Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Kevin Huang

2015

Cathode substrate

Articles 1 - 3 of 3

Full-Text Articles in Engineering

Gas-Diffusion Process In A Tubular Cathode Substrate Of A Sofc, Part Ii: Identification Of Gas-Diffusion Process Using Ac Impedance Method, Kevin Huang Feb 2015

Gas-Diffusion Process In A Tubular Cathode Substrate Of A Sofc, Part Ii: Identification Of Gas-Diffusion Process Using Ac Impedance Method, Kevin Huang

Kevin Huang

The effects of cathodic dc bias, bulk pO2, and effective O2 -diffusivity on ac impedance spectra of Siemens Westinghouse Power Corporation’s cathode-supported solid oxide fuel cells were systematically studied over a temperature range of 800 to 1000°C. It was found that the activation process dominated the overall electrode kinetics at 800°C, by which the applied dc bias reduced the electrode resistance considerably. With increasing the temperature to above 900°C, the activation process became effectively activated, leading to a visible arc at the lowest frequency on the impedance spectrum, which is relevant to the pore gas-diffusion process. Under this circumstance, lower …


Gas-Diffusion Process In A Tubular Cathode Substrate Of An Sofc, Part I: Theoretical Analysis Of Gas-Diffusion Process Under Cylindrical Coordinate System, Kevin Huang Feb 2015

Gas-Diffusion Process In A Tubular Cathode Substrate Of An Sofc, Part I: Theoretical Analysis Of Gas-Diffusion Process Under Cylindrical Coordinate System, Kevin Huang

Kevin Huang

In this the first part of a two-part paper, the gas-diffusion process through a thick and porous tubular cathode substrate of a solid oxide fuel cell-(SOFC) was theoretically analyzed using classic Fick’s diffusion equation under the cylindrical coordinate system. The effects of current density, temperature, oxygen diffusivity or porosity, wall thickness, and bulk pO2 on the concentration (or pore in this paper) polarization were calculated and are presented graphically. The results clearly show a greater impact on pore polarization by current density, oxygen diffusivity, wall thickness, and bulk pO2, but not by temperature. In addition, …


Temperature-Dependent Residual Stresses In Plasma Sprayed Electrolyte Thin-Film On The Cathode Substrate Of A Solid Oxide Fuel Cell, Kevin Huang, H. Harter Feb 2015

Temperature-Dependent Residual Stresses In Plasma Sprayed Electrolyte Thin-Film On The Cathode Substrate Of A Solid Oxide Fuel Cell, Kevin Huang, H. Harter

Kevin Huang

No abstract provided.