Open Access. Powered by Scholars. Published by Universities.®
- Keyword
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Development And Testing Of A Low-Cost Condensation Detection System, Michael D. Montross, George A. Duncan, Richard S. Gates
Development And Testing Of A Low-Cost Condensation Detection System, Michael D. Montross, George A. Duncan, Richard S. Gates
Biosystems and Agricultural Engineering Faculty Publications
A condensation sensing and control system was designed to detect condensation using a commercially available leaf wetness sensor (LWS). The leaf wetness sensor was a variable resistance grid-type that responded to moisture on the surface. A circuit was developed to compare the LWS voltage output to a user specified reference voltage, and operate a relay for possible switching of a humidity control device (for example a fan and/or heater). The condensation detection system operation was validated in an environmental chamber in the laboratory using a heat exchanger and water bath. Condensate was immediately detected when the plate was cooled below …
Changing Maine, 1960-2010: Teaching Guide, Richard Barringer, New England Environmental Finance Center
Changing Maine, 1960-2010: Teaching Guide, Richard Barringer, New England Environmental Finance Center
Maine History & Policy Development
Unlike forty years ago, none of us is now certain what the future holds for Maine – except that it will be different. Maine has been transformed by the events of the recent decades. We have come into a new world, a new time – a new historical era, if you will. This new era, like previous eras in Maine history, will require of us new ways of thinking, new ways of understanding, new ways of organizing ourselves as a community of people, if the values and culture we share and cherish are to endure and flourish.
Vertical Loads Due To Wheat On Obstructions Located On The Floor Of A Model Bin, Marek Molenda, Michael D. Montross, Sidney A. Thompson, Jozef Horabik
Vertical Loads Due To Wheat On Obstructions Located On The Floor Of A Model Bin, Marek Molenda, Michael D. Montross, Sidney A. Thompson, Jozef Horabik
Biosystems and Agricultural Engineering Faculty Publications
Tests were conducted in a model grain bin to evaluate the vertical loads acting on differently shaped obstructions embedded in wheat during filling, detention, and discharge. The bin had corrugated galvanized steel walls with a 1.83 m diameter and a flat bottom. All tests were conducted in a bin that was centrically loaded and unloaded. Three differently shaped obstructions (disc, cone, and cylinder) were tested; each had a circular base equivalent to 6% of the bin floor area. The obstructions were supported in the bin using a three-legged support structure. Each leg of the support structure rested on a load …