Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Improving The Mechanical Properties Of Single-Walled Carbon Nanotube Sheets By Intercalation Of Polymeric Adhesives, Jonathan N. Coleman, Werner J. Blau, Alan B. Dalton, Edgar Munoz, Steve Collins, Bog G. Kim, Joselito M. Razal, Miles Selvidge, Guillermo Vieiro, Ray Baughman
Improving The Mechanical Properties Of Single-Walled Carbon Nanotube Sheets By Intercalation Of Polymeric Adhesives, Jonathan N. Coleman, Werner J. Blau, Alan B. Dalton, Edgar Munoz, Steve Collins, Bog G. Kim, Joselito M. Razal, Miles Selvidge, Guillermo Vieiro, Ray Baughman
Australian Institute for Innovative Materials - Papers
Organic polymers, such as poly(vinyl alcohol), poly(vinyl pyrrolidone), and poly(styrene), were intercalated into single-walled carbon nanotube sheets by soaking the sheets in polymer solutions. Even for short soak times, significant polymer intercalation into existing free volume was observed. Tensile tests on intercalated sheets showed that the Young's modulus, strength, and toughness increased by factors of 3, 9, and 28, respectively, indicating that the intercalated polymer enhances load transmission between nanotubes.
Delta-Ferrite Recovery Structures In Low-Carbon Steels, Rian Dippenaar, Dominic Phelan
Delta-Ferrite Recovery Structures In Low-Carbon Steels, Rian Dippenaar, Dominic Phelan
Faculty of Engineering and Information Sciences - Papers: Part A
The development of delta-ferrite recovery substructures in low-carbon steels has been observed in-situ utilizing laser scanning confocal microscopy (LSCM). Well-developed sub-boundaries with interfacial energies much smaller than that of delta-ferrite grain boundaries formed following transformation from austenite to delta-ferrite on heating. It is proposed that transformation stresses associated with the austenite to delta-ferrite phase transformation generate dislocations that subsequently recover into sub-boundaries by a process of polygonization. Experimental evidence in support of this proposal was found in a ferritic stainless steel. Thermal cycling through the high-temperature delta-ferrite/austenite/delta-ferrite phase transformation leads to the development of a well-defined recovery substructure, which, in …
Detection Of Carbon Monoxide Within The Magellanic Bridge, E Muller, L Staveley-Smith, William Zealey
Detection Of Carbon Monoxide Within The Magellanic Bridge, E Muller, L Staveley-Smith, William Zealey
Faculty of Engineering and Information Sciences - Papers: Part A
The Mopra 22-m and SEST 15-m telescopes have been used to detect and partially map a region of 12CO(1-0) line emission within the Magellanic Bridge, a region lying between the Large and Small Magellanic Clouds (LMC and SMC, respectively). The emission appears to be embedded in a cloud of neutral hydrogen, and is in the vicinity of an IRAS source. The CO emission region is found to have a 60 μm/100 μm flux density ratio typical for 12CO(1-0) detections within the SMC, although it has a significantly lower 12CO brightness and velocity width. These suggest that the …