Engineering Commons^™

An Experimental Study Of Flow Control Techniques On A Multi-Element Airfoil, Ira James Walker

Mechanical & Aerospace Engineering Theses & Dissertations

The results of a wind tunnel experiment are reported, which investigated two different flow control techniques that demonstrated the potential of increasing the lift coefficient on a multi-element airfoil. The data also indicated that boundary-layer separation on the trailing-edge flap could be reduced significantly. Results of the investigation revealed that for some test conditions an increased amount of suction occurred on the upper surface of the main element where the flow was attached. One of the techniques that was tested in this investigation involved the use of a pair of piezoelectric devices attached to the model to provide oscillatory motion …

Large Amplitude Pitching Of Supermaneuver Delta Wings Including Flow Control, Yahia A. Abdelhamid

Mechanical & Aerospace Engineering Theses & Dissertations

The unsteady, three-dimensional Navier-Stokes equations are solved to simulate and study the aerodynamic response of a delta wing undergoing large amplitude pitching motion up to 90° angle of attack. The primary model under consideration consists of a 76° swept, sharp-edged delta wing of zero thickness, initially at zero angle of attack. The freestream Mach number and Reynolds number are 0.3 and 0.45 × 106, respectively. The governing equations are solved time-accurately using the implicit, upwind, Roe flux-difference splitting, finite-volume scheme. Both laminar and turbulent flow solutions are investigated. In the laminar flow solutions, validation of the computational results is carried …

Simulation Of Active Control Of Asymmetric Flows Around Slender Pointed Forebodies, Hazem Sharaf El-Din

Mechanical & Aerospace Engineering Theses & Dissertations

At high angles of attack, the flowfield over slender forebodies becomes asymmetric with substantial side force, which may exceed the available control capability. The unsteady compressible Navier-Stokes equations are used to investigate the effectiveness of different active control methods to alleviate and possibly eliminate the flow asymmetry and the subsequent side force. Although the research work focuses on active control methods, a passive control method has been investigated. The implicit, Roe flux-difference splitting, finite volume scheme is used for the numerical computations. Both locally-conical and three-dimensional solutions of the Navier-Stokes equations are obtained.

The asymmetric flow over five-degree semi-apex angle …

Numerical Study Of Three-Dimensional Separation And Flow Control At A Wing/Body Junction, Balakrishnan Lakshmanan

Mechanical & Aerospace Engineering Theses & Dissertations

The problem of three-dimensional separation and flow control at a wing/body junction has been investigated numerically using a three-dimensional Navier-Stokes code. The numerical code employs an algebraic grid generation technique for generating the grid for unmodified junction and an elliptic grid generation technique for filleted fin junction. The results for laminar flow past a blunt fin/flat plate junction demonstrate that after grid refinement, the computations agree with experiment and reveal a strong dependency of the number of vortices at the junction on Mach number and Reynolds number. The numerical results for pressure distribution, particle paths and limiting streamlines for turbulent …