Engineering Commons^™

The Influence Of Work Of Fracture On Six Orthodontic Bonding Systems, Tyler S. Pritchard

Loma Linda University Electronic Theses, Dissertations & Projects

Introduction: Bonding is the primary method of attaching brackets to teeth in modem orthodontics. Thus, many studies have focused on the maximum shear bond strength values of orthodontic adhesives. In contrast, very little research has been performed considering the work of fracture of orthodontic bonding systems. Work of Fracture is defined as the area under the curve of a stress-strain graph. Previous shear bond strength studies measured the force necessary to produce bond failure. The purpose of this study was to measure the maximum shear force and displacement of six bonding systems and to calculate the work of fracture.

Materials …

Cephalometric Analysis Using Magnetic Resonance Imaging, Wade A. Williams

Loma Linda University Electronic Theses, Dissertations & Projects

Purpose: The purpose of this study was to determine if T1-weighted 3D magnetic resonance images performed at 3.0 Tesla could be used to conduct routine orthodontic cephalometric analysis.

Methods: Three cranial imaging methods were compared using sixteen non-growing subjects (10 male and 6 female) who were not claustrophobic, did not have any metallic restorations on the distal of first molars, had no medical implants and the female subjects were not pregnant. Sagittal cranial images were produced by three methods: (1) a digital lateral cephalometric (LC) radiograph (Orthophos XG Plus, Sirona^TM, Bensheim, Germany), (2) a 12-inch FOV cone beam …

Ricketts And Steiner Analysis Using Newtom 3g™ Scout Images, James I. Gibson Iii

Loma Linda University Electronic Theses, Dissertations & Projects

NewTom 3G™ scout images have the general appearance of traditional lateral cephalometric radiographs. The purpose of this research was to determine if Ricketts and Steiner analyses could be accomplished on NewTom 3G™ scout images.

This was a retrospective study comparing the use of NewTom 3G™ scans in DICOM (Digital Imaging and Communications in Medicine) format to scout images from 25 consecutive patients of the Loma Linda University School of Dentistry Department of Orthodontics, three of these patients did not meet the inclusion criteria. The DICOM images were used to create controls. The controls and scout images were digitized using QuickCeph™. …

Dynamic Determinants Of Incisal Display, Shawn Paul Pesh

Loma Linda University Electronic Theses, Dissertations & Projects

The principal objective of this study was to use computer aided design (CAD) to better illustrate and quantify the relationship of mandibular arch depth, mandibular arch width, overbite, and overjet in the presence of mandibular dental crowding. To date, there has been no research examining how changes in the mandibular arch limit the orthodontist's ability to control overbite and overjet. Understanding how to effectively manage overbite and overjet are crucial to the clinician's ability to manipulate incisal display. Polyvinyl siloxane impressions of both maxillary and mandibular arches of a Caucasian patient were taken and used to pour dental stone models. …

Laser And Led Effects On The Proliferation Rate Of Periodontal Ligament Fibroblasts, Allen J. Job

Loma Linda University Electronic Theses, Dissertations & Projects

PURPOSE: To compare the effectiveness of a Gallium Aluminum Arsenide (GaAlAs) diode laser and a light emitting diode (LED) on periodontal ligament fibroblast cell proliferative rates.

METHODS and MATERIALS: PDLF obtained from freshly extracted permanent teeth were cultured under standard conditions until a subconfluent monolayer was present. The next section took 5 days to complete. On day 1, the initial cell concentration of 700 uL/cm² was plated on 96-well assay plates and placed in a CO₂ incubator at 37° C for 24 hours. On day 2, cell counts were first verified using hemocytometry then were irradiated using an …

New In Vivo And In Vitro Techniques For Quantification Of Lateral Force Levels That Cause Implants To Fail : A Progress Report On Monkey Research, V. Leroy Leggitt

Loma Linda University Electronic Theses, Dissertations & Projects

Two new techniques for quantification of forces generated by an expansion screw apparatus placed between pairs of cylindrical endosseous titanium implants are described, along with preliminary data gained from their use in Macaca rhesus monkeys. Strain gages were bonded to the expansion apparatus and were calibrated either directly by micro load cell, or indirectly by Instron Machine to reflect the applied force.

Immediate loads of up to 6 kilograms have been applied to the implants with no increase in mobility as verified by a Periotest device. No previous studies on the orthodontic uses of implants have evaluated in vivo forces …

A Comparative Analysis Of Intrusion Of Incisor Teeth Achieved In Adults And Children According To Facial Type, Ronald L. Otto

Loma Linda University Electronic Theses, Dissertations & Projects

A comparison of incisor intrusion achieved in deep bite adults and children was made. Facial type was also examined for affect upon intrusion achieved. Fifty-five cases treated with Bioprogressive mechanics were studied cephalometrically, including twenty-four adults and thirty-one children. Neither age nor facial type was found to be statistically related to the amount of incisor intrusion achieved in this sample. A method of measuring intrusion at the root apices was devised which was felt to give a more accurate indication of actual bodily intrusion. More external root changes during treatment were observed for adults than for growing children. Wide latitude …

Determination Of Lead Content In Apical Tissue Following Root Canal Obturation With Sargenti's Formula, G. Merle Hickok

Loma Linda University Electronic Theses, Dissertations & Projects

Four Stump-tail monkeys were used to help determine if the lead in Sargenti's formula diffuses out into the apical tissue while confined entirely within the root canal. In each animal two teeth were filled with Sargenti's formula 1-2 millimeters short of the radiographic apex, and two teeth were filled with gutta percha and Proco-Sol sealer for controls, making a total sample size of sixteen. The time ranged from 48 hours to 120 days. Lead analysis using the spectrophotometric method showed a higher lead content in the teeth filled with Sargenti's formula than with the gutta percha controls.

A Method Of Analyzing Mandibular Movement, Richard B. Mccoy

Loma Linda University Electronic Theses, Dissertations & Projects

Mandibular movement is considered to be a fundamental factor in the study, analysis, and treatment of occlusion. For many years, dentists have realized that dental health depends upon the compatibility of mandibular movements and occlusion. This realization has led to the development of new methods and techniques for recording accurately and scientifically the movements of the mandible. In order for this data to be of scientific value, it must be stored in a usable form which is easily available for analysis.

The purpose of this research project was to develop a procedure for storing and recalling mandibular-movement information. Before such …

A Procedure For The Measurement Of Glosso-Maxillary Forces, Howard L. Lilly Jr.

Loma Linda University Electronic Theses, Dissertations & Projects

The purpose of this investigation was to develop a clinically feasible procedure for recording the magnitudes of glosso-maxillary forces at four palatal loci using an electronic transducer system described by Lear et, al. (1965). Of particular interest was the development of a convenient and accurate calibration device for both intraoral and extraoral application. A further object of interest was the effect an acrylic carrier plate might introduce to the magnitude of force response. Finally whether or not any significant adaptation to the carrier plate or to the transducers occurs during a reasonable testing period (six to seven hours).

A calibration …