Engineering Commons^™

Probability Of A Hazardous Material Truck Accident In New Jersey, Mahesh Damodaran

Theses

Accident prediction modeling is a powerful tool for determining the frequency of accidents under certain circumstances. Nationwide, direct damages from highway hazardous material spills for the year 2000 were tallied at over $31billion. This thesis determines the probability of an accident involving hazardous materials on the roads of New Jersey. The methodology is based on a British predictive equation used by their Highways Agency to determine the probability of a hazardous spill over a section of a roadway. The parameters used by the British's Highways Agency, which is obtained from their accident data, were modified to reflect conditions that best …

Impact Of Truck Regulation And 65mph Speed Limit On Truck Accidents In New Jersey, Rajat G. Rajbhandari

Theses

The state of New Jersey enacted two regulations with significant importance to the highway operations: 65 mph speed limit and truck restriction on the National Network. The speed limit of 65mph was used on limited sections of interstate system highways with an objective to reduce energy consumption by vehicles and truck restriction was used on the interstate system and other state highway system to reduce large truck accidents and thereby increase truck safety. In this research, the safety impacts of these two regulations on truck crashes were studied.

The research focused on monthly truck crashes along the highway sections where …

Shear Behavior Of Reinforced Concrete Deep Beams Strengthened With Cfrp Laminates, Jon Erik Moren

Theses

Considerable research has been performed using CFRP plates bonded to normal reinforced concrete beams, the objective being to improve shear and flexural strength. However, very few tests have been performed on reinforced concrete deep beams with CFRP as shear reinforcement. The purpose of this experiment is to investigate the behavior of the deep beam in shear with various arrangements of Sika CarboDur laminates bonded to the sides. The beams were designed to be shear deficient with stirrups omitted, except at the supports and directly under the load. In total eight beams were tested, four with one-point loading and four with …

Mechanical Properties And Stress-Strain Behavior Of High Performance Concrete Under Uniaxial Compression, Pornchai Jiratatprasot

Theses

Many recent innovations in advanced concrete materials technology have made it possible to produce concrete with exceptional performance characteristics. High performance concrete (HPQ is defined as concrete that meets special performance and uniformity requirements that cannot always be achieved routinely by using conventional materials and normal mixing, placing, and curing practices. The importance of HPC to structural engineering is unquestionable. However, HPC is a relatively new material. Some results of research on conventional concrete are not entirely applicable. In this experiment, the main mechanical properties of HPC including compressive strength, modulus of elasticity, and Poisson's ratio were investigated and compared …