Engineering Commons^™

Interlaminar Tensile Properties Of Unidirectional And Woven Carbon Fiber Reinforced Toughened Epoxy Laminates, Eric Timothy Casey, Sean Mckalip Thompson

Materials Engineering

This project aims to develop a dataset on interlaminar tensile strength comparing unidirectional and woven thermoset matrix carbon fiber composites keeping ply count, matrix material, and fiber diameter constant. The interlaminar tensile strength is an important property relating to the delamination failure mode. Interlaminar tensile strength is determined using the ASTM D6415 testing standard. This test is a modified four-point bend test using a 90° curved beam test specimen. Laminates were produced by laying up pre-impregnated carbon fiber sheets onto a curved beam tooling. The unidirectional laminate was produced with 20 plies in a [0,0,90,0,0]₄ layup pattern. The woven …

Invariant-Based Method For Improving Efficiency Of Mechanical Testing In Aerospace Certification Of Carbon Fiber-Epoxy Composites, Alyssa Rina Gruezo, Erika Gabrielle Hansen

Materials Engineering

The current challenge with qualification of carbon fiber composites in the aerospace industry would be the low efficiency of testing hundreds of samples. The Trace Theory strives to streamline the qualification process by utilizing a material’s Trace to predict properties of composites using Excel programs and basis data. To test this theory, predicted properties from the program, QuickLam, were compared to experimental data. Unidirectional 0° (T1), unidirectional 90° (T2), quasi-isotropic (T3), and hard quasi-isotropic (T4) laminates were made using HexTowR carbon fiber and TC250 resin provided by TenCate Advanced Composites. Tensile and compression tests were done according to ASTM D3039 …

Finite Element Modeling Of Delamination Damage In Carbon Fiber Laminates Subject To Low-Velocity Impact And Comparison With Experimental Impact Tests Using Nondestructive Vibrothermography Evaluation, George Rodriguez Iv

Master's Theses

Carbon fiber reinforced composites are utilized in many design applications where high strength, low weight, and/or high stiffness are required. While composite materials can provide high strength and stiffness-to-weight ratios, they are also more complicated to analyze due to their inhomogeneous nature. One important failure mode of composite structures is delamination. This failure mode is common when composite laminates are subject to impact loading.

Various finite element methods for analyzing delamination exist. In this research, a modeling strategy based on contact tiebreak definitions in LS-DYNA^®was used. A finite element model of a low-velocity impact event was created to …

Simplifying The Testing And Calculation Of Fracture Toughness Of Thermoplastic And Thermoset Matrix Composite Materials, James Shedden

Materials Engineering

Fracture toughness, or the ability of a material to resist fast fracture by crack propagation is an important property in the use of composite materials for structural designs. Other mechanical tests such as tensile, flexure, and compression are more established and practical than testing fracture toughness. Fracture toughness testing is less commonly used because it requires specific specimens and non-conventional test methods. In composite materials specifically, delamination of the plies of materials is tested for G_IC and G_IIC values to find the critical strain energy release rate of the two types of fracture modes. The common two tests …

An Investigation Of Initially Delaminated Composite Sandwich With Delamination Arrest Mechanism Under Buckling Loading, Tony D. Tran

Master's Theses

This thesis involves the development of a fiberglass-foam composite sandwich structure with the introduction of delamination arrestment keys; therefore, a study of an initially delaminated composite sandwich structure was the experimental analysis on multiple configurations in how the arrestment keys are placed.

The first part of this thesis research was to the experimental design and manufacturing of the composite sandwich plates. These plates were later cut down to the specific test dimensions and manufacturing processes for the composite sandwich plates and test specimens were created. The composite sandwich plates were manufactured using a vacuum resin infusion process. The dimensions of …