chemical Vapor Deposition For Energy Storage Applications, Tandeep Singh Chadha

McKelvey School of Engineering Theses & Dissertations

Renewable energy sources offer a viable solution to the growing energy demand while mitigating concerns for greenhouse gas emissions and climate change. This has led to a tremendous momentum towards solar and wind-based energy harvesting technologies driving efficiencies higher and costs lower. However, the intermittent nature of these energy sources necessitates energy storage technologies, which remain the Achilles heel in meeting the renewable energy goals. This dissertation focusses on two approaches for addressing the needs of energy storage: first, targeting direct solar to fuel conversion via photoelectrochemical water-splitting and second, improving the performance of current rechargeable batteries by developing new …

Computational Fluid Dynamics Modeling And Simulations Of Fluidized Bed Reactors For Chemical Looping Combustion, Subhodeep Banerjee

McKelvey School of Engineering Theses & Dissertations

Chemical looping combustion (CLC) is a next generation combustion technology that shows great promise as a solution for the need of high-efficiency low-cost carbon capture from fossil fueled power plants. To realize this technology on an industrial scale, the development of high-fidelity simulations is a necessary step to develop a thorough understanding of the CLC process. Although there have been a number of experimental studies on CLC in recent years, CFD simulations have been limited in the literature.

In this dissertation, reacting flow simulations of a CLC reactor are developed using the Eulerian approach based on a laboratory-scale experiment of …

Nanoparticle Formation In The Flame Synthesis Of Multicomponent Nanostructured Materials For Clean Energy Applications, Jiaxi Fang

McKelvey School of Engineering Theses & Dissertations

This dissertation studies the initial stages of particle formation during the combustion synthesis of multicomponent nanomaterials. Combustion is commonly used for the production of nanomaterials at industrial scales and has advantages of high production rates, low waste generation, and scalability. However, there are limitations in being able to apply this synthesis approach to more advanced multicomponent systems. Gas to particle conversion in flames occurs through precursor decomposition, collisional growth, coagulation, condensation, and sintering. There is a fundamental gap in knowledge on the initial stages of particle formation in flames below 2nm due to measurement difficulties and instrumentation limitations. Using a …

Crumpled Graphene Oxide: Aerosol Synthesis And Environmental Applications, Yi Jiang

McKelvey School of Engineering Theses & Dissertations

Environmental technologies, such as for water treatment, have advanced significantly due to the rapid expansion and application of nanoscale material science and engineering. In particular, two-dimensional graphene oxide (GO), has demonstrated considerable potential for advancing and even revolutionizing some of these technologies, such as engineered photocatalysts and membranes. To realize such potential, an industrially scalable process is needed to produce monomeric and aggregation-resistant GO nanostructures/composites, in addition to new knowledge of material properties, behavior, and performance within an environmental context.

Research presented in this thesis addresses both scientific and engineering gaps through the development of a simple, yet robust aerosol-based …

Modeling, Simulation, And Analysis Of Lithium-Ion Batteries For Grid-Scale Applications, Matthew Thomas Lawder

McKelvey School of Engineering Theses & Dissertations

Lithium-ion batteries have become universally present in daily life, being used across a wide range of portable consumer electronics. These batteries are advantageous compared to other forms of energy storage due to their high energy density and long cycle life. These characteristics make lithium-ion batteries advantageous for many new and developing applications that require large scale energy storage such as electric vehicles and the utility grid. Typical uses for lithium-ion batteries require consistent cycling patterns that are predictable and easy to approximate across all uses, but new large scale applications will have much more dynamic demands. The cycling patterns for …

Hydrodynamics And Mass Transfer In Bubble Columns, Onkar N. Manjrekar

McKelvey School of Engineering Theses & Dissertations

Bubble columns and slurry bubble columns are multiphase reactors used for a wide range of applications in the biochemical, chemical, petrochemical, and metallurgical industries. In spite of their widespread usage, the scale-up of bubble columns remains an ongoing challenge. Various scale-up approaches, based on concepts ranging from ideal mixing to complex 3-D multiphase CFD models, have been used for assessing the effect of column size and gas and liquid flow rates on column hydrodynamics and reactor performance. Among these approaches, phenomenological models based on either single-class or multi-class bubbles that were validated on cold flow systems have been successful in …

Development Of Steady-State And Dynamic Flux Models For Broad-Scope Microbial Metabolism Analysis, Lian He

McKelvey School of Engineering Theses & Dissertations

Flux analysis techniques, including flux balance analysis (FBA) and 13C-metabolic flux analysis (MFA), can characterize carbon and energy flows through a cells metabolic network. By employing both 13C-labeling experiments and nonlinear programming, 13C-MFA provides a rigorous way of examining cell flux distributions in the central metabolism. FBA, on the other hand, gives a holistic review of optimal fluxomes on the genome scale. In this dissertation, flux analysis techniques were constructed to investigate the microbial metabolisms.

First, an open-source and programming-free platform of 13C-MFA (WUFlux) with a user-friendly interface in MATLAB was developed, which allowed both mass isotopomer distribution (MID) analysis …

Optical Probes In Multiphase Reactors, Boung Wook Lee

McKelvey School of Engineering Theses & Dissertations

This dissertation examines the application of optical probe techniques in two predominant multiphase reactors used for contacting gas and liquid phases: bubble column reactors and gas-liquid stirred tank reactors. Multiphase reactors are ubiquitous in industry, and for most processes, successful operation depends on successful inter- and intra-phase contacting and mixing. Extensive modeling and experimental research efforts have been made for better reactor design, modeling, and scale-up, yet, much remains unknown about the gas phase.

Optical probes offer significant advantages for gas phase dynamics measurements. Consequently, they have been adapted by numerous researchers around the world for detailed fluid dynamic investigations …