Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 5 of 5
Full-Text Articles in Engineering
4wd Baja Upright And Wheel Hub, Nathan Thompson, Jonathan P. Larson, Spencer D. Compan
4wd Baja Upright And Wheel Hub, Nathan Thompson, Jonathan P. Larson, Spencer D. Compan
Williams Honors College, Honors Research Projects
The University of Akron Zips Baja Team has switched to a 4-wheel-drive (4WD) vehicle as per the 2023 Baja Society of Automotive Engineers (SAE) rules. The 2022 Baja Vehicle was 2WD, thus the upright and wheel hub were designed exclusively for a 2-wheel-drive (2WD) Baja vehicle. This report entails the design process and methods of verification for the design of the 4WD upright and wheel hub.
Design Of Force Indicator For Ballistic Armor Trauma Pad, William Keenan, Anthony Cinalli, Patrick Kennedy
Design Of Force Indicator For Ballistic Armor Trauma Pad, William Keenan, Anthony Cinalli, Patrick Kennedy
Williams Honors College, Honors Research Projects
The purpose of the Force Indicator for Ballistic Armor Vests is to obtain an approximate value for the impact a bullet delivers through a trauma pad after the Kevlar layer stops the initial bullet. This approximation will be applied in the field to assist in medical treatment of gunshot wounds. The indicator is made from a pressure-sensitive film located behind the Kevlar layer and trauma pad, and it can be easily removed in the field for examination. The impact vest and force indicator are self-contained for ease of implementation. The device will be tested with 9mm, .22 Long Rifle, and …
The Passing Board, John Fitzgerald
The Passing Board, John Fitzgerald
Williams Honors College, Honors Research Projects
For my Honors Research Project I am taking a more personal route and looking to solve a childhood question/issue by designing a board that is small and easy to transport while also giving the best bounce pass possible. My proposed project would be a board that a soccer player can play a bounce pass onto and receive the ball from. The base of this design sounds simple enough, however, I would like to implement a way that the board can be adjusted to alter the angle of return of the soccer ball after the bounce. I also want to design …
Fluid Power Vehicle Challenge, Bryce Towne, Ethan Andrews, Carter Moore, Andrew Sobel
Fluid Power Vehicle Challenge, Bryce Towne, Ethan Andrews, Carter Moore, Andrew Sobel
Williams Honors College, Honors Research Projects
The Fluid Power Vehicle Challenge is a competition held by the National Fluid Power Association (NFPA) that challenges students to create a hydraulically powered vehicle to compete in four different races over two days. The vehicle has to be fully powered by hydraulics, with human power (such as pedaling) being used to move the hydraulic fluid. Electronics and pneumatics can be used to control the flow of the hydraulic oil. Vehicles also must have an energy storage device to take advantage of regenerative braking. The final competition was at the Norgren facility in Colorado from April 12th to April 14th. …
Distillery, Clare Nicholas, Patrick Hanlon
Distillery, Clare Nicholas, Patrick Hanlon
Williams Honors College, Honors Research Projects
The goal for this project is to make a cost effective still. We will be implementing cost saving parts to create a cheap but effective still. From initial research conducted, we will try to combine a stainless steel still and copper still together so that the cheaper material (stainless steel) and the component that removes sulfur compounds (copper) are both implemented. The ME side of the project will focus on the actual design and construction of the parts that will be implemented into the still. Included in the design process will be calculations of heat transfer for the current and …