Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 3 of 3
Full-Text Articles in Engineering
The Effect Of Parameters In Cryogenic Treatment On Mechanical Properties Of Tool Steel: A Review, Ronaldus Caesariano Ekaputra, Myrna Ariati Mochtar
The Effect Of Parameters In Cryogenic Treatment On Mechanical Properties Of Tool Steel: A Review, Ronaldus Caesariano Ekaputra, Myrna Ariati Mochtar
Journal of Materials Exploration and Findings (JMEF)
Tool steel is classified as special alloy steel which proposed as dies or mold materials as their high mechanical properties and dimensional stability. In order to improve tool steel’s mechanical properties, heat treatment process, especially, cryogenic treatment is conducted. Cryogenic treatment is done by exposing tool steel material at sub-zero liquid/gas media after heated at austenite temperature. This process significantly affects the martensite phase transformation increase and avoids retained austenite emersion. In particular, the higher martensite volume fraction, the higher hardness and wear resistance value of tool steel. It had been proven that adjusting critical process parameters of cryogenic treatment …
The Effect Of Sample Placement In The Furnace During The Heat Treatment Process Of 7075-T6 Aluminum Alloy On Microstructure, Hardness, And Electrical Conductivity, Donanta Dhaneswara, Hardi Rindharto, Muhammad Syauqi Aqilafif
The Effect Of Sample Placement In The Furnace During The Heat Treatment Process Of 7075-T6 Aluminum Alloy On Microstructure, Hardness, And Electrical Conductivity, Donanta Dhaneswara, Hardi Rindharto, Muhammad Syauqi Aqilafif
Journal of Materials Exploration and Findings (JMEF)
This paper reports the effects of sample placement during the heat treatment on the microstructural morphology and mechanical properties of 7075 Al alloy such as hardness value and electrical conductivity. The material was in the formed of Al alloy sheets where samples were machined into a square with dimensions of 1.5 x 1.5 inch. The 7075-T0 Al alloy as samples were given heat treatment by precipitation hardening (aging) at temperature 120°C for 24 hours, so it becomes 7075-T6 Al alloy. Samples were subjected to some mechanical tests and the morphology of the resulting microstructures were characterized by optical microscopy. The …
Microstructures And Hardness Of Tig Welded Experimental 57fe15cr25ni Steel, Parikin Parikin, Mohammad Dani, Abu Khalid Rivai, Agus Hadi Ismoyo, Riza Iskandar, Arbi Dimyati
Microstructures And Hardness Of Tig Welded Experimental 57fe15cr25ni Steel, Parikin Parikin, Mohammad Dani, Abu Khalid Rivai, Agus Hadi Ismoyo, Riza Iskandar, Arbi Dimyati
Makara Journal of Technology
The microstructures and hardness of tungsten inert gas (TIG) welded experimental 57Fe15Cr25Ni steel were investigated through optical–scanning electron microscopy analyses and with a hardness tester, respectively. The welding process restructured the constituent atoms into regular and irregular crystal lattices. Rapid cooling of the weld metal allowed the formation of a dendritic (columnar) structure, with porous grains. By contrast, slow cooling influenced HAZ and led to the formation of grain structures. The crystal lattice became more organized and larger than other zones. Meanwhile, the base metal formed circular nets that covered large area inside thick and thin grain boundaries. The diffraction …