Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Engineering
Custom Designed Wall Mounted Shop Crane, Bradley Lewis
Custom Designed Wall Mounted Shop Crane, Bradley Lewis
All Undergraduate Projects
The objective of this project was to design and fabricate a custom wall mounted jib crane to specific, non-standard dimensions. The crane was designed to be industry rated for 2000 pounds, rotate at least 180 degrees, and be designed to have a maximum boom length tailored to the specific installation site. Two potential installation sites and purposes were selected for construction: inside the bay doors of a fabrication shop, intended to transfer large pieces of material to and from a plasma table, and inside a car maintenance garage, intended to lift and remove engines and transmissions from cars.
Design of …
H.F. Hauff Outrigger: Vertical Arm, Juan Tovar
H.F. Hauff Outrigger: Vertical Arm, Juan Tovar
All Undergraduate Projects
H.F. Hauff is a company based out of Yakima which specializes in farming equipment. One of their products is a trailer which has a wind machine attached to it. In order to keep the fan’s thrust from tipping the trailer over, the trailer needs outriggers to extend out. The outriggers also serve as a way to level out the trailer in uneven surfaces. The outriggers are what needed to be designed. This portion of the project was the vertical arm which extends from the horizontal arm, and goes towards the ground to raise the trailer. The project consisted of three …
Orchard Bin Atv Trailer, Neil F. Leitz
Orchard Bin Atv Trailer, Neil F. Leitz
All Undergraduate Projects
A local orchardist was experiencing a problem that was being caused by their lack of apple picking bin moving equipment. The orchardist needed a well-engineered solution to this lack of equipment. The solution arrived at was a five bin trailer. There were multiple design requirements for this trailer, including the device needing to be able to interface with an ATV, be able to be loaded by hand, be able to carry five bins, and not exceed a budget of $750. While perfecting the design of the trailer, a number of different disciplines were utilized, which included dynamics, kinematics, static loading …
Dynamometer Stabilizer, Derek A. Lamarche
Dynamometer Stabilizer, Derek A. Lamarche
All Undergraduate Projects
Overhauling the CWU small engine Dynamometer in the CWU power lab will make it more ridged during the measurement of power in these engines. The goal of the project is to have the dyno used in the Small engines class run by a staff member and to be run by the students. The dynamometer does not work within the specified limits making it impractical to perform during lab