Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Assembly Level Clock Glitch Insertion Into An Xmega Mcu, Nigamantha Gopala Chakravarthi
Assembly Level Clock Glitch Insertion Into An Xmega Mcu, Nigamantha Gopala Chakravarthi
ETD Archive
This thesis proposes clock-glitch fault injection technique to inject glitches into the clock signal running in a microcontroller unit and studying its effects on different assembly level instructions. It focusses mainly on the effect of clock glitches over the execution, sub-execution and pre-execution cycles of the test instructions and also finds the delay between the actual position of glitch insertion and the trigger being set for the glitch insertion. The instructions used in this work are provided by Atmel which classifies them according to their type of operation. These instructions are here further grouped depending on the number of clock …
Specification Recommendation For Use Of High Performance Repair Material, Jennifer Woods
Specification Recommendation For Use Of High Performance Repair Material, Jennifer Woods
ETD Archive
The State of Ohio and the Ohio Department of Transportation (ODOT) have sought out ways to extend the life of the repair materials used by their construction crews, specifically, using high performance repair materials for the purposes of patching worn down or cracked sections of highways and bridge decks. Ohio is known for its frequent changes in weather, with freeze-thaw cycles occurring multiple times throughout the year. These cycles affect the lifespan of the repair material and create more maintenance for the DOT. Products that combat this problem were chosen, installed and examined over a year period to determine which …
The Behavior Of Simply Supported Plates Under Extreme Shear Loading, Mhd Ammar Hafez
The Behavior Of Simply Supported Plates Under Extreme Shear Loading, Mhd Ammar Hafez
ETD Archive
Steel plates are planar structural elements with one dimension significantly smaller than the others. These elements may fail due to either material yielding or buckling. Buckling is a sudden failure mode, which is not desirable in structural engineering applications. Buckling is called an “elastic buckling” when it happens before material yielding, and is termed as “plastic buckling” if it happens after material yielding. The focus of this thesis is on shear plates, which are plates that are primarily subjected to shear loads. Several studies were conducted to increase the elastic buckling capacity of plates by adding stiffeners to plates. However, …