Engineering Commons^™

Photovoltaic Cooking In The Developing World, Tyler Watkins, Christopher O'Day, Omar Arriaga

Mechanical Engineering

The challenge of clean cooking is faced by hundreds of millions of people worldwide. We present a cooking technology consisting of a solar panel directly connected to an electric heater in a well-insulated chamber. Assuming continued decrease in solar panel prices, we anticipate that in a few decades Solar Electric Cooking technologies will be the most common cooking technology for the poor. Appropriate use of insulation reduces the power demand making low-power Insulated Solar Electric Cooking systems already cost competitive.

Crop Selection, Cost Analysis, And Irrigation System Design For The Replanting Of A Nut Orchard, Maximilian Bricker

BioResource and Agricultural Engineering

This report was made to help the landowner of Bricker Farms make decisions regarding the replanting of his orchard. The decisions that need to be made in this process include: which crop to plant, how to plant it, and how to improve the distribution uniformity of irrigation water on the orchard. The report does not give definitive final decisions, but presents viable options that the landowner can utilize when deciding. In addition to the options that are presented, the report offers suggestions to the landowner so that the replanting process is done properly in a timely and economically-friendly manner.

Reducing Food And Packaging Waste Through Developing Edible Fruit Based Packaging Prototypes, Melanie Thatcher

Materials Engineering

Packaging is used to contain, preserve, protect, and advertise both manufactured and natural products. In 2013 it was reported that over thirty percent of solid waste in the United States was from packaging. One way to reduce the impact of packaging on the environment is to create a solution that is edible and sourced from a waste or secondary food product that is not currently being utilized. Food-contact packaging made from recycled materials must meet strict U.S. Food and Drug Administration (FDA) regulations to be utilized as raw material for packaging. Fruit pomace is a candidate material since it may …

Prosthetic Socket Cooling System, Benjamin K. Kraw, Kathy Ha, Derek Piastrelli, Cuong Lai

Mechanical Engineering

A team of four senior-level undergraduate students in the Interdisciplinary Senior Project Design course in the Engineering Department of California Polytechnic State University: San Luis Obispo have worked to develop a prosthetic socket cooling system, namely for veteran Taylor Morris and exclusively for a transfemoral prosthetic socket, under the Quality of Life+ Laboratory. This cooling system will utilize the thermoelectric effect known as the Peltier effect to transmit heat generated from the residual limb to the surrounding environment by means of forced convection over small aluminum heat sinks. Two measurement devices have also been developed to, one, measure the heat …

Physical Testing Of Potential Football Helmet Design Enhancements, Michael Jeremy Schuster

Master's Theses

Football is a much loved sport in the United States. Unfortunately, it is also hard on the players and puts them at very high risk of concussion. To combat this an inventor in Santa Barbara brought a new design to Cal Poly to be tested.

The design was tested in small scale first in order to make some preliminary conclusions about the design. In order to fully test the helmet design; however, full scale testing was required. In order to carry out this testing a drop tower was built based on National Operating Committee on Standards for Athletic Equipment, NOCSAE, …