Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Electronic Thesis and Dissertation Repository

Power and Energy

Load Compensation

Publication Year

Articles 1 - 2 of 2

Full-Text Articles in Engineering

Control System Design, Analysis, And Simulation Of A Photovoltaic Inverter For Unbalanced Load Compensation In A Microgrid, Elizabeth K. Tomaszewski May 2015

Control System Design, Analysis, And Simulation Of A Photovoltaic Inverter For Unbalanced Load Compensation In A Microgrid, Elizabeth K. Tomaszewski

Electronic Thesis and Dissertation Repository

This thesis presents a control scheme for a single-stage three-phase Photovoltaic (PV) converter with negative sequence load current compensation.

In this thesis a dual virtual impedance active damping technique for an LCL filter is proposed to address the issue of LCL filter resonance. Both inverter-side current and the capacitor current are used in the feedback loop. Using both signals provides higher DC rejection than using capacitor current alone. The proposed active damping scheme results in a faster transient response and higher damping ratio than can be obtained using inverter-side current alone. The feedback gains can be calculated to achieve a …


Comprehensive Statcom Control For Distribution And Transmission System Applications, Shubham Gupta Aug 2014

Comprehensive Statcom Control For Distribution And Transmission System Applications, Shubham Gupta

Electronic Thesis and Dissertation Repository

This thesis presents the development of a comprehensive STATCOM controller for load compensation, voltage regulation and voltage balancing in electric power distribution and transmission networks. The behavior of this controller is first validated with published results. Subsequently, the performance of this STATCOM controller is examined in a realistic Hydro One distribution feeder for accomplishing the compensation of both mildly and grossly unbalanced loads, and balancing of network voltages using PSCAD/EMTDC software. The STATCOM voltage control function is utilized for increasing the connectivity of wind plants in the same distribution feeder. The thesis further presents a frequency scanning technique for simple …